Search results for "Propylene"

Effect of high power ultrasound on physical–chemical properties of polypropylene films aimed for food packaging: structure and surface features

2019

International audience; Biaxially oriented polypropylene (BOPP) coated with acrylic/polyvinylidene chloride (BOPPAcPVDC) and biaxially oriented coextruded polypropylene (BOPPcoex) films have been treated with high power ultrasound (HPUS) while submerged in water. Polymer structure and the surface morphology changes were noticed, and obtained results were correlated with the physical properties of tested materials. In anticipation of sonochemically enhanced reactions, physical–chemical profile of film samples was determined using thermogravimetric analysis, differential scanning calorimetry, Fourier-transform infrared spectroscopy, UV spectrophotometry and environmental scanning electron mic…

Dielectric properties and partial discharge endurance of polypropylene-silica nanocomposite

2010

This paper presents the results of the dielectric properties and partial discharge endurance measurements conducted on polypropylene (PP)-silica nanocomposite. The material compounds were analyzed with micro-Raman spectroscopy, X-ray tomography and transmission electron microscopy (TEM). ac and dc breakdown strength of the materials was measured. Dielectric response, capacitance and loss factor of the film samples were measured as a function of temperature and frequency. Partial discharge (PD) endurance of the reference PP and PP Silica nanocomposite was studied as a function of ac voltage. Material surfaces were analyzed after PD stress with optical microscopy. All dielectric measurements …

Nonresonant Spectral Hole Burning in the Slow Dielectric Response of Supercooled Liquids

1996

Large-amplitude, low-frequency electric fields can be used to burn spectral holes in the dielectric response of supercooled propylene carbonate and glycerol. This ability to selectively modify the dielectric response establishes that the non-Debye behavior results from a distribution of relaxation times. Refilling of the spectral hole was consistent with a single recovery time that coincided with the peak in the distribution. Moreover, refilling occurred without significant broadening, which indicates negligible direct exchange between the degrees of freedom that responded to the field. Nonresonant spectral hole burning facilitates direct investigation of the intrinsic response of systems t…

Dielectric spectroscopy analysis of EVA-silicate nanocomposite insulating materials

2005

Nanocomposite materials show promising results for applications as electrical insulation. Among several materials presently under investigation, previous works indicate that polypropylene and ethylene-vinilacetate filled by nanosilicates present lower content of space charge and higher electric strength. However, efforts are needed to explain nanocomposite behaviour and characterize their electrical, thermal and mechanical properties. In this paper, the results of broad-band dielectric spectroscopy performed on ethylene-vinylacetate copolymer filled by layered micro and nanosized silicates are reported. The nanofillers consist of montmorillonite and fluorohectorite, that is, natural and syn…

Organic carbonates as alternative solvents for asymmetric hydrogenation

2009

Organic carbonates like propylene carbonate (PC) or butylene carbonate (BC) belong to the class of aprotic, highly dipolar solvents (AHD). Interestingly, their potential as solvents for asymmetric catalysis has been overlooked for a long time. The aim of this work is to evaluate organic carbonates and other organic solvents like THF, CH2Cl2, and acetonitrile as well as members of the AHD-family (DMF, DMSO, etc.) as media for homogeneous asymmetric hydrogenation. For this reason cationic Rh-complexes based on chiral phosphine ligands were tested in the hydrogenation of typical benchmark substrates. In several trials, significant advantages of organic carbonates were found. In contrast to DMS…

Physicochemical stability of human insulin 1 I.U./mL infusion solution in 50 mL polypropylene syringes

2021

Abstract Objectives The objective of this study was to investigate the physicochemical stability of human insulin 1 I.U./mL injection solutions (Insuman® Rapid) diluted with 0.9% NaCl solution in 50 mL disposable three-piece polypropylene syringes and stored refrigerated or at room temperature. Methods 1 I.U./mL test solutions were prepared with Insuman® Rapid and 0.9% sodium chloride infusion solution in 50 mL Original-Perfusor® syringes and BD® Perfusion syringes. Test solutions were stored for 90 days at 2–8 °C/dark or 48 h at 20–25 °C/diffuse room light in order to determine chemical stability. Additional test solutions were stored 28 days at 2–8 °C/dark followed by 24 h at 20–25 °C/dif…

Stability of mycophenolate mofetil in polypropylene 5% dextrose infusion bags and chemical compatibility associated with the use of the Equashield ® …

2019

Stability studies are necessary in healthcare settings as they facilitate fast, cost-effective and efficient work related to batch manufacturing and availability of supplies. We studied the stability of 1-10 mg/mL mycophenolate mofetil (MMF) in polypropylene 5% dextrose infusion bags prepared from Cellcept® and with a generic brand name (Micofenolato de Mofetilo Accord) at different storage temperatures. To ensure chemical compatibility during preparation, we also tested MMF sorption to the Equashield® closed-system drug transfer device used in this step. For this, a validated stability-indicating high-performance liquid chromatography method was developed for the quantification and identif…

Photo-oxidation of nano- and micro-filled polypropylene

2010

Faceted phospholipid vesicles tailored for the delivery of Santolina insularis essential oil to the skin

2015

The aim of this work was to formulate Santolina insularis essential oil-loaded nanocarriers, namely Penetration Enhancer containing Vesicles (PEVs), evaluate the physico-chemical features and stability, and gain insights into their ability to deliver the oil to the skin.S. insularis essential oil was obtained by steam distillation, and was predominantly composed of terpenes, the most abundant being β-phellandrene (22.6%), myrcene (11.4%) and curcumenes (12.1%). Vesicles were prepared using phosphatidylcholine, and ethylene or propylene glycol were added to the water phase (10% (v/v)) to improve vesicle performances as delivery systems. Vesicles were deeply characterized by light scattering,…

Controlled Synthesis of Multi-Arm Star Polyether-Polycarbonate Polyols Based on Propylene Oxide and CO2

2013

Multi-arm star copolymers based on a hyperbranched poly(propylene oxide) polyether-polyol (hbPPO) as a core and poly(propylene carbonate) (PPC) arms are synthesized in two steps from propylene oxide (PO), a small amount of glycidol and CO2 . The PPC arms are prepared via carbon dioxide (CO2 )/PO copolymerization, using hbPPO as a multifunctional macroinitiator and the (R,R)-(salcy)CoOBzF5 catalyst. Star copolymers with 14 and 28 PPC arms, respectively, and controlled molecular weights in the range of 2700-8800 g mol(-1) are prepared (Mw /Mn = 1.23-1.61). Thermal analysis reveals lowered glass transition temperatures in the range of -8 to 10 °C for the PPC star polymers compared with linear …