Search results for "Surfaces and Interfaces"
showing 10 items of 939 documents
Adsorption of gelatin during electrodeposition of copper and tin-copper alloys from acid sulfate electrolyte
2014
International audience; An acid Cu–Sn deposition bath was developed, and copper and copper–tin coatings were electrodeposited on polycrystalline platinum. The effect of gelatin on copper and copper–tin electrodeposition from acid sulfate solutions has been investigated by a variety of electrochemical methods (voltammetric studies and electrochemical quartz crystal microbalance) as well as by morphologic technique (scanning electron microscopy). The electrochemical results have shown that the overpotential is required when gelatin is added, indicating the presence of interaction between the additive and the coating. From the results of X-ray photoelectron spectroscopy, PM-IRRAS and cyclic vo…
Development of antibiotic loaded biodegradable matrices to prevent superficial infections associated to total knee arthroplasty.
2019
Abstract Development of a pharmaceutical form for the superficial infections related with arthroplasties would be helpful for clinical practice. In this context, we set out to evaluate ciprofloxacin and gentamicin elution from systems based on chitosan. Films and semisolid hydrogels containing chitosan alone (2%) or in combination with gelatin (6%) or different proportions (from 12% to 36%) of tetrakis-(hydroxymethyl)-phosphonium-chloride (THPC) were tested as delivery systems. Different antibiotic doses were assayed (0.5 mg/cm2,1 mg/cm2 and 2 mg/cm2). Antibiotic release was studied for each formulation. In vitro cytocompatibility studies and a simulation exercise for bioactivity evaluation…
Positron Studies of Subsurface Zone in Titanium Created in Sliding Wear
2014
Positron annihilation studies of the subsurface zone constituted during dry sliding in pure titanium are reported. A new type of defect depth profile in this zone, which is not an exponential decay usually reported for other metals and alloys, is observed. Two layers in the subsurface zone are present in this metal. In the layer adjacent to the worn surface, the characteristic plateau of the mean positron lifetime that extends to a depth of 60–70 μm was observed. Small vacancy clusters and dislocations were recognized in this layer. At deeper zone, the mean positron lifetime decreased exponentially in the manner typical for the other metals. In this zone, vacancy clusters increase in size a…
Production of Phosphorescent Coatings on 6082 Aluminum Using Sr0.95Eu0.02Dy0.03Al2O4-δ Powder and Plasma Electrolytic Oxidation
2019
In this study, a new approach for producing phosphorescent aluminum coatings was studied. Using the plasma electrolytic oxidation (PEO) process, a porous oxide coating was produced on the Al6082 aluminum alloy substrate. Afterwards, activated strontium aluminate (SrAl2O4: Eu2+, Dy3+) powder was filled into the cavities and pores of the PEO coating, which resulted in a surface that exhibits long-lasting luminescence. The structural and optical properties were studied using XRD, SEM, and photoluminescence measurements. It was found that the treatment time affects the morphology of the coating, which influences the amount of strontium aluminate powder that can be incorporated into the coating …
Optimized bath for electroless deposition of palladium on amorphous alumina membranes
2006
A new bath for the electroless deposition of palladium on anodic alumina (AA) membranes is proposed. It was found that the optimal conditions for the uniform deposition of palladium, with minimal damage to the AA membranes, were under conditions of pH 8.4 and plating times shorter than 30 min. The deposited Pd layer was detected by X-ray diffraction (XRD) and energy dispersive X-ray (EDX) analysis. The morphology of the AA membrane before and after plating was examined by scanning electron microscopy (SEM). EDX analysis revealed that palladium was deposited only on the surfaces of the membrane and Sn ions, coming from the sensitizing bath, were incorporated into the palladium layer. EDTA in…
X-ray Photoelectron-spectroscopy Investigation of Pumice-supported Nickel-catalysts
1995
Pumice-supported nickel catalysts, prepared by the method of slow homogeneous precipitation with urea, were analysed by x-ray photoelectron spectroscopy (XPS). By comparison with similarly prepared silica- and alumina-supported nickel catalysts, a preferential interaction of Ni2+ with Al3+ of the support has been determined. A quantitative XPS analysis indicated large segregation of nickel to the surface. The treatment with H2 at 673 K and 1073 K produced a partial reduction of Ni+2 to Ni0. The extent of the reduction was largest at 1073 K and in this case the reduced Ni in the metallic phase was detectable by x-ray diffraction. A decrease of the Ni 2p/Si 2p intensity ratio occurring in the…
Study by static SIMS, XPS and UPS of the adsorption of cyanogen on (100) Ni surfaces
2000
Abstract The interaction of cyanogen with (100) Ni surfaces at room temperature was studied using secondary ion mass spectrometry in a static mode, and photoemission spectroscopies (XPS and UPS). It has been shown that cyanogen is adsorbed on this nickel surface in a dissociative mode: atomic carbon and nitrogen are present on the surface as well as CN fragments. These adsorbed species have been characterized by XPS and UPS. Increasing the temperature in the 400 K range increases the rate of the dissociation reaction of CN into atomic carbon and nitrogen. Moreover carbon is found to dissolved into the bulk for temperatures as low as 475 K. No evidence has been found of a polymerized form of…
A surface EXAFS study of thin nickel deposits on (110) TiO2 surfaces
1997
Abstract The first stages of nickel deposition on a clean (110) TiO 2 surface were studied using surface extended X-ray absorption fine structure (EXAFS). Experiments were performed on two kinds of nickel deposits, one of 0.8 equivalent monolayers and another of 1.6 equivalent monolayers. Depositions were performed on well characterized TiO 2 (110)-p(1 × 1) surfaces. The correlation of Auger experiments with EXAFS results showed that no islands were present on the surface; only two-dimensional growth of nickel was observed. Moreover, it was shown, in the case of the thinner deposit, that a model with nickel atoms forming chains in the channels determined by oxygen atoms on the surface is co…
Determination of the Absolute Density of Fe3+ and Ni2+ Ions in Langmuir-Blodgett Films
1996
By means of the Langmuir–Blodgett (LB) technique, mono- and multilayers of Ni2+ and Fe3+ containing fatty acid salts are transferred onto silicon wafers. After thermal treatment, oxidic layers can be produced. The absolute amounts of Fe3+ and Ni2+ ions per monolayer of LB film were measured and calculated by three different methods. In the case of nickel, the amount expected from theory and preparation conditions was obtained experimentally. In contrast, about twice the number of Fe3+ ions as expected is transferred. An explanation can be given by the presence of hydroxide groups bound to iron. The mean film thickness of the oxidic layers after thermal treatment was estimated where the thic…
Monte Carlo Simulations of Parallel Charged Platelets as an Approach to Tactoid Formation in Clay
2013
The free energy of interaction between parallel charged platelets with divalent counterions has been calculated using Monte Carlo simulations to investigate the electrostatic effects on aggregation. The platelets are primarily intended to represent clay particles. With divalent counterions, the free energy for two platelets or two tactoids (clusters of parallel platelets) shows a minimum at a short separation due to the attraction caused by ion-ion correlations. In a salt-free system, the free energy of interaction has a long-range repulsive tail beyond the minimum. The repulsion increases for tactoids with larger aggregation numbers, whereas the depth of the free-energy minimum is graduall…