Search results for "Waveform"
showing 10 items of 131 documents
PPG/ECG Multisite Combo System Based on SiPM Technology
2019
Two versions of a PPG/ECG combined system have been realized and tested. In a first version a multisite system has been equipped by integrating 3 PPG optodes and 3 ECG leads, whereas in another setup a portable version has been carried out. Both versions have been realized by equipping the optical probes with SiPM detectors. SiPM technology is expected to bring relevant advantages in PPG systems and overcome the limitations of physiological information extracted by state of the art PPG, such as poor sensitivity of detectors used for backscattered light detection and motion artifacts seriously affecting the measurements repeatability and pulse waveform stability. This contribution presents t…
Phase error analysis of clipped waveforms in surface topography measurement using projected fringes
2021
Abstract When working with the method of projected fringes outside the optical laboratory one often encounters the problem of uncontrollable ambient light. This might cause saturation of the camera which in turn results in clipping of the fringes. Since standard theories describing phase-shifting techniques assume the projected fringes to be purely sinusoidal, such clipping will result in measurement error. In this paper a detailed analysis of this problem is given, and relations between phase errors, the amount of fringe clipping and the number of phase steps are found. Moreover, the phase difference between the clipped and the unclipped fringes is described. This investigation is based on…
Subharmonic phase-lock criteria for a class of weakly non-linear high-order oscillators
1985
Subharmonic frequency entrainment of high-order weakly non-linear oscillators is investigated. For the class of circuits considered, equations are first derived which provide the first approximation values for the amplitudes and phases of the two main spectral components of the steady-state waveform. Necessary and sufficient stability criteria are then derived in explicit from. The example worked out (a negative conductance double-tuned oscillator) shows the efficiency and ease of use of the proposed method.
2019
Abstract In high sensitivity inductive electron spin resonance spectroscopy, superconducting microwave resonators with large quality factors are employed. While they enhance the sensitivity, they also distort considerably the shape of the applied rectangular microwave control pulses, which limits the degree of control over the spin ensemble. Here, we employ shaped microwave pulses compensating the signal distortion to drive the spins faster than the resonator bandwidth. This translates into a shorter echo, with enhanced signal-to-noise ratio. The shaped pulses are also useful to minimize the dead-time of our spectrometer, which allows to reduce the wait time between successive drive pulses.
A reexamination of voltage distortion for classical carrier-based vs B-Spline modulation of three-phase Voltage Sources Inverters
2015
Voltage waveform improvement has been the object of several investigations for many years and a manifold of different solutions have been proposed to reduce the harmonic content in Voltage Source Inverters (VSI) power application. In many cases this improvements have been obtained by modifying the reference voltage modulating signal. The recent introduction of cardinal B-spline functions, used as carrier signals, has given rise to a new modulation technique whose main characteristic is a lower value of the Total Harmonic Distortion (THD). After the discussion on the B-Spline modulation principle and on its computational effort, a performance comparisons is carried out by means of Total Harm…
Surveying in the Valley of the Temples
2014
Full-waveform terrestrial laser scanning enables high-precision 3D topographic modelling of unstable rock valleys that is valuable for various geomorphological investigations. The area below the archaeological site of Temple of Juno in Agrigento, Sicily, is characterised by the presence of large sections of rock that have fallen down from the upper ridge. In this context, full-waveform laser scanning technology was tested for the production of a highly detailed 3D topographic model at two resolutions (2cm and 20cm) for simulating potential rockfall paths at the site.
A linear generator for a waveroller power device
2017
In this paper experimental tests on a small scale tubular linear generator to be applied to wave rollers device are presented. A reduced scale of gnerator is presented and experimental results obtained in on test bench are shown. Experimental waveforms of current and voltage are recorded. Simulation results are compared to the experimental ones in order to validate the mathematical models used.
Mixed Harmonic Elimination Control for a Single-Phase 9 Level Grid-Connected Inverter
2018
The power quality requirements are increasingly stringent, due to the continuous growth of devices connected to the grid that introduce harmonics. These devices include DC to AC energy conversion systems, i.e. grid connected inverters. The design, control and operation of these systems must take into account the rules of interconnection to the electricity grid. To improve the quality of the output waveform of the grid-connected inverter, Multilevel Converters (MC) with selective harmonic elimination modulation technique can be used. This paper presents a single-phase nine level grid-connected inverter with DC/DC input stages. The obtained switching angles for THD minimization are independen…
Full-Waveform Terrestrial Laser Scanning for Extracting a High-Resolution 3D Topographic Model: a Case Study on an Area of Archaeological Significance
2014
AbstractThis paper describes a method, which uses full-waveform terrestrial laser scanning to survey the surface of the slope below the Temple of Juno, located in the Valley of the Temples in Agrigento (Sicily, Southern Italy). The surface is characterized by the presence of large rock blocks, which have fallen down from the upper side; possible further detachments of rock blocks would cause a situation of general instability, with a very high risk to the archaeological structures in the near future. The methodology was designed to evaluate the potential of full-waveform laser scanning technology for the production of a very high resolution 3D topographic model of the slope, to be used as a…
Detection of Incipient Bearing Fault in a Slowly Rotating Machine Using Spline Wavelet Packets
2018
This chapter describes a successful application of spline-based wavelet packet transforms (WPTs) described in Chap. 4 to a complicated problem of detection of incipient defects in rolling element bearings by the analysis of recorded vibration signals. The methodology presented in this chapter is applied to the analysis of vibration data recorded from large bearings working in real unfavorable operation conditions in presence of strong noise and vibrations from multiple internal and external sources. It relies on properties of discrete spline-based wavelet packets such as orthogonality, near-rectangular spectra, transient oscillating shapes of testing waveforms and fast implementation of tra…