Search results for "Upgrade"
showing 10 items of 116 documents
Design and status of COMPASS FAST-RICH
2006
In the context of the upgrade of COMPASS RICH-1, we are developing a fast photodetection system for RICH counters, based on UV extended Multi-Anode PhotoMultiplier Tubes (MAPMT) and a custom, low dead-time electronic readout system. Photons are concentrated on the MAPMT photocathode by an optical system that preserves the position information. The ratio between the collection and the photosensitive surfaces is ∼7.5 in our design, larger than in previous applications. A new front-end electronics, based on a modified version of the MAD4 discriminator chip, is being realized to digitize the MAPMT signals. We report about the design of the photodetection system and of the associated electronic …
Fast photon detection for COMPASS RICH-1
2007
A fast photon detection system has been built and assembled for the upgrade of COMPASS RICH-1. The system is based on multianode photomultipliers coupled to fused silica lenses to collect the light from a larger surface and to guide it to the photocathode, preserving the position information. The emphasis is on the fast response and high rate capability of the detectors and the associated electronics. The photon detection system is now ready and it will be employed in the 2006 COMPASS data taking. We report about the system design and construction.
High brilliance uranium beams for the GSI FAIR
2017
The 40 years old GSI-UNILAC (Universal Linear Accelerator) as well as the heavy ion synchrotron SIS18 will serve as a high current heavy ion injector for the new FAIR (Facility for Antiproton and Ion Research) synchrotron SIS100. In the context of an advanced machine investigation program in combination with the ongoing UNILAC upgrade program, a new uranium beam intensity record (11.5 emA, ${\mathrm{U}}^{29+}$) at very high beam brilliance was achieved recently in a machine experiment campaign. This is an important step paving the way to fulfill the FAIR heavy ion high intensity beam requirements. Results of high current uranium beam measurements applying a newly developed pulsed hydrogen g…
Recent results from AMANDA II
2003
Abstract We present new data taken with the AMANDA-II neutrino telescope array. The AMANDA-II upgrade was completed at the beginning of 2000. It significantly extends the sensitivity of the 10-string AMANDA-B10 detector to high- and ultrahigh-energy neutrino fluxes into regions of interest for probing current astrophysical models which remain unexplored by other experiments.
Point-to-point readout for the ALICE EMCal detector
2014
Abstract It is anticipated that the LHC will deliver Pb+Pb collisions at a minimum bias interaction rate of about 50 kHz after the second long shutdown of the LHC in 2018. This will be roughly two orders of magnitude greater than the current data recording rate capability of the ALICE experiment. Therefore a major upgrade of the ALICE detector is planned for the next shutdown to enable ALICE to record data at the full Pb+Pb minimum bias interaction rate delivered by the LHC. A new point-to-point readout system for the electromagnetic calorimeter (EMCal) of ALICE has been developed, to replace the legacy readout bus, that essentially accomplishes this goal, and is being installed during the …
Applications of the pulsed gas stripper technique at the GSI UNILAC
2017
Abstract In the frame of an upgrade program for the GSI UNILAC, preparing it for the use as an injector system for FAIR, a pulsed gas stripper cell was developed. It utilizes the required low duty cycle by applying a pulsed gas injection instead of a continuous gas inlet. The resulting lower gas consumption rate enables the use of low-Z gas targets over a wide range of stripper target thicknesses. The setup enables an increased flexibility for the accelerator by allowing the gas stripper to be used in time-sharing beam operation matching the capabilities of the GSI UNILAC like the acceleration of different ion beams in quasi-parallel operation. Measured charge state distributions of 238 U, …
Structure and dynamics of sawteeth crashes in ASDEX Upgrade
2010
The crash phase of the sawteeth in ASDEX Upgrade tokamak [Herrmann et al., Fusion Sci. Technol. 44(3), 569 (2003)] is investigated in detail in this paper by means of soft x-ray (SXR) and electron cyclotron emission (ECE) diagnostics. Analysis of precursor and postcursor (1,1) modes shows that the crash does not affect the position of the resonant surface q=1. Our experimental results suggest that sawtooth crash models should contain two ingredients to be consistent with experimental observations: (1) the (1,1) mode structure should survive the crash and (2) the flux changes should be small to preserve the position of the q=1 surface close to its original location. Detailed structure of the…
The Mainz Microtron MAMI
2008
An overview of the Mainz Microtron MAMI is given. The main goal is to study the low-energy structure of hadrons. Typical examples are measurements of nucleon form factors, the polarizability of nucleons and pions and the detailed study of the excitation spectrum of nucleons. At present, an energy upgrade to 1.5 GeV (MAMI C) is close to completion. The status of the new accelerator section (HDSM) and experimental setups are briefly described and an outlook to the planned physics program is given.
Design and Calculations for the New ECRIS at KVI
2005
In this paper a brief description is given of the on‐going upgrade of the CAPRICE‐type ECRIS injector of the K=600 AGOR cyclotron at KVI. This upgrade is motivated by the new TRIμP program, which requires a significant increase of available beam intensity by up to two orders in magnitude. The upgrade follows the AECR design of the university of Jyvaskyla, which was originally pioneered at LBNL (USA). We will discuss the mechanical design and magnetic field calculations of the solenoidal and the permanent magnetic hexapole fields.
Topological and Central Trigger Processor for 2014 LHC luminosities
2012
The ATLAS experiment is located at the European Center for Nuclear Research (CERN) in Switzerland. It is designed to observe phenomena that involve highly massive particles produced in the collisions at the Large Hadron Collider (LHC): the world’s largest and highest-energy particle accelerator. Event triggering and Data Acquisition is one of the extraordinary challenges faced by the detectors at the high luminosity LHC collider. During 2011, the LHC reached instantaneous luminosities of 4 10^33 cm−1 s−1 and produced events with up to 24 interactions per colliding proton bunch. This places stringent operational and physical requirements on the ATLAS Trigger in order to reduce the 40MHz coll…