Search results for "Trial"

Adaptive Fuzzy Super-Twisting Sliding Mode Control for Microgyroscope

2019

This paper proposes a novel adaptive fuzzy super-twisting sliding mode control scheme for microgyroscopes with unknown model uncertainties and external disturbances. Firstly, an adaptive algorithm is used to estimate the unknown parameters and angular velocity of microgyroscopes. Secondly, in order to improve the performance of the system and the superiority of the super-twisting algorithm, this paper utilizes the universal approximation characteristic of the fuzzy system to approach the gain of the super-twisting sliding mode controller and identify the gain of the controller online, realizing the adaptive adjustment of the controller parameters. Simulation results verify the superiority a…

Multi-band identification for enhancing bearing fault detection in variable speed conditions

2020

Abstract Rolling element bearings are crucial components in rotating machinery, and avoiding unexpected breakdowns using fault detection methods is an increased demand in industry today. Variable speed conditions render a challenge for vibration-based fault diagnosis due to the non-stationary impact frequency. Computed order tracking transforms the vibration signal from time domain to the shaft-angle domain, allowing order analysis with the envelope spectrum. To enhance fault detection, the bearing resonance frequency region is isolated in the raw signal prior to order tracking. Identification of this region is not trivial but may be estimated using kurtosis-based methods reported in the li…

An intelligent Proportional controller of a Seeded Batch Crystallizer

2020

Crystallization process is used in a very wide range of industrial applications. However, highly nonlinear comportment of such process and the difficulties of characterizing several phenomenological effects makes difficult to find suitable operational procedures for producing required products. In this article, we use a model-free control (MFC) for controlling the mean size of crystals produced by seeded batch cooling crystallization. The MFC method is distinguished notably in terms of the modeling strategy. Rather than developing a crystallization model within the classic population balance equation (PBE) together with the mass balance and the energy balance, as is usually done, we use a l…

Strategic Thinking under social influence: Scalability, stability and robustness of allocations

2016

This paper studies the strategic behavior of a large number of game designers and studies the scalability, stability and robustness of their allocations in a large number of homogeneous coalitional games with transferable utilities (TU). For each TU game, the characteristic function is a continuous-time stochastic process. In each game, a game designer allocates revenues based on the extra reward that a coalition has received up to the current time and the extra reward that the same coalition has received in the other games. The approach is based on the theory of mean-field games with heterogeneous groups in a multi-population regime.

Time-varying Sampled-data Observer with Asynchronous Measurements

2019

International audience; In this paper a time-varying observer for a linear continuous-time plant with asynchronous sampled measurements is proposed. The observer is contextualized in the hybrid systems framework providing an elegant setting for the proposed solution. In particular some theoretical tools are provided, in terms of LMIs, certifying asymptotic stability of a certain compact set where the estimation error is zero. We consider sampled asynchronous measurements that occur at arbitrary times in a certain window with an upper and lower bound. The design procedure, that we propose for the selection of the time-varying gain, is based on a constructive algorithm that is guaranteed to f…

Analysis of Linear Feedback Position Control in Presence of Presliding Friction

2016

Improved Active Disturbance Rejection Control for Trajectory Tracking Control of Lower Limb Robotic Rehabilitation Exoskeleton.

2020

Neurological disorders such as cerebral paralysis, spinal cord injuries[acronym](SCI), and strokes, result in the impairment of motor control and induce functional difficulties to human beings like walking, standing, etc. Physical injuries due to accidents and muscular weaknesses caused by aging [english]affectsaffect people and can cause them to lose their ability to perform daily routine functions. In order to help people recover or improve their dysfunctional activities and quality of life after accidents or strokes, assistive devices like exoskeletons and orthoses are developed. Control strategies for control of exoskeletons are developed with the desired intention of improving the qual…

Estimation of Sway-angle Based on Hybrid State Observer Using Continuous and Discrete Sensing

2019

A hybrid state observer design is presented herein to estimate sway-angle and angular velocity in trolley systems with pendulum. In general, anti-sway control for trolley systems with pendulum such as overhead cranes are designed based on sway-angle signals detected by angular sensors. Opposed to that, a state observer without those sensors is proposed to estimate the sway-angle of the pendulum. A standard linear continuous feedback observer causes estimation error owing to the system nonlinearity and modeling error. This paper proposes a hybrid state observer incorporating discrete sensor signals. In the hybrid state observer, the estimation performance is improved by correcting the state …

Calibration of mobile manipulators using 2D positional features.

2018

International audience; Robotic manipulators are increasingly being attached to Automatic Ground Vehicles (AGVs) to aid in the efficiency of assembly for manufacturing systems. However, calibrating these mobile manipulators is difficult as the offset between the robotic manipulator and the AGV is often unknown. This paper provides a novel, simple, and low-cost method for calibrating and measuring the performance of mobile manipulators by using data collected from a laser retroreflector that digitally detects the horizontal two-dimensional (2D) position of reflectors on an artifact as well as a navigation system that provides the heading angle and 2D position of the AGV. The method is mathem…

When Is an Affordance? Outlining Four Stances

2016

Part 3: Exploring Affect and Affordance; International audience; Affordance has emerged as a core concept in information systems (IS) research during the last decade. This relational concept is applied to understand and theorize the relationship between the social and the technical. In the works of the concept originator James Gibson, the relation was mainly portrayed as an ever-existing fact between the natural environment and an animal. In contrast, IS research focuses on relationships in-the-making between artificial things and human beings. In the IS context, we have identified vagueness in temporal and relational ontology: when do affordances exist and between whom or what? In this pap…