Search results for "X-ray photoelectron spectroscopy"
showing 10 items of 416 documents
Physicochemical characterization of metal hexacyanometallate–TiO2composite materials
2015
The paper describes the synthesis and characterization of novel TiO2–metal hexacyanometallates (MHCMs) composite materials. The starting material, TiO2, was modified by addition of cobalt-hexacyanoferrate (CoHCF) or iron-hexacyanocobaltate (FeHCC) at various concentrations. The resulting composites were characterized as follows: cyclic voltammetry (CV) followed the formation of TiO2–MHCM clusters, TEM micrographs studied their morphology, XAS and XPS data indicated that MHCM bonds to TiO2 through the nitrogen atom of its –CN group and modifies the environment of Ti compared to that of pure anatase. As expected, and confirmed by UV-Vis and XP-valence band data, the electronic properties of T…
Unveiling the oxidation behavior of liquid-phase exfoliated antimony nanosheets
2020
Abstract Antimonene, a monolayer of β-antimony, is increasingly attracting considerable attention, more than that of other monoelemental two-dimensional materials, due to its intriguing physical and chemical properties. Under ambient conditions, antimonene exhibits a high thermodynamic stability and good structural integrity. Some theoretical calculations predicted that antimonene would have a high oxidation tendency. However, it remains poorly investigated from the experimental point of view. In this work, we study the oxidation behavior of antimonene nanosheets (ANS) prepared by ultrasonication-assisted liquid-phase exfoliation. Using a set of forefront analytical techniques, a clear effe…
Influence of the dissolution of MnS inclusions under free corrosion and potentiostatic conditions on the composition of passive films and the electro…
2006
Abstract The influence of the dissolution of MnS inclusions at the OCP value and 400 mV versus SCE on the chemical composition of passive films and the electrochemical behaviour of resulfurized austenitic stainless steel was studied in 1 M NaClO 4 , pH 3, solution using SIMS, XPS, electrochemical impedance spectroscopy and the electrochemical microcell technique. The electrochemical dissolution (at 400 mV versus SCE) of inclusions occurred uniformly along the interface and this process was almost complete after 25 min immersion. A small amount of sulfur was detected on the matrix that exhibited a wide passive range. By contrast, the dissolution process under free corrosion was not uniform a…
Characterization of Zirconium Phosphate/Polycation Thin Films Grown by Sequential Adsorption Reactions
1997
Monolayer and multilayer thin films consisting of anionic α-zirconium phosphate (α-ZrP) sheets and polycations (poly(allylamine hydrochloride) (PAH), cytochrome c) were characterized by transmission electron microscopy (TEM), ellipsometry, UV−visible absorbance spectroscopy, reflectance FT-IR, XPS, and X-ray diffraction. Titration and powder X-ray diffraction experiments confirm that exfoliation of α-ZrP begins to occur when enough tetra(n-butylammonium) hydroxide (TBA+OH-) has been added to exceed single-layer packing of TBA+ ions (x ≈ 0.50) in the intercalation compound Zr(HPO4)2-x(TBA+PO4-)x·nH2O. The identical contrast of many sheets in TEM micrographs suggests that the suspension is un…
A study of thin surface layers by multilayer Mössbauer spectroscopy /MMS/
1990
A stacking Mossbauer technique, MMS has been applied for studying thin surface layers. The surface layers formed on the57Fe film in aqueous solutions of corrosion inhibitors, such as zinc phosphate and barium metaborate, and in distilled water was studied by this method. It has been found that the corrosion is much slower in the presence of zinc phosphate and barium metaborate. XPS analysis suggests the formation of a mixed iron zinc phosphate on the surface of the57Fe film after corrosion in a zinc phosphate solution.
Quantitative XPS analysis of leached layers on optical glasses
1993
The corrosion of optical glasses often reduces the utility of uncoated glasses as well as the adhesion of resistive coatings deposited onto corroded glasses. Photoelectron spectroscopy (XPS) was applied to study glass surfaces with respect to their surface corrosion. In particular, leaching by the influence of polish slurries, pure water, air and even residual gases inside a vacuum device was studied in detail. Pure quartz glass and different sodium and barium silicate glasses were broken in ultrahigh vacuum (4 × 10−10 mbar) for the determination of sensitivity factors of the different XPS signals. It was found that a quantitative determination of the surface composition of corroded and lea…
Chemical heterogeneities in nanometric titanomagnetites prepared by soft chemistry and studied ex situ : evidence for fe-segregation and oxidation ki…
2001
Nanocrystalline Fe-based spinels with composition Fe3-xTixO4 are synthesized using soft chemistry. Two steps are involved: precipitation in an aqueous solution followed by thermal annealing under a reducing mixture of N2/H2/H2O gases. Fe-segregation is found inside stoichiometric particles when the powders are studied ex situ; they exhibit a strong surface iron enrichment. This heterogeneity is related to kinetic effects linked to the difference of mobility between Fe2+ and Ti4+ cations during the partial oxidation of cations occurring ex situ. Stresses in the grains induced by oxidation govern the oxidation kinetics and lead to an abrupt compositional variation inside each particle. These…
In-situ characterisation of organosilane films formation on aluminium alloys by electrochemical quartz crystal microbalance and in-situ ellipsometry
2005
Abstract Organosilane pre-treatments have been studied intensively during the last years in order to replace hexavalent chromium conversion treatments. The aim of this study is to follow in-situ the formation of this organosilane layer in solution. Two in-situ techniques, spectroscopic ellipsometry and electrochemical quartz crystal microbalance, were used to investigate the mechanism and the kinetics of this protective film formation. In-situ measurements highlight that the organosilane film observed after the drying process is not formed into the solution, but during the emersion and drying step. Hence, it has been possible to characterise the presence of a very thin organosilane layer in…
Influence of annealing atmosphere on photoelectrochemical response of TiO2 nanotubes anodized under controlled hydrodynamic conditions
2021
[EN] The influence of three annealing atmospheres (air, nitrogen and argon) and the use of controlled hydrodynamic conditions (from 0 to 5000 rpm) on morphological, structural, chemical and photoelectrochemical properties of TiO2 nanotubes have been evaluated. For this purpose, different characterization techniques have been used: Field Emission Scanning Electron Microscopy, Raman Confocal Laser Spectroscopy, X-Ray Diffraction, X-Ray Photoelectron Spectroscopy, Incident Photon-to-electron Conversion Efficiency measurements, ultraviolet-visible absorption spectra, Mott-Schottky analysis and photoelectrochemical water splitting tests. According to the results, it can be concluded that both hy…
Superficial defects induced by argon and oxygen bombardments on (110) TiO2 surfaces
1998
Abstract Compositional and chemical changes of titanium dioxide monocrystalline surfaces induced by bombardment with 4 keV argon and oxygen ions have been studied by AES, XPS and AFM. Argon ion bombardment induced strong changes in the composition and chemical state of the surface: loss of oxygen due to preferential sputtering occurred, and, related to this, Ti4+ species were reduced to Ti3+ and Ti2+. During oxygen bombardment, competition between preferential sputtering of oxygen ions of the oxide surface and oxygen implantation was observed. This phenomenon was found to be strongly dependent upon the incidence angle of the oxygen ions. Moreover, an oxygen bombardment with normal incidence…