Search results for "Performance."
showing 10 items of 4178 documents
Study of passive sampling of polycyclic aromatic hydrocarbons in gas phase using Amberlite XAD resins as filling materials of semipermeable membranes
2013
Abstract In this work, a study was performed to evaluate the use of Amberlite XAD resins (XAD-2, XAD-4 and XAD-16), for the first time, as filling materials for low-density polyethylene membranes, which will be inserted as passive samplers for polycyclic aromatic hydrocarbons (PAHs) in gas phase. The use of samplers deployed for 48 h evidenced a relative capability to retain the compounds under study. A detailed study was performed to evaluate the recovery of analytes from the sampler through microwave-assisted extraction by using acetonitrile. A clean-up step using alumina-C18 cartridges was necessary before determination of the PAHs by high performance liquid chromatography with fluoresce…
Fast Separation and Determination of Sterols in Vegetable Oils by Ultraperformance Liquid Chromatography with Atmospheric Pressure Chemical Ionizatio…
2010
A method for the determination of sterols in vegetable oils by ultraperformance liquid chromatography (UPLC) with atmospheric pressure chemical ionization mass spectrometry detection has been developed. The separation of sterols was optimized in terms of mobile phase composition, column temperature and flow rate. The optimal conditions were achieved using an Acquity UPLC BEH C18 column (50 x 2.1 mm, 1.7 microm) with a mobile phase consistent of acetonitrile/water (0.01% acetic acid) using a linear gradient, at a flow rate of 0.8 mL min(-1) and column temperature of 10 degrees C, giving a total analysis time below 5 min. The determination was performed in selective ion recording mode. The li…
Comparison of gas and liquid chromatography coupled to mass spectrometry for the residue analysis of pesticides in organges
2001
Liquid chromatography-mass spectrometry (LC-MS) with atmospheric pressure chemical ionization (APCI), and gas chromatography-mass spectrometry (GC-MS) with electron impact ionization (EI), are compared for the determination of eight pesticides in oranges. Seven of the selected pesticides, chlorpyriphos, chlorpyriphos-methyl, imazalil, α and β-endosulfan, endosulfan sulphate and dicofol, are commonly determined by GC whereas one, thiabendazole, can only be directly determined by LC. Primary ions [M-H]− or [M-Cl+O]− are obtained using LC-APCI-MS in negative ionization (NI) mode. In contrast, a high degree of fragmentation is reported with GC-MS. Both techniques were applied to oranges, which …
Determination of fungicide residues in fruits and vegetables by liquid chromatography–atmospheric pressure chemical ionization mass spectrometry
2002
Abstract A liquid chromatography (LC) method for the quantitative determination of five fungicide residues (dichloran, flutriafol, o -phenylphenol, prochloraz and tolclofos methyl) in oranges, lemons, bananas, peppers, chards and onions is described. The residues were extracted by matrix solid-phase dispersion (MSPD) using C 8 . Quantitative analysis was performed by isocratic LC coupled to quadrupole mass spectrometer using atmospheric pressure chemical ionization in the negative ionization mode. The limit of quantification was 0.01 mg kg −1 for flutriafol, o -phenylphenol and dichloran, and 0.1 mg kg −1 for prochloraz and tolclofos methyl. The MSPD method is also suitable for LC–UV analys…
Determination of carbamate residues in fruits and vegetables by matrix solid-phase dispersion and liquid chromatography-mass spectrometry.
2000
Abstract Thirteen carbamates were analysed in orange, grape, onion and tomatoes by matrix solid-phase dispersion (MSPD) followed by liquid chromatography–mass spectrometry (LC–MS). Electrospray (ES) and atmospheric pressure chemical ionisation (APCI) were compared and both gave similar results in terms of sensitivity and structural information because at 20 V fragmentor voltages the fragmentation is minimal. The efficiency of different solid-phases (C18, C8, cyano, amine and phenyl) for the MSPD was compared. Mean recoveries using C8 varied from 64 to 106% with relative standard deviations of 5–15% in the concentration range of 0.01–10 mg kg−1. Matrix constituents did not interfere signific…
Comparative evaluation of liquid chromatography versus gas chromatography using a β-cyclodextrin stationary phase for the determination of BTEX in oc…
2009
An HPLC method for the determination of benzene, toluene, ethylbenzene and o-xylene, m-xylene and p-xylene in occupational environments was developed and compared with a GC-MS method. Chromatographic analysis using a beta-cyclodextrin stationary phase was performed after active and passive air sampling by adsorption on activated charcoal and pressurized fluid extraction. The analytes were completely separated and quantified using both methods, although GC-MS provided better resolutions and lower detection limits than HPLC. The HPLC method was unsuccessfully applied to the determination of benzene in real samples because its sensitivity was too low. Both methods were applied to the analysis …
Fishing for a drug: solid-phase microextraction for the assay of clozapine in human plasma
1999
Solid-phase microextraction (SPME) was investigated as a sample preparation method for assaying the neuroleptic drug clozapine in human plasma. A mixture of human plasma, water, loxapine (as internal standard) and aqueous NaOH was extracted with a 100-micron polydimethylsiloxane (PDMS) fiber (Supelco). Desorption of the fiber was performed in the injection port of a gas chromatograph at 260 degrees C (HP 5890; 30 m x 0.53 mm I.D., 1 micron film capillary; nitrogen-phosphorous selective detection). Fibers were used repeatedly in up to about 75 analyses. The recovery was found to be 3% for clozapine from plasma after 30 min of extraction. However, in spite of the low recovery, the analyte was…
Automated Fourier Transform near Infrared Determination of Buprofezin in Pesticide Formulations
2005
An automated procedure has been developed for Fourier transform near infrared (FT-NIR) determination of buprofezin in pesticide formulations. This methodology is based on on-line pesticide extraction with acetonitrile from solid samples and its determination by using peak area absorbance measurements between 2147 and 2132 nm, corrected with a horizontal baseline established at 2091 nm. The repeatability, as a relative standard deviation of five independent analyses of 18.9 mg g−1 of buprofezin, was 0.06% and the limit of detection 5 mg L−1. The reagent consumption was clearly reduced compared with a chromatographic reference procedure from 40.4 mL acetonitrile per sample, required by high …
Determination of water-soluble UV-filters in sunscreen sprays by liquid chromatography.
2002
Abstract Liquid chromatography was used for the determination of the three most used water-soluble UV filters, benzophenone-4 (BZ4), terephthalylidene dicamphor sulfonic acid (TDS), and phenylbenzimidazole sulphonic acid (PBS), in aqueous sunscreen sprays. A C 18 stationary phase and an isocratic mobile phase of EtOH–20 m M sodium acetate buffer of pH 4.6 (30:70, v/v) were used at a flow-rate of 0.5 ml min −1 . Mobile phase was also used as solvent for samples and standards. UV detection was at 313 nm. The analytical run took 5.5 min. The limits of detection were 0.5, 0.9 and 2 μg ml −1 for BZ4, TDS and PBS, respectively. The proposed method does not involve highly toxic solvents.
Quantification of nortriptyline in plasma by HPLC and fluorescence detection
2009
Abstract A simple, sensitive and specific high-performance liquid chromatography method has been developed for the determination of nortriptyline (NT) in plasma samples. The assay involved derivatization with 9H-fluoren-9-ylmethyl chloroformate (Fmoc-Cl) and isocratic reversed-phase (C 18 ) chromatography with fluorescence detection. The developed method required only 100 μl of plasma sample, deproteinized and derivatized in one step. Calibration curves were lineal over the concentration range of 5–5000 ng/ml. The derivatization reaction was performed at room temperature in 20 min and the obtained NT derivative was stable for at least 48 h at room temperature. The within-day and between-day…