Search results for "Radiance"
showing 10 items of 284 documents
FluorMODgui V3.0 : a graphic user interface for the spectral simulation of leaf and canopy chlorophyll fluorescence
2006
The FluorMODgui Graphic User Interface (GUI) software package developed within the frame of the FluorMOD project Development of a Vegetation Fluorescence Canopy Model is presented in this manuscript. The FluorMOD project was launched in 2002 by the European Space Agency (ESA) to advance the science of vegetation fluorescence simulation through the development and integration of leaf and canopy fluorescence models based on physical methods. The design of airborne or space missions dedicated to the measurement of solar-induced chlorophyll fluorescence using remote-sensing instruments require physical methods for quantitative feasibility analysis and sensor specification studies. The FluorMODg…
Weld pool surface temperature measurement from polarization state of thermal emission
2014
This paper presents a passive polarimetry method using a division of aperture optical device in order to measure the temperature distribution at the weld pool surface. Thermal emission from a hot liquid metal was investigated at a near-infrared wavelength corresponding to a blind spectral window of a helium plasma generated during gas tungsten arc welding process. The refractive index of liquid metal and the surface radiance are deduced from the polarisation state of thermal emissions. Based upon the knowledge of both characteristics, the temperature distribution can be calculated. Conseil Régional de Bourgogne
Dual Cherenkov Radiation-Induced Near-Infrared Luminescence Imaging and Photodynamic Therapy toward Tumor Resection
2020
International audience; Cherenkov radiation (CR), the blue light seen in nuclear reactors, is emitted by some radiopharmaceuticals. This study showed that (1) a portion of CR could be transferred in the region of the optical spectrum, where biological tissues are most transparent: as a result, upon radiance amplification in the near-infrared window, the detection of light could occur twice deeper in tissues than during classical Cherenkov luminescence imaging and (2) Cherenkov-photodynamic therapy (CR-PDT) on cells could be achieved under conditions mimicking unlimited depth using the CR-embarked light source, which is unlike standard PDT, where light penetration depth is limited in biologi…
Validation of temperature-emissivity separation and split-window methods from TIMS data and ground measurements
2003
Abstract Land surface temperature retrieved with temperature-emissivity separation (TES) and split-window (SW) algorithms from six-channel Thermal Infrared Multispectral Scanner (TIMS) data in the HAPEX-Sahel experiment agreed with contemporaneous ground temperature measurements to within ±1 °C (TES and SW with channels at 10.8 and 11.7 μm, or SW-56). The SW algorithm used with TIMS channels at 8.4 and 8.7 μm (SW-12) underestimated ground temperatures by 2–5 °C. The TES method required atmospheric correction of at-sensor radiances, which was done with local radiosonde data and MODTRAN 4, and an empirical relationship between the spectral range of emissivity and its minimum value. Emissivity…
Improved Temperature and Emissivity Separation Algorithm for Multispectral and Hyperspectral Sensors
2017
The Temperature and Emissivity Separation (TES) algorithm was originally developed for the Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER). This paper focuses on improving the TES algorithm. The main modification is the replacement of the normalized emissivity module with a new module, which is based on the smoothing of spectral radiance signatures. Smoothing is performed by estimating emissivity using an optimized approximation of the relationship between brightness temperature and emissivity. The improved TES algorithm, which is called Optimized Smoothing for Temperature Emissivity Separation (OSTES), was first tested on simulated data from three different sensors, …
Estimation of solar-induced vegetation fluorescence from space measurements
2007
[1] A characteristic spectral emission is observed in vegetation chlorophyll under excitation by solar radiation. This emission, known as solar-induced chlorophyll fluorescence, occurs in the red and near infra-red spectral regions. In this paper a new methodology for the estimation of solar-induced chlorophyll fluorescence from spaceborne and airborne sensors is presented. The fluorescence signal is included in an atmospheric radiative transfer scheme so that chlorophyll fluorescence and surface reflectance are retrieved consistently from the measured at-sensor radiance. This methodology is tested on images acquired by the Medium Resolution Imaging Spectrometer (MERIS) on board the ENVIron…
Influence of low power CW laser irradiation on skin hemoglobin changes
2012
Influence of low power laser irradiance on healthy skin using diffuse reflectance spectroscopy and multispectral imaging was studied. Changes of diffuse reflectance spectra in spectral range from 500 to 600 nm were observed after 405 nm, 473 nm and 532 nm laser provocation, leading to conclusion that the content of skin hemoglobin has changed. Peaks in spectral absorbance (optical density) curves corresponded to well-known oxy-hemoglobin absorbance peaks at 542 and 577 nm.
Production of hydrogen negative ions in an ECR volume source: balance between vibrational excitation and ionization
2018
International audience; The operation of an ECR-driven (2.45 GHz) hydrogen negative ion source is studied. Electron densities and temperatures are investigated with electrostatic probes and negative ion densities are measured with laser photodetachment. Vacuum ultraviolet irradiance measurements are focused on molecular transitions to the ground state while high-resolution visible emission spectroscopy is used to study the transitions between excited states for both molecules and atoms. The standalone operation of the source is found to be more efficient in higher pressures (12 mTorr) where negative ion densities are as high as 4×109 cm−3. Further investigation on the operation of the sou…
A field method for measuring the thermal infrared emissivity
1993
Abstract In this work, a field method for measuring thermal infrared emissivities is proposed which is based on the box method, initially developed by Buettner and Kern (1965) for laboratory measurements. A theoretical analysis was made of the measurement carried out using the box and a correcting factor to Buettner and Kern's technique has been determined. Buettner and Kern's method has been modified to use radiative temperatures measured with a radiothermometer instead of radiance measurements. The walls of the box used and the cold lid was made of polished aluminium and the hot lid was made of black-painted anodized aluminium and it was heated in the field by solar radiation. With this m…
Modeling and parameter identification of crystalline silicon photovoltaic devices
2011
This paper tests the standard single-exponential model of the electrical characteristics of crystalline-Si photovoltaic devices, focusing on the (apparent) shunt current. Measured characteristics of illuminated polycrystalline-Si photovoltaic modules are modeled, and the apparent shunt current is analyzed. It is shown that an Ohmic-like behavior only takes place at voltages well below the maximum-power point. At higher voltages, the apparent shunt current quickly drops to negligible values. Modeling a crystalline-Si PV device with a fixed shunt resistance may therefore lead to underestimation of the maximum power exceeding 10% at certain irradiance levels.