Search results for "X-ray photoelectron spectroscopy"
showing 10 items of 416 documents
Structure and the metal-support interaction of the Au/Mn oxide catalysts
2010
Gold catalysts with loading 1 and 10 wt % were-prepared by deposition precipitation method with urea over mesoporous manganese oxide, obtained through a surfactant-assisted procedure by using cetyltrimethylammonium bromide (CTAB), followed by treatment with sulphuric acid. For comparison, Au(10 wt %) was also deposited over commercial CeO2 and SiO2 supports. The materials were characterized by XRD and EXAFS at the Mn K and Au L-III edges and XPS. Moreover, the analyses were performed on the samples treated under 1%CO/He, at 250 degrees C for 90 min. The structural and surface results of the as prepared manganese oxide confirmed the formation of gamma-MnO2 along with some amorphous Mn3O4 upo…
Influence of Nitrogen Doping on Device Operation for TiO 2 -Based Solid-State Dye-Sensitized Solar Cells: Photo-Physics from Materials to Devices
2016
International audience; Solid-state dye-sensitized solar cells (ssDSSC) constitute a major approach to photovoltaic energy conversion with efficiencies over 8% reported thanks to the rational design of efficient porous metal oxide electrodes, organic chromophores, and hole transporters. Among the various strategies used to push the performance ahead, doping of the nanocrystalline titanium dioxide (TiO 2) electrode is regularly proposed to extend the photo-activity of the materials into the visible range. However, although various beneficial effects for device performance have been observed in the literature, they remain strongly dependent on the method used for the production of the metal o…
Polystyrene as Graphene Film and 3D Graphene Sponge Precursor
2019
[EN] Polystyrene as a thin film on arbitrary substrates or pellets form defective graphene/graphitic films or powders that can be dispersed in water and organic solvents. The materials were characterized by visible absorption, Raman and X-ray photoelectron spectroscopy, electron and atomic force microscopy, and electrochemistry. Raman spectra of these materials showed the presence of the expected 2D, G, and D peaks at 2750, 1590, and 1350 cm(-1), respectively. The relative intensity of the G versus the D peak was taken as a quantitative indicator of the density of defects in the G layer.
Layer-by-Layer Graphene Growth on β-SiC/Si(001)
2019
ACS nano 13(1), 526 - 535 (2019). doi:10.1021/acsnano.8b07237
The co-reactant role during plasma enhanced atomic layer deposition of palladium
2020
Atomic layer deposition (ALD) of noble metals is an attractive technology potentially applied in nanoelectronics and catalysis. Unlike the combustion-like mechanism shown by other noble metal ALD processes, the main palladium (Pd) ALD process using palladium(ii)hexafluoroacetylacetonate [Pd(hfac)2] as precursor is based on true reducing surface chemistry. In this work, a thorough investigation of plasma-enhanced Pd ALD is carried out by employing this precursor with different plasmas (H2*, NH3*, O2*) and plasma sequences (H2* + O2*, O2* + H2*) as co-reactants at varying temperatures, providing insights in the co-reactant and temperature dependence of the Pd growth per cycle (GPC). At all te…
Electronic Structure Changes across the Metamagnetic Transition in FeRh via Hard X-Ray Photoemission
2012
International audience; Stoichiometric FeRh undergoes a temperature-induced antiferromagnetic (AFM) to ferromagnetic (FM) transition at similar to 350 K. In this Letter, changes in the electronic structure accompanying this transition are investigated in epitaxial FeRh thin films via bulk-sensitive valence-band and core-level hard x-ray photoelectron spectroscopy with a photon energy of 5.95 keV. Clear differences between the AFM and FM states are observed across the entire valence-band spectrum and these are well reproduced using density-functional theory. Changes in the 2p core levels of Fe are also observed and interpreted using Anderson impurity model calculations. These results indicat…
Spatially resolved nanostructural transformation in graphite under femtosecond laser irradiation
2015
Abstract A polycrystalline graphite target was irradiated using infrared (800 nm) femtosecond (120 fs) laser pulses of different energies. Increase of sp 3 bonds percentage and possible diamond crystal formation were investigated ‘in-depth’ and on the irradiated surfaces. Synchrotron X-ray diffraction pattern have shown the presence of a diamond peak in one of the irradiated zones while X-ray photoelectron spectroscopy investigations have shown an increasing tendency of the sp 3 percent in the low power irradiated areas and similarly ‘in the depth’ of the higher power irradiated zones. Multiple wavelength Micro-Raman investigations have confirmed this trend along with an ‘in-depth’ (but not…
XPS study of pumice-supported palladium and platinum catalysts
1992
An XPS study has been performed on samples of monometallic of palladium and platinum and on bimetallic Pd-Pt catalysts supported on pumice. A negative shift of about 0.5 eV in the Pd 3d and Pt 4f binding energies of the catalysis relative to the energies of the same levels in the pure metals suggested an increase in the electron density in both metals. A quantitative XPS analysis indicated that the supported metals did not modify the surface atomic composition of pumice
H2-TPR, XPS and TEM Study of the Reduction of Ru and Re promoted Co/γ-Al2O3, Co/TiO2 and Co/SiC Catalysts
2016
<p class="1Body">Effects of Ru and Re promoters on Co-CoO<sub>x </sub>catalysts supported on γ-Al<sub>2</sub>O<sub>3</sub>, TiO<sub>2</sub> and SiC were investigated to improve the understanding of the role of promoters of the active phase of Co-CoO<sub>x</sub>-Ru and Co-CoO<sub>x</sub>-Re. The influence of promoter addition on the composition and activity of the catalysts was characterized by several methods, such as H<sub>2</sub>-TPR, XPS, chemisorption and TEM. Furthermore, the role of support and metal-support interaction was especially studied and different support materials were compared.</p&g…
Support effect on the structure and CO oxidation activity of Cu-Cr mixed oxides over Al2O3 and SiO2
2009
Abstract Cu-Cr based catalysts supported on silica and alumina with 5 wt% total loading of (CuO + Cr2O3), in different molar ratios, were prepared by wet impregnation. The samples were studied by nitrogen adsorption isotherms (BET), temperature-programmed reduction (TPR), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS). Their catalytic activity was tested in the CO oxidation reaction. Different structures were obtained in dependence of the support, the atomic ratio and the calcination temperature. In particular, whereas on Al2O3 there was no experimental evidence for interaction between Cu and Cr, over the silica supported systems formation of new phases CuCr2O4 and CuCrO…