Search results for "Pressure"
showing 10 items of 4493 documents
LABORATORY INSTRUMENTATION TO STUDY CHANGES OF ELECTRICAL CONDUCTIVITY OF ROCKS WITH CHANGES OF FREQUENCY, TEMPERATURE AND PRESSURE*
1983
A laboratory instrument was developed to investigate the electrical properties of rock samples with respect to changes of frequency, temperature and pressure. The instrument can be used to obtain general trends and typical values for geological media. It should be of particular interest in geothermal studies and research in the geophysical properties of rocks. The design intervals for quantities under investigation were 20–300°C, 10 5 -4 × 10 7 Pa and 5 × 10 −4 -10 3 Hz. Certain limitations exist on the simultaneous use of the highest values of temperature and pressure. The main features of the instrument are: analog electrical outputs recorded by an x-y recorder or observed on a scope with…
Pressure dependence of the refractive index in wurtzite and rocksalt indium nitride
2014
We have performed high-pressure Fourier transform infrared reflectance measurements on a freestanding InN thin film to determine the refractive index of wurtzite InN and its high-pressure rocksalt phase as a function of hydrostatic pressure. From a fit to the experimental refractive-index curves including the effect of the high-energy optical gaps, phonons, free carriers, and the direct (fundamental) band-gap in the case of wurtzite InN, we obtain pressure coefficients for the lowfrequency (electronic) dielectric constant e1 . Negative pressure coefficients of -8.8 × 10-2 GPa-1 and -14.8 × 10-2 GPa-1 are obtained for the wurtzite and rocksalt phases, respectively. The results are discussed …
CARS methane spectra: Experiments and simulations for temperature diagnostic purposes
2007
International audience; CARS laboratory experiments were done in the 2905-2925 cm(-1) range, in the vicinity of the v, band of the methane molecule, for pressures ranging from I to 50 bar, and temperatures up to 1100 K. These experiments were carried out in order to retrieve the pressure evolution of the CH4 spectrum, as well as to confirm its temperature dependance. After a brief recall on the theory used to compute pressure broadening coefficients and relaxation rates, we consider the v(3) and v(4) infrared bands of methane for benchmark calculations purposes. Next, we present recent experimental CARS spectra and calculated ones. Lastly, we discuss flame experiments as well as comparisons…
Loose crystals engineered by mismatched halogen bonds in hexachloroethane
2018
Distortions of the directional requirements in halogen⋯halogen contacts between hexachloroethane (HCE), C2Cl6, molecules lead to a loose crystal under ambient conditions. Single-crystal X-ray diffraction shows that the orthorhombic HCE phase of space group Pnma, with the molecules in the staggered conformation, extends at least from 85 to 305 K and from 0.1 MPa to 5.42 GPa. At ambient pressure, all intermolecular distances are longer than the sum of van der Waals radii, reached only at the pressure of ca. 1.2 GPa.
Phosphites as precursors in atomic layer deposition thin film synthesis
2021
We here demonstrate a new route for deposition of phosphorous based materials by atomic layer deposition (ALD) using the phosphites Me3PO3 or Et3PO3 as precursors. These contain phosphorous in the oxidation state (III) and are open for deposition of reduced phases by ALD. We have investigated their applicability for the synthesis of LiPO and AlPO materials and characterized their growth by means of in situ quartz crystal microbalance. Phosphites are good alternatives to the established phosphate-based synthesis routes as they have high vapor pressure and are compatible with water as a coreactant during deposition. The deposited materials have been characterized using XPS, x-ray fluorescence…
CNT and Graphene Growth: Growing, Quality Control, Thermal Expansion and Chiral Dispersion
2017
The chapter presents and discusses the production of graphene sheets of carbon nanotubes (CNT) of various types. The Iijima arc discharge method, following the purification methods, is described identifying advantages and disadvantages. Several types of non-regularities such as the Stone–Wales defect and corner effect, which locally increases reactivity, are described from the structural point of view. The laser ablation method is presented as one of the most prominent methods in the production of CNTs. The catalytic chemical vapour deposition (CVD) method is a very effective tool for the controlled production of different carbon shells. The sporadic and simulated growth of CNTs depends on …
Detection of deuterium retention by LIBS at different background pressures
2017
ITER plans foresee the quantitative diagnostics of fuel retention in reactor walls at near-atmospheric pressures. Using laser induced breakdown spectroscopy (LIBS) for this purpose assumes a reliable resolving of Balmer α-lines of hydrogen isotopes in spectra of plasma produced by focused laser radiation onto the target surface. To develop LIBS for quantitative diagnostics of fuel retention during the maintenance breaks of ITER, the effect of background gas pressure on the laser-induced plasma characteristics has been studied. The background pressure limits the expansion rate of plasma and as a result it leads to higher plasma concentrations. At the same time the limiting factor of the reso…
Efficiency of Stress-Strain Models of Confined Concrete With and Without Steel Jacketing to Reproduce Experimental Results
2016
The improvement and the capacity assessment of existing buildings has become the main topic of the last years so that different studies can be found devoted to damaged structures or structures not having a capacity compatible with the safety levels of the actual codes. Reinforced concrete framed structure buildings represent a conspicuous rate of the existing constructions so many efforts are addressed to them. Referring to this type of buildings, a good prediction of strength and deformation capacity requests models able to interpret the constitutive law of concrete confined by internal reinforcement or by eventual external reinforcement applied to increase capacity of cross-sections. Cons…
Structural analysis of W3O/WO3 and TiO/TiO2 periodic multilayer thin films sputter deposited by the reactive gas pulsing process
2012
International audience; DC reactive sputtering was used to deposit titanium and tungsten-based metal/oxide periodic nanometric multilayers using pure metallic targets and Ar + O-2 gas mixture as reactive atmosphere. The innovative technique namely, the reactive gas pulsing process allows switching between the metal and oxide to prepare a periodic multilayered structure with various metalloid concentrations and nanometric dimensions. The same pulsing period was used for each deposition to produce metal-oxide periodic alternations close to 10 nm. Structure, crystallinity and chemical composition of these films were systematically investigated by Raman spectroscopy, X-ray diffraction and Energ…
Multi-color resonance ionization of laser ablated gadolinium at high laser power
2005
Abstract Spectroscopic and analytical properties of a trace analytical method using multi-step resonance ionization at high laser intensities (>kW/cm 2 ) have been investigated with gadolinium as a test element. Strongly saturated transitions are observed, which have been used for a temperature determination of the atoms in the laser ablated plume. Regimes of multi-step resonance ionization and multiphoton ionization could be distinguished. Analytical performances due to resonance enhancement and resulting discrimination against non-resonant background, precision in isotope ratio determination and overall detection efficiency are discussed.