Search results for "Scanning"
showing 10 items of 1808 documents
Crystal Growth of HgSe by the Cold Travelling Heater Method
2002
We report on the low-temperature synthesis and growth of HgSe crystals making use of the cold travelling heater method. Ingots so obtained are analyzed by means of scanning microscopy, including EDAX and backscattered electron modes, and X-ray diffraction techniques.
Growth temperature influence on the GaN nanowires grown by MOVPE technique
2011
GaN nanowires (NWs) were successfully grown by Vapor-Liquid-Solid (VLS) growth mechanism on GaN template using metal-organic vapor phase epitaxy (MOVPE) with diameters ranging from 20 to 200 nm and length up to few microns. The characterization by scanning electron microscopy (SEM) reveals an optimum growth temperature at 790°C and X-ray diffraction (XRD) investigations indicates oriented crystallinity of grown NWs.
Mechanism of pulsed electron irradiation of the PLZT X/65/35 ceramics
2005
The comprehensive study of high-current pulsed electron irradiation effect on the structure and lattice dynamics as well as Atomic Force (AFM) and Laser Confocal Scanning microscope (LSCM) surface imaginaries of PLZT 8/65/35 ceramics have been performed. X-ray powder diffraction studies show the transformation of the cubic perovskite Pm-3m (Z = 1) into orthorhombic Pmmm (Z = 1) structure for the sample irradiated by one pulse (dose 6 × 1014 electrons/cm2) and into cubic Pm-3m with increased lattice volume and more ordered structure at irradiating by 10 and 100 pulses (dose 6 × 1015 and 6 × 1016 el/cm2). A consequence, the changes of number, intensity and phonon modes position occur in Raman…
Keggin heteropolyacid H3PW12O40 supported on different oxides for catalytic and catalytic photo-assisted propene hydration
2013
Catalytic and catalytic photo-assisted hydration of propene to form 2-propanol in gas–solid regime at atmospheric pressure and 85 1C were carried out by using a heteropolyacid (POM) supported on different oxides. Binary materials were prepared by impregnation of H3PW12O40 on different commercial and home prepared supports (TiO2, SiO2, WO3, ZrO2, ZnO, Al2O3). Some of the composites were active both for catalytic and catalytic photo-assisted reactions. The Keggin type POM was completely and partially degraded, when supported on ZnO and Al2O3, respectively, and these binary solids always resulted as inactive for both catalytic and catalytic photo-assisted reactions. The supported Keggin POM sp…
Crystalline microstructure of sepiolite influenced by grinding
2005
The crystalline microstructure of ground sepiolite has been investigated. A reference sample of sepiolite and products of its comminution by dry grinding were studied through X-ray diffraction pattern analysis, specific surface measurements by nitrogen adsorption and complementary analysis of field emission scanning electron microscope images. A statistical model of polycrystals was applied to describe and determine the crystalline microstructure of the studied specimens. The model parameters characterizing the microstructure were prevalent crystallite shape, volume-weighted crystallite size distribution and second-order crystalline lattice strain distribution, and they were determined for …
The Instability of the NbTe2 Surface Structure
2002
Low energy electron diffraction from clean NbTe 2 surfaces shows very diffuse reflections. The effect is attributed to an anisotropic heating of the irradiated Te-Nb-Te surface layer. Diffraction patterns for electron energies below 90 eV correspond to an overlapped contribution from numerous domains, belonging to three orientational variants. Electrons of higher energies stabilize the parent high-temperature CdI 2 structure. A similar effect is observed during scanning tunneling microscopy, where the expected surface corrugation is usually lost for tunneling currents of a few ten nA.
Thermal, spectroscopic and crystallographic analysis of mannose-derived linear polyols
2018
The major diastereomer formed in the Barbier-type metal-mediated allylation of D-mannose has previously been shown to adopt a perfectly linear conformation, both in solid state and in solution, resulting in the formation of hydrogen-bonded networks and subsequent aggregation from aqueous solution upon stirring. Here, a comprehensive study of the solid state structure of both the allylated D-mannose and its racemic form has been conducted. The binary melting point diagram of the system was determined by differential scanning calorimetry analysis, and the obtained results, along with structure determination by single crystal X-ray diffraction, confirmed that allylated mannose forms a true rac…
Mechanical and structural characterizations of gamma- and alpha-alumina nanofibers
2015
Abstract We investigate the applicability of alumina nanofibers as a potential reinforcement material in ceramic matrix compounds by comparing the mechanical properties of individual nanofibers before and after annealing at 1400 °C. Mechanical testing is performed inside a scanning electron microscope (SEM), which enables observation in real time of the deformation and fracture of the fibers under loading, thereby providing a close-up inspection of the freshly fractured area in vacuum. Improvement of both the Young's modulus and the breaking strength for annealed nanofibers is demonstrated. Mechanical testing is supplemented with the structural characterization of the fibers before and afte…
A multi-technique, micrometer- to atomic-scale description of a synthetic analogue of chukanovite, Fe-2(CO3)(OH)(2)
2014
International audience; A synthetic analogue of chukanovite Fe-2(CO3)(OH)(2) is formed during experimental work on iron-clay interactions simulating the cooling of containers in radioactive waste repositories. Despite its small size and the mixture with other minerals it is undoubtedly identified by X-Ray Diffraction, Fourier Transform Infrared Spectroscopy, Scanning Electron Microscopy and Transmission Electron Microscopy. For the first time, the structural characterisation of a synthetic chukanovite is carried out thanks to the combination of Automated Diffraction Tomography and Precession Electron Diffraction. Refinement results and comparison with literature data show that the structure…
Relative proportions of rutile and pseudo-brookite phases in the Fe(III)-TiO2 system at elevated temperature
1997
Abstract The Fe(III)-TiO2 system has been studied at T ≥ 1023 K in the range of concentration 2–10 at.% of iron by powder X-ray diffraction, transmission and scanning electron microscopy, and optical microscopy. The relationship between the relative proportions of the TiO2 rutile phase and the pseudo-brookite phase Fe2TiO5, has been investigated in powder samples. Single crystals of pure rutile and rutile doped with 0.5 at.% of iron have been examined to elucidate the microstructures found in the powders. The results suggest that a low degree of solid solubility exists and that doped crystals contain planar faults on 101 planes.