Search results for "TiO2"

Kinetics of 4-Methoxybenzyl Alcohol Oxidation in Aqueous Solution in a Fixed Bed Photocatalytic Reactor

2010

WOS: 000280384800004

Photocatalytic oxidation of trans-ferulic acid to vanillin on TiO2 and WO3-loaded TiO2 catalysts

2015

Abstract The photocatalytic oxidation of trans-ferulic acid to vanillin in water has been studied by using various TiO2 and WO3-loaded TiO2 samples as catalysts. Different values of selectivity were obtained depending on the physico-chemical properties of the single samples and a vanillin selectivity of 10% was reached in the presence of the commercial TiO2 Merck. Higher selectivity values were obtained by impregnation of TiO2 with H2WO4 followed by calcination. The increased production of vanillin exhibited by the obtained WO3-loaded TiO2 powders was attributed to a reduced further oxidation of the aldehyde caused by the presence of the practically inactive tungsten trioxide hydrate on the…

Enhancing Selectivity In Photocatalytic Formation Of P-Anisaldehyde In Aqueous Suspension Under Solar Light Irradiation Via Tio2 N-Doping

2012

The photocatalytic partial oxidation of 4-methoxybenzyl alcohol to the corresponding aldehyde (p-anisaldehyde) was performed under simulated solar irradiation by using home prepared N-doped TiO2 catalysts. The photocatalysts were prepared by a sol–gel method, using TiCl4 as TiO2 precursor and NH4Cl, urea or NH4OH as N-doping sources. A commercial TiO2 (Degussa P25) was also used for comparison aims. The prepared catalysts were characterized by BET specific surface area, XRD, ESEM and UV-vis spectroscopy. The reactivity results show that (i) the doped catalysts are predominantly amorphous, and they show selectivity values far higher than those of the corresponding undoped ones and of well cr…

New Porphyrin/Fe-Loaded TiO2 Composites as Heterogeneous Photo-Fenton Catalysts for the Efficient Degradation of 4-Nitrophenol

2013

A new class of porphyrin(Pp)/Fe co-loaded TiO2 composites opportunely prepared by impregnation of [5,10,15,20-tetra(4-tert-butylphenyl)] porphyrin (H2Pp) or Cu(II)[5,10,15,20-tetra(4-tert-butylphenyl)] porphyrin (CuPp) onto Fe-loaded TiO2 particles showed high activities by carrying out the degradation of 4-nitrophenol (4-NP) as probe reaction in aqueous suspension under heterogeneous photo-Fenton-like reactions by using UV-visible light. The combination of porphyrin-Fe-TiO2 in the presence of H2O2 showed to be more efficient than the simple bare TiO2 or Fe-TiO2.

ChemInform Abstract: Elemental Bromine Production by TiO2Photocatalysis and/or Ozonation.

2016

Significant production of elemental bromine (Br2 ) was observed for the first time when treating bromide containing solutions at acidic pH, with TiO2 photocatalyst, ozone, or a combination thereof. Br2 selectivities up to approximately 85 % were obtained and the corresponding bromine mass balance values satisfied. The process is general and may be applied at a laboratory scale for green bromination reactions, or industrially as a cheap, safe, and environmentally sustainable alternative to the currently applied bromine production methods.

TiO2-Based Photocatalysis for Organic Synthesis

2010

A major aim of the contemporary chemistry is to replace old environmentally hazardous processes with new, energy efficient routes allowing to reduce or totally avoid the use and production of harmful chemicals and to maximise the quantity of raw material that ends up in the final product. This chapter gives an account of TiO2-based selective photocatalysis as a green synthetic tool for the production of organics. Some case studies of the most common transformations carried out by means of photocatalytic reactions are illustrated in a midway perspective between photochemistry and organic chemistry.

Influence of post formation proceses on electrochemical and photoelectrochemical behaviour of TiO2 nanotubes

2011

Photocatalytic degradation of nitrophenols in aqueous titanium dioxide dispersion

1991

Abstract The results are reported of an investigation into the photodegradation of nitrophenol isomers carried out in aqueous titania (anatase) dispersions under various experimental conditions. We investigated the influence of various parameters on the photodegradation rate, such as the concentrations of the catalyst, dissolved oxygen and organic compound, and the presence of various anions in the dispersion. A plausible explanation is proposed for the influence of these parameters, both mechanistic and kinetic factors being accounted for. Gas chromatography and mass spectrometry were used as analytical methods in order to determine intermediate products. Spectroscopic methods (UV-vis and …

New Viewpoint in Exaggerated Increase of PtiO2 With Normobaric Hyperoxygenation and Reasons to Limit Oxygen Use in Neurotrauma Patients

2018

Mechanical and optical properties of as-grown and thermally annealed titanium dioxide from titanium tetrachloride and water by atomic layer deposition

2021

Funding Information: This work was carried out within the MECHALD project funded by Business Finland (Tekes) and is linked to the Finnish Centers of Excellence in Atomic Layer Deposition (ref. 251220) and Nuclear and Accelerator Based Physics (refs. 213503 and 251353) of the Academy of Finland. Funding Information: This work was carried out within the MECHALD project funded by Business Finland (Tekes) and is linked to the Finnish Centers of Excellence in Atomic Layer Deposition (ref. 251220 ) and Nuclear and Accelerator Based Physics (refs. 213503 and 251353 ) of the Academy of Finland. Publisher Copyright: © 2021 The use of thin-films made by atomic layer deposition (ALD) is increasing in …