Search results for "Verters"
showing 10 items of 163 documents
MuPix10: First Results from the Final Design
2021
Many years of research and development of High Voltage Monolithic Active Pixel Sensors (HVMAPS) have culminated in the final design for the Mu3e pixel sensor. MuPix10 is a fully monolithic sensor with an active pixel matrix size of $20\times20\,\mathrm{mm}^2$ produced in the $180\,\mathrm{nm}$ HV-CMOS process at TSI Semiconductors. The pixel size is $80\times80\,\mathrm{\mu m}^2$. Hits are read out using a column-drain architecture and sent over up to four serial links with up to $1.6\,\left.\mathrm{Gbit}\middle/\mathrm{s}\right.$ each. By means of DC/DC converters and exclusive usage of on-chip biasing, MuPix10 is fully operable with a minimal set of electrical connections. This is an inte…
A Temperature Dependent Non-Linear Inductor Model for a DC/DC Boost Converter
2018
This paper is focused on the use of non-linear inductors in DC/DC switching converters, as well as their behaviour due to changes in current and temperature. The model of an inductor is set up on the basis of experimental data, which are automatically acquired by a virtual instrument; from those data, a polynomial curve describing the inductance variations is obtained. The analysis of the converter, performed by including the proposed model, is validated by experimental tests.
Innovative Computational Approach to Harmonic Mitigation for Seven-level Cascaded H-Bridge Inverters
2020
Low frequency modulation strategies are a good solution to increase the energy conversion efficiency in high power applications. The paper is devoted to presents an innovative way to low order harmonics mitigation for seven-level Cascaded H-Bridge Inverters. In particular, this approach is based on the mitigation of selected harmonics without solve non-linear equations for an extended range of the fundamental amplitude. In fact, in real-Time operation to evaluate the control angles the polynomial equations have been identified. Through circuit simulation analysis in MatLab/PLECS environment, the effectiveness of the harmonic mitigation method has been tested and compared with theoretical re…
Power Quality Savings with Controlled Fault-Tolerant Power Converters
2011
Power quality is simply the interaction of electrical power with electrical equipments. If electrical equipments operate correctly and reliably without being damaged or stressed, a suitable level of power quality is assured. On the other hand, if the electrical equipment malfunctions, is unreliable, or is damaged during normal usage, power quality is poor and probably the economical loss could be preeminent over the technical one. In the scenario of the Distributed generation power quality issues will be more- over important because an higher dissemination of power conditioning equip- ment will be requested and this obviously will increase the sources of vulnera- bility for the electrical s…
Achieving maximum power transfer in a multi-source renewable system
2014
A General Mathematical Model for the Simulation of Common Faults in Three‐ phase Voltage Source Inverters
2013
In the last years the fault problem in power electronics has been more and more investigated both from theoretical and practical point of view. This paper analyzes the problem of faults modeling in a three phase voltage source inverter(VSI) and presents a model of a VSI able to simulate both unfaulty and faulty conditions when one or more devices go broken. In the past the fault problem was faced step by step considering the fault on each single device building a model for each case. The model hereafter presented solves this drawback through the introduction of the concept of the Healthy Device Binary Variable (HDBV) and the more general Healthy Leg Binary Variable (HLBV) showing also as th…
Performance Comparison of modified modulation Techniques for Quasi-Z-Source Converters
2020
The single-stage converters represent an innovation in the field of power electronics thanks their features. Aim of this work consists in the improvement of the performances of quasi-Z-Source converters by adopting a modified modulation technique, which is based on the Maximum Constant Boost Control (MCBC) and Switching Frequency Optimal (SFO). The results in terms of voltage stress and harmonic content are compared with those obtained with conventional techniques, demonstrating the effectiveness of the proposed modulation scheme.
Innovative systems based on optical nanoantennas for energy harvesting application
The purpose of this study is to outline the main guidelines for the design of arrays of optical rectennas aiming to harvest energy and for the optimization of the power transfer to an external load. In particular, the novelty of this study consists in introducing the concept of the integrated design between the array of optical rectennas and the harvesting circuit able to exploit the available energy. The design of the array represents the crucial point in order to optimize the power transfer between the antenna and the load and can influence the rectenna design. On the other hand, the maximum power transfer to the load has to be obtained under matching conditions between the array and the …
A Constrained Optimal Model Predictive Control for Mono Inverter Dual Parallel PMSM Drives
2018
The actual trends in the design of AC drives are directed to the reduction of the total weight, volume and cost. Usually, this implies the necessity to adopt new motor topologies and converter architectures. An important role is played by the mono-inverter dual parallel motor (MIDP), which gives the possibility to reduce the total weight and costs of power converters. This paper proposes a novel model predictive control algorithm in order to improve the transient performances of a MIDP used for an overhead carrier. The effectiveness of the proposal control is verified through some numerical simulations.
Challenges for the Goal of 100% Renewable Energy Sources to Fit the Green Transition
2022
The increasing penetration of Renewable Energy (RE) into the electrical market is desirable in terms of sustainability. Nevertheless, it is a challenge that all the interested actors shall address from both the technical and economical points of view. This paper provides an overview of the main challenges and solutions towards the technological transition to an electrical system with 100% renewable energy sources in terms of innovations and operative limits of the traditional systems. These innovative paradigms will also address the social impact and government policies.