Search results for "Signal processing"

Urban Energy Hubs and Microgrids: Smart Energy Planning for Cities

2017

In this chapter, we try to connect the urban design features with energy consumption and consequent pollution parameters. After a review of a selected set of approaches to Urban Energy Systems study with a special focus on electrical power systems, urban energy systems are proposed as networks of multi-source hybrid energy hubs, where different energy flows are collected at the same bus and can be stored, delivered or transformed as needed. Resources at the hub and infrastructures interact with each other; therefore, both definition and boundaries of such energy systems at urban level are difficult to be clearly outlined. Similarly, the possibility to generate new operational models based o…

Identification of the inertial model for innovative semi-immergible USV (SI-USV) drone for marine and lakes operations

2015

The proposed project shows the results obtained in the implementation and testing in lacustrine and marine environment of a nautical remote controlled vehicle with surface navigation and innovative features Semi-Immergible (SI-USV). This vehicle is based on a pending patent belonging to Palermo University (Patent Pending RM2012A000209 and Patent RM2014Z000060) concerning innovative semi-immersible vehicles (SI-Drone), that can be remotely controlled from the ground, air, satellite and sea also during the semi-immersible operation. Given its low draft, the electric powered vehicle, coupled with jet propulsion, makes it possible to navigate in shallow waters, coastal shipping or sandbars.

Exploring FPGA‐Based Lock‐In Techniques for Brain  Monitoring Applications

2017

Functional near‐infrared spectroscopy (fNIRS) systems for e‐health applications usually suffer from poor signal detection, mainly due to a low end‐to‐end signal‐to‐noise ratio of the electronics chain. Lock‐in amplifiers (LIA) historically represent a powerful technique helping to improve performance in such circumstances. In this work a digital LIA system, based on a Zynq® field programmable gate array (FPGA) has been designed and implemented, in an attempt to explore if this technique might improve fNIRS system performance. More broadly, FPGA‐based solution flexibility has been investigated, with particular emphasis applied to digital filter parameters, needed in the digital LIA, and its …

Closed-loop bandwidth impact on MVSA for rotor broken bar diagnosis in IRFOC double squirrel cage induction motor drives

2013

This paper investigates the detectability of rotor broken bars in indirect rotor flux oriented control (IRFOC) for variable speed double cage induction motor drives, using vibration signature analysis techniques. The Impact of the closed loop control system cannot be neglected when the detection of rotor asymmetries in the machine is based on the signature analysis of electrical or mechanical variables. Therefore, the investigation of rotor fault components for different bandwidths of closed-loop regulators is necessary to evaluate its relevance in the above listed variables. This paper investigates the impact of the control system on relevance of the fault components computed from axial an…

Exposure to bioaerosols and noise at a Finnish dry waste treatment plant

2004

Repeated measurements were carried out during two different campaigns between 1998 and 2001 to assess the occupational hygiene at a Finnish dry waste treatment plant. The analytical determinations were done in four different places within the processing hall of the plant: near a conveyor belt, near a jigger screen, near an after-crusher and near a bailer. Measurements were also carried out in a coffee room for employees. Concentrations of bacteria, fungi and actinomycetes were determined by two methods (six-stage impactor and Camnea method) and levels of endotoxins, dust and noise were also investigated. High concentrations of microbes and endotoxins and the noise level were found to be a …

Application of the IO Methodology to the Energy and Environmental Analysis of a Regional Context

2009

Performing an energy and environmental analysis, researchers have to face many problems regarding the data quality and availability. Data are often out-of-date, not representative and consistent or, frequently, referred to faraway geographic and productive contexts. The Input-Output (IO) model, due to its simplicity, allows to acquire information regarding the energy and environmental performances of productive sectors.

Control and Estimation of Electrified Vehicles

2015

A new preprocessing and control board for the phase 2 electronics of AGATA experiment

2016

The electronics of AGATA HPGe segmented gamma ray detector faces a new challenge in the search of a bigger integration and cost reduction for the phase 2 of the experiment going beyond 45 crystals. This opportunity can be used to introduce a new architecture based on commercial standards while keeping backward compatibility with current electronics. In this sense, new FPGA devices and fast Ethernet links can be used to ease the preprocessing and control task and allowing for processor farms to distribute the processing load. At the same time, modularity should be a key feature of the design in the aim to make it upgradable in time and technology. This paper presents the design of a new prep…

A study on spectral optimisation in partial response CPM signals

1995

An optimisation technique for the minimisation of the effective bandwidth in partial response CPM signals is described. The minimum Euclidean distance is used as optimisation constraint because the bit error probability is a function of this parameter for high values of signal to noise ratio. The procedure has been implemented for a correlation length corresponding to two signalling intervals. The optimisation problem leads to a system of two nonlinear differential equations for the pulse shape, together with some boundary conditions. Numerical solution of the differential equations has been performed; initial conditions have been adjusted, to satisfy the boundary conditions using an iterat…

Taking Advantage of Selective Change Driven Processing for 3D Scanning

2013

This article deals with the application of the principles of SCD (Selective Change Driven) vision to 3D laser scanning. Two experimental sets have been implemented: one with a classical CMOS (Complementary Metal-Oxide Semiconductor) sensor, and the other one with a recently developed CMOS SCD sensor for comparative purposes, both using the technique known as Active Triangulation. An SCD sensor only delivers the pixels that have changed most, ordered by the magnitude of their change since their last readout. The 3D scanning method is based on the systematic search through the entire image to detect pixels that exceed a certain threshold, showing the SCD approach to be ideal for this applicat…