Search results for "Phase Transition"
showing 10 items of 1281 documents
Dielectric behaviour of BaTi1-xZrxO3ceramics obtained by means of a solid state and mechanochemical synthesis
2016
ABSTRACTIn this study the comparison of dielectric behaviour of BaTi1-xZrxO3 (BTZx) ceramic samples prepared by means of a solid state and mechanochemical synthesis was presented. A single phase of perovskite structure was identified in the samples at room temperature. No significant impurities were detected in an EDS spectrum and the samples had a good stoichiometric ratio. The morphology of the investigated samples was characterized by a scanning electron microscopy (SEM). The investigation of dielectric properties of the BTZx samples within the temperature range from 140 K to 600 K was performed by means of a dielectric spectroscopy method at the frequency ranging from 0.1 Hz to 10 MHz. …
Effects of water removal on the structure and spin-crossover in an anilato-based compound
2021
The crucial role played by a crystallization water molecule in the spin crossover (SCO) temperature and its hysteresis is described and discussed in compound [NBu4][Fe(bpp)2][Cr(C6O4Br2)3]⋅2.5H2O (1), where bpp = 2,6-bis(pyrazol-3-yl)pyridine and (C6O4Br2)2− = dianion of the 3,6-dibromo-2,5-dihydroxy-1,4-benzoquinone. The compound has isolated [Fe(bpp)2]2+ cations surrounded by chiral [Cr(C6O4Br2)3]3− anions, NBu4+ cations, and a water molecule H-bonded to one of the non-coordinated N–H groups of one bpp ligand. This complex shows a gradual almost complete two-step spin transition centered at ca. 180 and 100 K with no hysteresis. The loss of the water molecules results in a phase transition…
Correlation between in situ structural and optical characterization of the semiconductor-to-metal phase transition of VO2 thin films on sapphire
2020
A detailed structural investigation of the semiconductor-to-metal transition (SMT) in vanadium dioxide thin films deposited on sapphire substrates by pulsed laser deposition was performed by in situ temperature-dependent X-ray diffraction (XRD) measurements. The structural results are correlated with those of infrared radiometry measurements in the SWIR (2.5-5 μm) and LWIR (8-10.6 μm) spectral ranges. The main results indicate a good agreement between XRD and optical analysis, therefore demonstrating that the structural transition from monoclinic to tetragonal phases is the dominating mechanism for controlling the global properties of the SMT transition. The picture that emerges is a SMT tr…
Phase transitions in Na0.5Bi0.5TiO3-(Sr0.7Bi0.2)TiO3-PbTiO3 solid solutions
2016
ABSTRACTIncreasing of Sr0.7Bi0.2TiO3 concentration in Na0.5Bi0.5TiO3-Sr0.7Bi0.2TiO3 solid solutions causes increasing of Bi/Na relation and vacancies in the A-site of perovskite structure. In temperature dependence of dielectric permittivity, such a change of composition is reflected by transforming of the frequency-dependent shoulder into a maximum characteristic for relaxor ferroelectrics and diminishing of the frequency-independent maximum characteristic for Na0.5Bi0.5TiO3. Here changes in behavior of dielectric permittivity and polarization are studied if PbTiO3 is added in a certain concentration range of Na0.5Bi0.5TiO3-Sr0.7Bi0.2TiO3 solid solutions. Changes of the characteristic temp…
Structural phase transition in [(C2H5)4N][(CH3)4N]ZnCl4
2019
The hybrid crystal [(C2H5)4N][(CH3)4N]ZnCl4 was studied using several experimental methods. DSC studies revealed the first order phase transition to the high temperature phase at about 496 K. This phase transition was confirmed in dielectric studies. Optical observation revealed the domain structure appearance characteristic for that of the phase transition between tetragonal and orthorhombic phases. This phase transition shows a lowering of symmetry as in the case of bromide analogs. Additionally, the optical studies showed the appearance of a number of cracks in the sample and in some cases, the samples became milky after cooling from the high temperature to the room temperature phase.
Structure and dielectric properties at phase transition of Na1/2Bi1/2TiO3-BaTiO3 solid solutions
2016
ABSTRACTPhase coexistence region is studied by x-ray diffraction for Na1/2Bi1/2TiO3-BaTiO3 solid solutions in the tetragonal phase side from the morphotropic phase boundary. The first order ferroelectric phase transition, determined from a jump in the temperature dependence of dielectric permittivity, is located inside the coexistence region of cubic and tetragonal phases and is below the temperature, where tetragonality disappears. At low BaTiO3 concentrations phase transition into ferroelectric state at cooling is slowly approached in time and is smeared over large temperature range. Rietveld method, applied for more precise evaluation of phase content, reveals large local deformations in…
Normal and relaxor ferroelectric behavior in the Ba1−xPbx(Ti1−yZry)O3 solid solutions
2017
Abstract Polycrystalline samples of Ba 1−x Pb x (Ti 1−y Zr y )O 3 (BPTZ) with x = 0.025 & 0.1 and 0.10 ≤ y ≤ 0.50 have been synthesized by high-temperature solid-state reaction technique. X-ray diffraction reveals the formation of single phase with tetragonal or cubic structure. Dielectric investigations were carried out in the temperature range from 80 to 445 K with frequencies range from 10 2 to 10 6 Hz. A broad dielectric anomaly coupled with the shift of dielectric maxima toward a higher temperature with increasing frequency indicates either a diffuse phase transition or relaxor behavior in some of these ceramics. Whatever lead content, when zirconium is substituted by titanium, T C an…
Identifying Early Warning Signals for the Sudden Transition from Mild to Severe Tobacco Etch Disease by Dynamical Network Biomarkers
2019
This article belongs to the Special Issue The Complexity of the Potyviral Interaction Network.
Behavior of plant plasma membranes under hydrostatic pressure as monitored by fluorescent environment-sensitive probes.
2010
International audience; We monitored the behavior of plasma membrane (PM) isolated from tobacco cells (BY-2) under hydrostatic pressures up to 3.5 kbar at 30 °C, by steady-state fluorescence spectroscopy using the newly introduced environment-sensitive probe F2N12S and also Laurdan and di-4-ANEPPDHQ. The consequences of sterol depletion by methyl-β-cyclodextrin were also studied. We found that application of hydrostatic pressure led to a marked decrease of hydration as probed by F2N12S and to an increase of the generalized polarization excitation (GPex) of Laurdan. We observed that the hydration effect of sterol depletion was maximal between 1 and 1.5 kbar but was much less important at hig…
Integrated Fixed Film Activated Sludge (IFAS) membrane BioReactor: The influence of the operational parameters
2020
Abstract The present paper investigated an Integrated Fixed Film Activated Sludge (IFAS) Membrane BioReactor (MBR) system monitored for 340 days. In particular, the short-term effects of some operational parameters variation was evaluated. Results showed a decrease of the removal rates under low C/N values. Respirometry results highlighted that activated sludge was more active in the organic carbon removal. Conversely, biofilm has a key role during nitrification. The major fouling mechanism was represented by the cake deposition (irreversible).