Search results for "TEMPERATURE RANGE"
showing 10 items of 433 documents
Comparison of the F-type center thermal annealing in heavy-ion and neutron irradiated Al2O3 single crystals
2018
Abstract The optical absorption and thermally stimulated luminescence of Al2O3 (sapphire) single crystals irradiated with swift heavy ions (SHI) 238U with energy 2.4 GeV is studied with the focus on the thermal annealing of the F-type centers in a wide temperature range of 400–1500 K. Its theoretical analysis allows us to obtain activation energies and pre-exponentials of the interstitial oxygen ion migration, which recombine with both types of immobile electron centers (F and F+ centers). A comparison of these kinetics parameters with literature data for a neutron-irradiated sapphire shows their similarity and thus supports the use of SHI-irradiation for modeling the neutron irradiation.
Lattice sites of diffused gold and platinum in epitaxial ZnSe layers
2000
Abstract The lattice location of diffused gold and platinum in zinc selenide (ZnSe) epitaxial layers was studied using the Rutherford backscattering (RBS) channeling technique. Thin Au and Pt films were evaporated onto ZnSe samples. The Au/ZnSe samples were annealed at 525°C and the residual Au film was removed by etching. Channeling angular scan measurements showed that about 30% of Au atoms were close to substitutional site (displaced about 0.2 A). In the case of the Pt/ZnSe samples the annealing temperatures ranged from 600°C to 800°C. The Pt minimum yields along 〈1 0 0〉 direction were close to the random value, varying from 80% to 90%. The measured Pt angular scans along 〈1 0 0〉 and 〈1 …
Radiation-induced defects in sapphire single crystals irradiated by a pulsed ion beam
2020
Abstract The luminescence and thermal stability of defects formed in α-Al2O3 single crystals after powerful (300 keV) pulsed irradiation with C+/H+ ion beam were investigated. It was found by measuring of optical density, photoluminescence, and pulsed cathodoluminescence that ion irradiation induces both single F-, F+-centers and F2-type aggregate centers. An intense thermoluminescence band with a complex shape was observed in the broad temperature range of 350–700 K, its intensity decreases with increasing of the energy density of the ion beam. The thermal stability of the F-type defects produced in α-Al2O3 after irradiation with a pulsed ion beam is comparable to that in neutron-irradiate…
Relaxation of polarization in (K0.5Na0.5)(Nb0.93Sb0.07)O3 ferroelectric ceramics modified by BaTiO3
2017
ABSTRACTA study of low-frequency relaxation of polarization in conventionally prepared ceramic compounds of (1-x)(K0.5Na0.5)(Nb0.93Sb0.07)O3+xBaTiO3+0.5mol.%MnO2 (x = 0.02, 0.04) examined over a wide temperature range is reported. Anomalous behavior of the temperature dependence of the coercive field Ec(T) is detected in the temperature range of the orthorhombic to tetragonal phase transition. The observed features of polarization are assigned to dynamics of the domain structure at the temperature range of phase coexistence.
Study of the thermochromic phase transition in CuMo1−xWxO4 solid solutions at the W L3-edge by resonant X-ray emission spectroscopy
2021
Abstract Polycrystalline CuMo 1 − x W x O 4 solid solutions were studied by resonant X-ray emission spectroscopy (RXES) at the W L 3 -edge to follow a variation of the tungsten local atomic and electronic structures across thermochromic phase transition as a function of sample composition and temperature. The experimental results were interpreted using ab initio calculations. The crystal-field splitting parameter Δ for the 5d(W)-states was obtained from the analysis of the RXES plane and was used to evaluate the coordination of tungsten atoms. Temperature-dependent RXES measurements were successfully employed to determine the hysteretic behaviour of the structural phase transition between t…
Dielectric behaviour of BaTi1-xZrxO3ceramics obtained by means of a solid state and mechanochemical synthesis
2016
ABSTRACTIn this study the comparison of dielectric behaviour of BaTi1-xZrxO3 (BTZx) ceramic samples prepared by means of a solid state and mechanochemical synthesis was presented. A single phase of perovskite structure was identified in the samples at room temperature. No significant impurities were detected in an EDS spectrum and the samples had a good stoichiometric ratio. The morphology of the investigated samples was characterized by a scanning electron microscopy (SEM). The investigation of dielectric properties of the BTZx samples within the temperature range from 140 K to 600 K was performed by means of a dielectric spectroscopy method at the frequency ranging from 0.1 Hz to 10 MHz. …
Thermal oxidation of the intermetallic phases Al 8 Mo 3 and AlMo 3
2017
Abstract The thermal oxidation reactions of the intermetallic phases Al8Mo3 and AlMo3 were investigated and analyzed by ex-situ powder-x-ray diffraction (XRD), difference thermal analysis (DTA), thermogravimetry (TGA), and infrared spectroscopy (IR). The initial oxidation reactions in air were found to yield Al2O3 and AlMo3 in the case of Al8Mo3 (Tonset =725 °C), and MoO3 as well as Al8−xMo3 (Tonset =435 °C) for the pure intermetallic phase AlMo3, respectively. Thus, both intermetallic phases are coexisting in an equilibrium within a temperature range of 300 °C under oxidizing conditions. The formation of β-Al2(MoO4)3 followed the second oxidizing process of the respective minority componen…
Quantification of relaxor behavior in (1 − x)Na0.5Bi0.5TiO3 – xCaTiO3 lead-free ceramics system
2019
Abstract This work examines the relaxor behavior of lead-free ceramic (1 − x)Na0.5Bi0.5TiO3–xCaTiO3 systems. A stable rhombohedral (R3c) phase is detected at room temperature for all compositions by XRD and Raman spectroscopy. Relaxor behavior was observed in the temperature range 300 K - 400 K for all materials. Ceramics exhibit normal ferroelectric properties at room temperature, and then they develop relaxor characteristics with increasing temperature showing the same dispersive properties. This work quantifies the relaxor phenomenon at low temperature. For instance, the maximum temperature of relaxor and the order of dispersion were determined at the strongest dispersion. Finally, the s…
Normal and relaxor ferroelectric behavior in the Ba1−xPbx(Ti1−yZry)O3 solid solutions
2017
Abstract Polycrystalline samples of Ba 1−x Pb x (Ti 1−y Zr y )O 3 (BPTZ) with x = 0.025 & 0.1 and 0.10 ≤ y ≤ 0.50 have been synthesized by high-temperature solid-state reaction technique. X-ray diffraction reveals the formation of single phase with tetragonal or cubic structure. Dielectric investigations were carried out in the temperature range from 80 to 445 K with frequencies range from 10 2 to 10 6 Hz. A broad dielectric anomaly coupled with the shift of dielectric maxima toward a higher temperature with increasing frequency indicates either a diffuse phase transition or relaxor behavior in some of these ceramics. Whatever lead content, when zirconium is substituted by titanium, T C an…
An investigation of photo- and pressure-induced effects in a pair of isostructural two-dimensional spin-crossover framework materials
2014
International audience; Two new isostructural iron(II) spin-crossover (SCO) framework (SCOF) materials of the type [Fe(dpms)2 (NCX)2 ] (dpms=4,4'-dipyridylmethyl sulfide; X=S (SCOF-6(S)), X=Se (SCOF-6(Se))) have been synthesized. The 2D framework materials consist of undulating and interpenetrated rhomboid (4,4) nets. SCOF-6(S) displays an incomplete SCO transition with only approximately 30 % conversion of high-spin (HS) to low-spin iron(II) sites over the temperature range 300-4 K (T1/2 =75 K). In contrast, the NCSe(-) analogue, SCOF-6(Se), displays a complete SCO transition (T1/2 =135 K). Photomagnetic characterizations reveal quantitative light- induced excited spin-state trapping (LIES…