Search results for "WASTEWATER"
showing 10 items of 718 documents
Modeling light and temperature influence on ammonium removal by Scenedesmus sp. under outdoor conditions.
2016
[EN] The ammonium removal rate of the microalga Scenedesmus sp. was studied under outdoor conditions. Microalgae were grown in a 500 L flat-plate photobioreactor and fed with the effluent of a submerged anaerobic membrane bioreactor. Temperature ranged between 9.5 WC and 32.5 WC and maximum light intensity was 1,860 μmol·m2·s1. A maximum specific ammonium removal rate of 3.71 mg NH4 þ-N·g TSS1·h1 was measured (at 22.6 WC and with a light intensity of 1,734 μmol·m2·s1). A mathematical model considering the influence of ammonium concentration, light and temperature was validated. The model successfully reproduced the observed values of ammonium removal rate obtained and it is thus p…
A pilot-scale study of struvite precipitation in a stirred tank reactor: Conditions influencing the process
2008
Currently, the two most developed techniques for recovering phosphorus from wastewater consist of the formation of calcium phosphates and struvite (MgNH(4)PO(4).6H(2)O). In this work the influence of the operational conditions on the struvite precipitation process (pH in the reactor, hydraulic retention time, and magnesium:phosphorus, nitrogen:phosphorus, and calcium:magnesium molar ratios) have been studied. Twenty-three experiments with artificial wastewater were performed in a stirred reactor. In order to obtain the pH value maintenance during the crystallization process, a fuzzy logic control has been developed. High phosphorus removal efficiencies were reliably achieved precipitating t…
Performances of a granular sequencing batch reactor (GSBR).
2007
Aerobic granulation in sequencing batch reactors is widely reported in literature and in particular in SBAR (Sequencing batch airlift reactor) configuration, due to the high localised hydrodynamic shear forces that occur in this type of configuration. The aim of this work was to observe the phenomenon of the aerobic granulation and to confirm the excellent removal efficiencies that can be achieved with this technology. In order to do that, a laboratory-scale plant, inoculated with activated sludge collected from a conventional WWTP, was operated for 64 days: 42 days as a SBAR and 22 days as a SBBC (sequencing batch bubble column). The performances of the pilot plant showed excellent organic…
Wastewater treatment and reclamation : A review of pulp and paper industry practices and opportunities
2016
The pulp and paper (P&P) industry worldwide has achieved substantial progress in treating both process water and wastewater, thus limiting the discharge of pollutants to receiving waters. This review covers a variety of wastewater treatment methods, which provide P&P companies with cost-effective ways to limit the release of biological or chemical oxygen demand, toxicity, solids, color, and other indicators of pollutant load. Conventional wastewater treatment systems, often comprising primary clarification followed by activated sludge processes, have been widely implemented in the P&P industry. Higher levels of pollutant removal can be achieved by supplementary treatments, which…
Sequential biological and photocatalysis based treatments for shipboard slop purification: A pilot plant investigation
2019
This study investigated the treatment of a shipboard slop containing commercial gasoline in a pilot plant scale consisting of a membrane biological reactor (MBR) and photocatalytic reactor (PCR) acting in series. The MBR contributed for approximately 70% to the overall slop purification. More precisely, the biological process was able to remove approximately 40%, on average, of the organic pollution in the slop. Nevertheless, the membrane was capable to retain a large amount of organic molecules within the system, amounting for a further 30% of the influent total organic content removal. However, this affected the membrane fouling, thus resulting in the increase of the pore blocking mechani…
Metal ion adsorption by phomopsis sp. Biomaterial in laboratory experiments and real Wastewater Treatments
2005
An insoluble material of polysaccharidic nature has been obtained by thermal alkali treatment of the filamentous fungus Phomopsis sp. FT-IR spectrum of the resulting material as well as its nitrogen content suggest that chitosan and glucans are the main components of the biomaterial. Information on Lewis base sites has also been obtained and used as a guideline in the evaluation of the complexing ability against a number of metal ions in aqueous media at pH in the range 4--6. Results indicate that after 24h contact time, up to 870 micromol/g of lead, 390 micromol/g of copper, 230 micromol/g of cadmium, 150 micromol/g of zinc and 110 micromol/g of nickel ions are adsorbed into the material. …
Analysis of pharmaceutical biodegradation of WWTP sludge using composting and identification of certain microorganisms involved in the process.
2018
Pharmaceuticals (PhCs) are organic contaminants that have been detected in wastewater, surface water, and soils throughout the world. The presence of 10 commonly used PhCs in Spain (azithromycin, benzylpenicillin, citalopram, fluconazole, fluoxetine, ibuprofen, irbesartan, olanzapine, telmisartan, and venlafaxine) was analysed at four wastewater treatment plants, and the changes in their concentrations during treatment were assessed. Although certain some PhCs were degraded in the treated water, their presence in sewage sludge increased in all cases. The sewage sludge was composted using rice straw to degrade the PhCs, and the composting efficiency was modified by changes in the relative C/…
Aerobic granular sludge treating anaerobically pretreated brewery wastewater at different loading rates.
2020
Abstract In this study, three different aerobic granular sludge (AGS) reactors fed with anaerobically pre-treated brewery wastewater were studied. The AGS reactors were operated under different conditions including organic loading rates (OLR) between 0.8 and 4.1 kg COD m−3 d−1, C:N:P ratios (100:10:1 and 100:6:1) and food to microorganism ratios (F/M) between 0.8 ± 0.6 and 1.2 ± 0.5 and 0.9 ± 0.3 kg-TCOD kg-VSS−1d−1. Stable granulation was achieved within two weeks and the size of the granules increased according to the OLR applied. The results indicated that low C:N:P and F/M ratios were favorable to achieve stable aerobic granules in the long term. The carbon removal rate was load-indepen…
Microalgae-bacteria consortia in high-rate ponds for treating urban wastewater: Elucidating the key state indicators under dynamic conditions
2020
[EN] On-line performance indicators of a microalgae-bacteria consortium were screened out from different variables based on pH and dissolved oxygen on-line measurements via multivariate projection analysis, aiming at finding on-line key state indicators to easily monitor the process. To fulfil this objective, a pilot-scale high-rate pond for urban wastewater treatment was evaluated under highly variable conditions, i.e. during the start-up period. The system was started-up without seed of either bacterial or microalgal biomass. It took around 19 days to fully develop a microalgal community assimilating nutrients significantly. Slight increases in the biomass productivities in days 26-30 sug…
Efficiency of wastewater treatment facilities: The influence of scale economies.
2018
The water cycle, from catchment to discharge, is a sector that involves an important investment and operation and maintenance costs. In particular, sewage treatment is a challenge for governments because they are having to consider economic, environmental, and social aspects. Within the European Union, implementation of Directive 91/271/EEC is responsible for the location of wastewater treatment facilities in the territory, due to the requirement that all urban areas must have this infrastructure to reduce the environmental impact of treated water in water bodies. Different sizes of municipalities affect the design of each wastewater treatment plant (WWTP) and cause variations in the operat…