Search results for "Static timing analysis"
showing 5 items of 15 documents
Timing and spectral changes of the Be X-ray transient EXO 0531-6609.2 through high and low state
2004
We report on spectral and timing analysis of BeppoSAX data of the 13.6 s period transient X-ray pulsar EXO 0531-6609.2. Observations were carried out in March 1997 and October 1998, catching the source during a high and a low emission state, respectively. Correspondingly, the X-ray luminosity is found at a level of 4.2x10^37 erg/s and 1.5x10^36 erg/s in the two states. In the high state the X-ray emission in the energy range 1-100 keV is well fitted by an absorbed power-law with photon index Gamma ~1.7 plus a blackbody component with a characteristic temperature of ~3.5 keV. Moreover, we find an evidence of an iron emission at ~6.8 keV, typical feature in this class of sources but never rev…
Measuring the spin up of the Accreting Millisecond Pulsar XTE J1751-305
2007
We perform a timing analysis on RXTE data of the accreting millisecond pulsar XTE J1751-305 observed during the April 2002 outburst. After having corrected for Doppler effects on the pulse phases due to the orbital motion of the source, we performed a timing analysis on the phase delays, which gives, for the first time for this source, an estimate of the average spin frequency derivative = (3.7 +/- 1.0)E-13 Hz/s. We discuss the torque resulting from the spin-up of the neutron star deriving a dynamical estimate of the mass accretion rate and comparing it with the one obtained from X-ray flux. Constraints on the distance to the source are discussed, leading to a lower limit of \sim 6.7 kpc.
Filtering and emission area identification in the Time Resolved Imaging data
2012
Abstract Time Resolved Imaging (TRI) acquisitions allow precise timing analysis of emission spots. Up to date technologies deeply challenge their isolation by hiding the weak ones, under sizing or over sizing visually detectable emission spots and finally by jeopardizing timing resolution. We report on an algorithm based on 1 and 2D signal processing tools which automates the identification of emission sites and optimizes separation between noise and useful signal, even for weak spots surrounding strong emission areas. The application of the algorithm on several sets of data from different types of devices and their results are also discussed.
Study of the accretion torque during the 2014 outburst of the X-ray pulsar GRO J1744−28
2017
We present the spectral and timing analysis of the X-ray pulsar GRO J1744-28 during its 2014 outburst using data collected with the X-ray satellites Swift, INTEGRAL, Chandra, and XMM-Newton. We derived, by phase-connected timing analysis of the observed pulses, an updated set of the source ephemeris. We were also able to investigate the spin-up of the X-ray pulsar as a consequence of the accretion torque during the outburst. Relating the spin-up rate and the mass accretion rate as $\dot{\nu}\propto\dot{M}^{\beta}$, we fitted the pulse phase delays obtaining a value of $\beta=0.96(3)$. Combining the results from the source spin-up frequency derivative and the flux estimation, we constrained …
Timing an Accreting Millisecond Pulsar: Measuring the Accretion Torque in IGR J00291+5934
2006
We performed a timing analysis of the fastest accreting millisecond pulsar IGR J00291+5934 using RXTE data taken during the outburst of December 2004. We corrected the arrival times of all the events for the orbital (Doppler) effects and performed a timing analysis of the resulting phase delays. In this way we have the possibility to study, for the first time in this class of sources, the spin-up of a millisecond pulsar as a consequence of accretion torques during the X-ray outburst. The accretion torque gives us for the first time an independent estimate of the mass accretion rate onto the neutron star, which can be compared with the observed X-ray luminosity. We also report a revised valu…