Search results for "POWER ELECTRONICS"
showing 10 items of 80 documents
Frequency constrained optimal Power Flow based on Glow-worm Swarm Optimization in Islanded Microgrids
2015
This work presents an application of a swarm optimization method to solve the optimal power flow problem taking into account the constraints of frequency and line ampacity in three-phase islanded Microgrids. Each generation unit is equipped with a Power Electronics Interface. In the considered formulation, the droop control parameters are considered as variables to be adjusted by a higher control level, while the frequency is kept in rated bounds. Another typical constraint for OPF formulation, the max ampacity of each line, is also considered. Two case studies with different dimensions and electrical features have been considered and the obtained results show the efficiency of the proposed…
Voltage Source Multilevel Inverters With Reduced Device Count: Topological Review and Novel Comparative Factors
2021
Multilevel inverters (MLIs) have gained increasing interest for advanced energy-conversion systems due to their features of high-quality produced waveforms, modularity, transformerless operation, voltage, and current scalability, and fault-tolerant operation. However, these merits usually come with the cost of a high number of components. Over the past few years, proposing new MLIs with a lower component count has been one of the most active topics in power electronics. The first aim of this article is to update and summarize the recently developed multilevel topologies with a reduced component count, based on their advantages, disadvantages, construction, and specific applications. Within …
Quasi‐digital front‐ends for current measurement in integrated circuits with giant magnetoresistance technology
2014
In this study, the authors report on two different electronic interfaces for low-power integrated circuits electric current monitoring through current-to-frequency (I-f) conversion schemes. This proposal displays the intrinsic advantages of the quasi-digital systems regarding direct interfacing and self-calibrating capabilities. In addition, as current-sensing devices, they have made use of the giant magnetoresistance (GMR) technology because of its high sensitivity and compatibility with standard complementary metal oxide semiconductor processes. Single elements and Wheatstone bridges based on spin-valves and magnetic tunnel junctions have been considered. In this sense, schematic-level si…
Linear Non Linear Digital control for DC/DC Converters with fast transient response PARTE II
2009
This article presents a digital control that improves the stability of the system, solves the problem of the limit cycle, shortens the recovery time and limits the overcoming of the rectified output voltage. The digital linear-nonlinear control function for DC / DC converters is described. The simulation model in the mixed environment of matlab-simulink / active -hdl is described. Preliminary results of the preliminary hardware test on a step-down-phase converter are presented and simulation and experimental results are also presented.
Linear Non Linear Digital control for DC/DC Converters with fast transient response PARTE I
2009
This article presents a digital control that improves the stability of the system, solves the problem of the limit cycle, shortens the recovery time and limits the overcoming of the rectified output voltage. Describes the linear digital nonlinear control function for DC / DC converters. The simulation model in the mixed environment of matlab-simulink / active -hdl is described. Preliminary results of the preliminary hardware test on a step-down-phase converter are presented and simulation and experimental results are also presented.
Comprehensive Analytical Investigation for PV Plants and Their Control System with Reduced Power Electronics Equipments
2012
This paper presents a comprehensive analysis of a power generation system from PV source and it control system with a reduced power equipments connected with a power AC grid. The absence of the boost chopper as an actuator for Maximum Power Point Tracking concurs to make the system more reliable, affordable and moreover cheaper respect to a traditional one in which the boost chopper is used. The mathematical analysis exposed in the paper shows as a three phase inverter has two degrees of freedom allowing the simultaneous MPPT control and the synchronization with the power grid. The analysis also shows the way to determine the duty cycle of the inverter to deliver active power, and eventuall…
The CZT X-ray imager on AXO
2001
DSRI has initiated a development program of CZT X-ray and gamma ray detectors employing strip readout techniques. A dramatic improvement of the energy response was found operating the detectors as so-called drift detectors. For the electronic readout, modern ASIC chips were investigated. Modular design and the low power electronics will make large area detectors using the drift strip method feasible. The performance of a prototype CZT system will be presented and discussed. One such detector system has been proposed for future space missions: The X-Ray Imager (XRI) on the Atmospheric X-ray Observatory (AXO), which is a mission proposed to the Danish Small Satellite Program and is dedicated …
A review of fuel cell based hybrid power supply architectures and algorithms for household appliances
2014
Abstract Nowadays, renewable power system solutions are widely investigated for residential applications. Grid-connected systems including energy storage elements are designed. Advanced research is actually focused on improving the reliability and energy density of renewable systems reducing the whole utility cost. Source and load modeling, power architectures and algorithms are only a few topics to be addressed. Designers have to carefully deal with each subtopic prior to design efficient renewable energy systems. In the literature, each topic is separately discussed and the lack of a unique reference guide is clear to power electronics designers. In this paper, each design step including …
Performance Comparison of modified modulation Techniques for Quasi-Z-Source Converters
2020
The single-stage converters represent an innovation in the field of power electronics thanks their features. Aim of this work consists in the improvement of the performances of quasi-Z-Source converters by adopting a modified modulation technique, which is based on the Maximum Constant Boost Control (MCBC) and Switching Frequency Optimal (SFO). The results in terms of voltage stress and harmonic content are compared with those obtained with conventional techniques, demonstrating the effectiveness of the proposed modulation scheme.
MATLAB-based simulator of a 5 kW fuel cell for power electronics design
2013
Abstract In the last few years, renewable energies have been encouraged by worldwide governments to meet energy saving policies. Among renewable energy sources, fuel cells have attracted much interest for a wide variety of research areas. Since combined heat-power generation is allowed, household appliances are still the most promising applications. Fuel cell-based residential-scaled power supply systems take advantage by simultaneous generation of power and heat, reducing the overall fossil fuel consumption and utilities cost. Modelling is one of the most important topic concerning fuel cell use. In this paper, a measurement-based steady-state and dynamic fuel cell model is presented. The …