Search results for "Thermometer"
showing 10 items of 48 documents
European Dissemination of the Ultra-low Temperature Scale, PLTS-2000
2003
The first phase of the EU collaborative project on sub‐kelvin thermometry, ‘ULT Dissemination’, is nearing completion, leading to the development of several thermometers and devices, and the instrumentation needed to disseminate the new Provisional Low Temperature Scale, PLTS‐2000, to users. Principal among these are a current‐sensing noise thermometer (CSNT), a CMN thermometer adapted for industrial use, a Coulomb blockade thermometer, a second‐sound acoustic thermometer and a superconductive reference device SRD‐1000. Several partners have set up 3He melting‐pressure thermometers to realise the PLTS‐2000, and will check it using Pt‐NMR, CMN and other thermometers. The scale, which was for…
Wide-range thermometer based on the temperature-dependent conductance of planar tunnel junctions
2000
The effect of the Fermi–Dirac distribution on the current through standard planar tunnel junctions is a suitable basis for thermometry in a wide temperature range. In particular, it extends the range spanned by Coulomb-blockade thermometers up to room temperature.
Coulomb blockade nanothermometer
1998
Reliable thermometry is normally based on commercial secondary sensors which are factory calibrated. Primary thermometers exist, too, but their use is limited because of intrinsic slowness, complex instrumentation, or inconvenient installation at the desired location. We have found that arrays of nanoscale tunnel junctions exhibit properties which are very suitable for primary and secondary cryogenic thermometry. Temperature range of this Coulomb blockade thermometer (CBT) extends over about two decades for one sensor and the mean temperature is lithographically adjustable. We have studied the performance of the CBT sensors at very low temperatures where the minimum temperature is limited b…
Normal metal - insulator - superconductor thermometers and coolers with titanium-gold bilayer as the normal metal
2018
We have fabricated superconductor - insulator - normal metal - insulator - superconductor (SINIS) tunnel junctions in which Al acts as the superconductor, AlOx is the insulator, and the normal metal consists of a thin Ti layer (5 nm) covered with a thicker Au layer (40 nm). We have characterized the junctions by measuring their current-voltage curves between 60 mK and 750 mK. For comparison, the same measurements have been performed for a SINIS junction pair whose normal metal is Cu. The Ti-Au bilayer decreases the SINIS tunneling resistance by an order of magnitude compared to junctions where Cu is used as normal metal, made with the same oxidation parameters. The Ti-Au devices are much mo…
Empirical calibration of the clumped isotope paleothermometer using calcites of various origins
2014
We present the first universal calibration of the clumped isotope thermometer for calcites of various mineralizing types. These are an eggshell of an ostrich, a tropical bivalve, a brachiopod shell, cold seep carbonate, and three foraminifera samples that grew between 9 and 38 C. CaCO3 was digested at 90 C using a common acid bath. Considering a difference in phosphoric acid fractionation factors between reaction at 25 and 90 C of 0.069& (Guo et al., 2009), the function between growth temperature T and the excess of 13 C– 18 O bonds in the evolved CO2 is expressed by a linear regression between 1/T 2 and absolute D47 (R 2 = 0.9915):
Ordering kinetics in synthetic Mg(Al,Fe3+)2O4 spinels: Quantitative elucidation of the whole Al-Mg-Fe partitioning, rate constants, activation energi…
2014
A novel procedure, based on the application of the kinetics simulator Gepasi, has been successfully applied for modeling the cation ordering process in two synthetic Mg(Al2-yFe3+y)O4 spinels (y~ 0.39 and 0.54, samples F39 and F54, respectively). The kinetic profiles suggested a two-stage mechanism, with rapid inter-site exchange of Fe3+ with Mg followed by slow exchange of Al with Mg. The trial to apply the classical approaches, based on the explicit solutions of the differential equations corresponding to single-cation (Sha-Chappel model) or two-cation (Müller model) exchange reactions, proved not feasible in the whole time range, thus implying a lack of information about the exchange proc…
EU dissemination of the provisional ultra-low-temperature scale, PLTS-2000
2003
Following the introduction of the provisional low-temperature scale from 0.9 mK to 1K, PLTS-2000, there is a need for primary and secondary thermometers and fixed points, which can disseminate the scale to users. This paper reports on the progress, within the EU collaborative project ‘ULT Dissemination’, in the development and evaluation of several devices with associated instrumentation. Principal among them are a current-sensing noise thermometer, a CMN thermometer adapted for industrial use, a Coulomb blockade thermometer, a second-sound thermometer, a 3He melting pressure thermometer for a direct realisation of the PLTS-2000. A superconductive reference device has also been developed, a…
Improving the Diagnostic Accuracy of the Distress Thermometer: A Potential Role for the Impact Thermometer
2015
Abstract Context Screening for and management of distress in clinical practice is an important issue in the field of psycho-oncology. The Distress Thermometer (DT) is a common screening tool, but other methods recently have been proposed, with the aim of improving its diagnostic accuracy. Objectives To investigate the diagnostic accuracy of the DT alone and combined with the Impact Thermometer (IT), via the use of two possible combination methods. Methods A heterogeneous sample of 385 adult patients with cancer completed the DT, the IT, and the Brief Symptom Inventory-18. Results The results of the DT were comparable with those found in previous studies, indicating that the DT was adequate …
Ru-Based Thin Film Temperature Sensor for Space Environments: Microfabrication and Characterization under Total Ionizing Dose
2016
The paper shows the microfabrication processes of a Ruthenium-based resistance temperature detector and its behavior in response to irradiation at ambient temperature. The radiation test was done in a public hospital facility and followed the procedures based on the ESA specification ESCC 22900. The instrumentation system used for the test is detailed in the work describing the sensors resistance evolution before, during, and after the exposure. A total irradiation dose of 43 krad with 36 krad/h dose rate was applied and a subsequent characterization was performed once the Ru sensors were submitted to an 80°C annealing process during a period of 168 h. The experimental measurements have sho…
Primary thermometry with nanoscale tunnel junctions
1995
We have found current-voltage (I-V) and conductance (dI/dV) characteristics of arrays of nanoscale tunnel junctions between normal metal electrodes to exhibit suitable features for primary thermometry. The current through a uniform array depends on the ratio of the thermal energy kBT and the electrostatic charging energy E c of the islands between the junctions and is completely blocked by Coulomb repulsion at T = 0 and at small voltages eV/2 ≤ Ec. In the opposite limit, kBT ≫ Ec, the width of the conductance minimum scales linearly and universally with T and N, the number of tunnel junctions, and qualifies as a primary thermometer. The zero bias drop in the conductance is proportional to T…