Search results for "Pyrolytic carbon"
showing 10 items of 15 documents
Effect of graphene substrate type on formation of Bi2Se3 nanoplates
2019
AbstractKnowledge of nucleation and further growth of Bi2Se3 nanoplates on different substrates is crucial for obtaining ultrathin nanostructures and films of this material by physical vapour deposition technique. In this work, Bi2Se3 nanoplates were deposited under the same experimental conditions on different types of graphene substrates (as-transferred and post-annealed chemical vapour deposition grown monolayer graphene, monolayer graphene grown on silicon carbide substrate). Dimensions of the nanoplates deposited on graphene substrates were compared with the dimensions of the nanoplates deposited on mechanically exfoliated mica and highly ordered pyrolytic graphite flakes used as refer…
Tuning the Magnetic Properties of Carbon by Nitrogen Doping of Its Graphene Domains
2015
Here we present the formation of predominantly sp-coordinate carbon with magnetic- and heteroatom-induced structural defects in a graphene lattice by a stoichiometric dehalogenation of perchlorinated (hetero)aromatic precursors [hexachlorobenzene, CCl (HCB), and pentachloropyridine, NCCl (PCP)] with transition metals such as copper in a combustion synthesis. This route allows the build-up of a carbon lattice by a chemistry free of hydrogen and oxygen compared to other pyrolytic approaches and yields either nitrogen-doped or -undoped graphene domains depending on the precursor. The resulting carbon was characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM…
Auto-assembly of nanometer thick, water soluble layers of plasmid DNA complexed with diamines and basic amino acids on graphite: Greatest DNA protect…
2017
Abstract We have investigated the ability of diamines as well as basic amino acids to condense DNA onto highly ordered pyrolytic graphite with minimum damage after re-dissolution in water. Based on a bibliographic survey we briefly summarize DNA binding properties with diamines as compared to basic amino acids. Thus, solutions of DNA complexed with these linkers were drop-cast in order to deposit ultra-thin layers on the surface of HOPG in the absence or presence of Tris buffer. Atomic Force Microscopy analyses showed that, at a fixed ligand-DNA mixing ratio of 16, the mean thickness of the layers can be statistically predicted to lie in the range 0–50 nm with a maximum standard deviation ±…
Extractive-Pyrolytic Method for Au/MeO<sub>x</sub> Nanocomposites Production
2014
Au/MeOx(MeOx- SiO2, Al2O3and TiO2) nanocomposites have been produced by the extractive-pyrolytic method. An organic extract – a solution of n-trioctylammonium tetrachlorolaurate ([Oct3NH]AuCl4) in toluene – was used as a gold-containing precursor. The produced samples were analyzed by IR spectroscopy, X-ray diffraction and scanning electron microscopy. The performed studies have shown that the mean size of the metal crystallites vary within wide limits: on Al2O3from 60 nm to 35 nm; on SiO2from 33 nm to 23 nm; on TiO2from 50 nm to 13 nm.
STRUCTURE AND MAGNETIC PROPERTIES OF COBALT FERRITE PARTICLES PRODUCED BY METHOD OF PYROLYTIC SYNTHESIS
2008
ABSTRACT Magnetic fine particles of cobalt ferrite have been prepared by method of pyrolytic synthesis. X-ray diffraction confirmed the formation of single-phase cobalt ferrite nanoparticles in the range 6–50 nm. The size of the particles varies depending on matrix dispersity and mass content in the organic precursors. A large coercivity observed to be small for smaller single-domain particles due to superparamagnetic behavior.
Spray pyrolytic deposition of ZnO thin layers composed of low dimensional nanostructures
2010
Abstract ZnO nanolayers composed of fine nanostructures have been successively grown by spray pyrolytic deposition at 300 ∘ C over amorphous glass substrates. As deposited samples were analysed by scanning electron microscopy (SEM), showing a granular morphology with grain size in the limit of the microscope resolution. CL measurement shows a broad near band edge (3.4 eV) emission of ZnO in the UV region and the defect level emissions in the green region of the spectrum. The use of intermittent spray pyrolytic deposition is shown as an alternative to increase the homogeneity of the samples when temperatures near to the precursor pyrolytic decomposition is selected, long depositions times a…
Phase Composition and Morphology of Tungsten Oxide Nanoparticles Produced via a Pyrolytic Process
2018
The chemical synthesis is a leading route for the purposeful design of nanomaterials, whereas the tungsten oxides are employed in a variety of special applications. The production of nanomaterials by traditional synthetic methods is still a cumbersome multistep procedure. Here we propose an improved method to produce tungsten oxide nanoparticles via a pyrolytic process. A tungsten-containing precursor was prepared by liquid extraction using n-trioctylamine (C8H17)3N solution in toluene. We have shown that the conditions of thermal treatment of the W-based precursor determine the crystalline structure and nanomorphology of the final product. Monoclinic WO3 nanocrystallites are produced condu…
Multiband light emission and nanoscale chemical analyses of carbonized fumed silica
2018
Fumed silica with a specific area of 295 m2/g was carbonized by successive phenyltrimethoxysilane treatments followed by annealing in inert atmosphere up to 650 °C. Emission, excitation, kinetics, and photo-induced bleaching effects were investigated by steady state and time-resolved photoluminescence spectroscopies. The local chemistry was also studied by infrared transmission spectroscopy. Strong ultraviolet and visible photoluminescence was observed in the samples after the chemical treatments/modifications and thermal annealing. It has been shown that ultraviolet photoluminescence in chemically modified fumed silica is associated with phenyl groups, while near ultraviolet and visible em…
Stabilization of MCM-41 by Pyrolytic Carbon Deposition
2000
A new method of surface modification which is effective in stabilizing silica grades of MCM-41 in the presence of water vapor is presented. It is shown by means of XRD, low-temperature nitrogen ads...
On the pyrolytic decomposition of cadmium carbonate
1996
The pyrolytic decomposition of cadmium carbonate was studied by thermogravimetry (TG), derivative thermogravimetry (DTG), differential thermoanalysis (DTA) and exoemission of electrons (EEE).