Search results for "Solid"
showing 10 items of 3575 documents
Ion-sputtering deposition of Ca–P–O films for microscopic imaging of osteoblast cells
2007
Abstract An ion-beam sputtering technique was used to produce Ca–P–O films on borosilicate glass at room temperature from hydroxyapatite targets using nitrogen, argon and krypton beams at different acceleration voltages. The sputtering target was pressed from high purity hydroxyapatite powder or mixture of high purity hydroxyapatite powder and red phosphorus in order to optimise the film composition. The film composition, determined using time-of-flight elastic recoil detection analysis (TOF–ERDA), was found to be strongly dependent on the ion energy used for deposition. By extra doping of the target with P the correct Ca/P atomic ratio in the deposited films was reached. The films deposite…
Optical spectroscopy and performance tests with a solid state laser ion source at HRIBF
2008
An ISOLDE-type hot-cavity laser ion source based on high-repetition-rate Ti:Sapphire lasers has been set up at the Holifield radioactive ion beam facility. To assess the feasibility of the all-solid-state laser system for applications at advanced radioactive ion beam facilities, spectroscopy and performance tests have been conducted with this source. The results of recent studies on excitation schemes, source efficiency, beam emittance and ion time structure are presented.
Germanium Doped CHxMicroshells for LMJ Targets
2011
AbstractAt the CEA Laser “Megajoule” facility, amorphous hydrogenated carbon (a-C:H or CHx) is the nominal ablator used to achieve inertial confinement fusion experiments. These targets are filled with a fusible mixture of deuterium-tritium in order to perform ignition.Since the achievement of ignition greatly depends on the physical properties of the shell, there must be precise control of thicknesses, doping concentration, and roughness. Experimental devices associated with suitable characterizations are described in this paper. The tolerances and yields for each specification are also presented. Some specifications are largely reached; high-frequency surface roughness due to isolated sur…
Effect of ion irradiation on the stability of amorphous Ge2Sb2Te5 thin films
2008
The archival life of phase-change memories (PCM) is determined by the thermal stability of amorphous phase in a crystalline matrix. In this paper, we report the effect of ion beam irradiation on the crystallization kinetics of amorphous Ge2Sb2Te5 alloy (GST). The transition rate of amorphous GST films was measured by in situ time resolved reflectivity (TRR). The amorphous to crystal transformation time decreases considerably in irradiated amorphous GST samples when ion fluence increases. The stability of amorphous Ge2Sb2Te5 thin films subjected to ion irradiation is discussed in terms of the free energy variation of the amorphous state because of damage accumulation. © 2008 Elsevier B.V. Al…
Formation of cobalt silicide from filter metal vacuum arc deposited films
2006
The thermal reaction of Co film deposited on Si(111) surfaces by a high current filter metal vacuum arc (FMEVAD) system has been studied. After deposition the films were annealed over the 400-900 degrees C temperature range for 30 min. Rutherford backscattering spectrometry (RBS) was used to characterize the elemental depth distributions in the films subjected to different annealing temperatures. Ordered chemical phases were determined by glancing-incidence X-ray diffraction (GIXRD) and the morphology was determined by cross section transmission electron microscopy (TEM). The results show that the phases formed are Co2Si at 400 degrees C, CoSi + Coo at 500 degrees C, CoSi + CoSi2 at 600 deg…
Study of Fe−Ti and Fe−TiN interfaces by conversion electron Mössbauer spectroscopy
1992
Titanium and titanium nitride-iron interfaces obtained by PVD coated thin films of Ti and TiN onto argon plasma etched iron substrates at various temperatures and negative bias were studied by use of CEMS. It was found that intermixing to Ti with Fe resulted in the appearance of an amorphous FeTi1−x phase. Furthermore, a comparison of CEM spectra of samples before and after heating in UHV has shown rather strong influence of thermal treatments on Fe/Ti as well as Fe/TiN interfaces.
A new beamline for energy-dispersive high-resolution PIXE analysis using polycapillary optics
2019
Abstract A new beamline for high energy resolution PIXE measurements is presented. This new setup includes options for both in-air and vacuum measurements. For the high energy resolution transition-edge sensor array, a polycapillary lens is used for detecting low-energy X-rays down to 0.5 keV and to increase the effective solid angle. X-ray transmission of the polycapillary lens was characterized using two calibration standards. The gain obtained by adding a polycapillary lens was 1.6–2.3 at energies between 2.1 keV and 4.5 keV. From 1.04 to 1.74 keV the gain is increased to 2.1–3.0, and at energies 4.9–8.0 keV the gain is between 1.6 and 0.65. The measured gain agreed well with theoretical…
Radiation defects in complex perovskite solid solutions
2014
Abstract First principles density functional theory (DFT) based modeling is performed to explore formation energies of a series of point cation and oxygen defects, Frenkel and Schottky disorder, as well as structural disorder in Ba1−xSrxCo1−yFeyO3−δ (BSCF) perovskite solid solutions. The results are compared with previous studies on a prototype SrTiO3 perovskite. It is shown that BSCF permits accommodation of a high concentration of defects and cation clusters but not antisite defects.
State of the art of CPMAS 13C-NMR spectroscopy applied to natural organic matter
2004
A number of different techniques are presently available for characterizing humified natural organic matter (NOM). Carbon-13 nuclear magnetic resonance spectroscopy (13C-NMR) in the solid state using cross-polarization (CP) and magic angle spinning (MAS) represents the most powerful experimental approach used to collect direct information on the structural and conformational characteristics of humic carbon backbones. Despite the problems due to the presence of paramagnetic impurities and the generally low organic matter concentration, cross-polarization magic angle spinning 13C-NMR spectroscopy (CPMAS 13C-NMR) is applied in soil chemistry and geochemistry mainly because of its relevance in …
Oxygen-excess-related point defects in glassy/amorphous SiO2 and related materials
2012
Abstract An insight is given into recent experimental advances in the spectroscopic studies of oxygen-excess intrinsic defects, in glassy SiO 2 and α-quartz. By controlling excess oxygen in a-SiO 2 , and the conditions of F 2 -laser irradiation, SiO 2 glass samples can be obtained with optical absorption almost exclusively dominated by single defect, oxygen dangling bonds (“non-bridging oxygen hole centers” or NBOHCs), without the presence of complementary Si dangling bonds (generic “E′-centers”). This allows for a more accurate determination of the spectral shape of NBOHC optical absorption in UV and vacuum UV spectral regions. The temperature dependence of NBOHC electron paramagnetic reso…