Search results for "Toe"
showing 10 items of 3824 documents
Circular dichroism in X-ray photoemission from Pd(111) and CO/Pd(111)
1995
It is shown experimentally that in the soft X-ray region a large circular dichroism in the photoelectron angular distribution (CDAD) exists for both valence orbitals and core levels of CO molecules adsorbed on Pd(111). From theoretical consideration it follows that in the case of a spherically symmetric ground state wave function, like the 1σ and 2σ orbitals of CO, CDAD appears due to the lack of spherical symmetry in the final state. For carbonK-shell experimental results are compared to model calculations. Investigations at the Pd core levels proved that CDAD does also arise in X-ray photo-emission from non-magnetic crystals.
Density-Functional Calculations of Auger and X-Ray Photoemission Shifts for Metallic Elements
1982
ΔSCF density-functional calculations are reported for Auger, and core level binding energy shifts in sp-bonded metals. The basic model, atom-in-jellium-vacancy, gives good agreement with experiment, especially in the Auger case. The chemical and relaxation contributions to the shifts are discussed. The shifts are calculated also by using the thermochemical model and the results obtained are in agreement with experimental data. The applicability of the "excited-atom" approach to the Auger energy shifts is found restricted.
Photon Energy Dependent Hard X-ray Photoemission Spectroscopy of YbCu2Si2
2012
We have performed photon energy ( h ν) dependent hard X-ray photoemission spectroscopy (HAXPES) for YbCu 2 Si 2 , which is a heavy Fermion compound with intermediate Yb valence. We identified that the bulk components in the Si 1 s and Yb 3 d spectra develop with increasing h ν from 2.5 to 6 keV. Moreover, the temperature dependence of the Yb 3 d spectra measured at h ν= 8 keV has shown a valence fluctuation behavior. These results suggest that high h ν HAXPES is essential to determine the mean valence of the Yb compounds.
Electronic and magnetic properties of Mn 12 molecular magnets on sulfonate and carboxylic acid prefunctionalized gold surfaces
2012
Structural, electronic, and magnetic properties of [Mn 12O 12(bet) 16(EtOH) 4](PF 6) 14·4CH 3CN·H 2O (in short Mn 12bet, bet = betaine = +N(CH 3) 3-CH 2-COO -) single-molecule magnets (SMMs) deposited on previously functionalized gold surfaces have been investigated. Self-assembled monolayers (SAMs) either of sodium mercaptoethanesulfonate (MES) or mercaptopropionic acid (MPA) are used as functionalization to avoid the direct interaction between the Mn 12bet molecules and the Au surface with the aim of preserving the main functional properties of the molecules. Scanning tunneling microscopy (STM) and X-ray photoemission spectroscopy (XPS) analysis show deposited Mn 12bet SMMs well-isolated …
Interfacial reaction between deposited molybdenum and TiO2(110) surface: role of the substrate bulk stoichiometry
2004
Abstract The interfacial reaction between deposited molybdenum and three different TiO2(1 1 0) substrates (a bulk and surface stoichiometric TiO2; a bulk stoichiometric and surface reduced crystal; a bulk and surface slightly reduced crystal) was investigated by means of X-ray photoelectron spectroscopy (XPS) and X-ray absorption near edge spectroscopy (XANES). While the interfacial reaction is not a function of the substrate at room temperature (in any case, molybdenum layers grow with oxygen dissolved in), this study clearly reveals a strong effect of the substrate bulk stoichiometry on the chemical state of the deposit after annealing up to 750 °C whereas the substrate surface stoichiome…
Study of the structural phase transformation of iron oxide nanoparticles from an Fe2+ ion source by precipitation under various synthesis parameters …
2015
Abstract Magnetite nanoparticles were precipitated from a pure aqueous ferrous salt solution in an air atmosphere. The influence of the solution molarity, the rate of precipitator agent addition, stirring time and annealing temperature was studied. The morphology, crystalline phase purity and magnetic properties of the obtained powders were studied by X-Ray powder diffraction (XRD), Scanning electron microscopy (SEM), Differential thermal analysis (DTA), X-ray photoelectron spectroscopy (XPS), X-ray absorption spectroscopy (XAS) and Vibrating sample magnetometer (VSM). The synthesis conditions were seen to have an effect on phase composition. It was possible to obtain near stoichiometric Fe…
Co doped ZnO nanowires as visible light photocatalysts
2016
Abstract High aspect ratio cobalt doped ZnO nanowires showing strong photocatalytic activity and moderate ferromagnetic behaviour were successfully synthesized using a solvothermal method and characterized by scanning electron microscopy (SEM), X-ray powder diffraction (XRD), X-ray photoelectron spectroscopy (XPS), X-ray absorption spectroscopy (XAS), vibrating sample magnetometry (VSM) and UV–visible absorption spectroscopy. The photocatalytic activities evaluated for visible light driven degradation of an aqueous methylene orange (MO) solution were higher than for Co doped ZnO nanoparticles at the same doping level and synthesized by the same synthesis route. The rate constant for MO visi…
Support effects on NiO-based catalysts for the oxidative dehydrogenation (ODH) of ethane
2019
[EN] We report on the effect of NiO-support interactions on the chemical nature of Ni species in a series of supported NiO catalysts for the ODH of ethane. SiO2, TiO2-anatase, a high surface area TiO2 and a porous clay hetero-structure (PCH) with TiO2 and SiO2 pillars were used as supports, which led to a selectivity to ethylene in the range 30-90% over supported NiO catalysts. The catalysts were characterized by means of XRD, N-2-Adsorption, H-2-TPR, XPS and in situ (under H-2 reductive atmosphere) and ex situ XAS spectroscopy. The catalytic performance of supported materials is discussed in terms of their reducibility and specific reduction kinetics, but also taking into account the speci…
Chemical microimaging and microspectroscopy of surfaces with a photoemission microscope
1997
We applied element sensitive photoemission electron microscopy (PEEM) to investigate surfaces of devices built from complex materials. Conventional PEEM suffers from lack of information about the chemical composition of the imaged surface. Such information can be obtained by PEEM via tuning the photon energy to X-ray absorption edges. To apply spectromicroscopy we acquired and subtracted microscopic images using photon energies just below and at the edges. The resulting difference gives a micro-image of the lateral distribution of a specific element. Microspectroscopy is performed by recording the intensity of secondary electrons in selected spots during a sweep of the photon energy. We app…
The lateral variation of solid state reactions at surfaces studied by means of photoemission electron microscopy: formation of titanium silicides
2001
The alloying and oxygen reduction at titanium silicon interfaces were studied by means of photoemission microscopy. The microscopic chemical composition of the sample surface was characterised by means of imaging X-ray absorption. The silicide formation was studied at clean and oxidised silicon substrates both covered with micron-sized titanium patterns.