Search results for "absorption"

Light-induced transmission nonlinearities in gallium selenide

1999

The intensity of a He–Ne laser (633 nm, 5 mW) transmitted by different GaSe samples is observed to change in correlation with a Nd-yttrium–aluminum–garnet laser pulse (532 nm, 7.8 ns, 3 mJ) which excites them. Such time response has been attributed to a nonlinear optical effect, i.e., a decrease in the refractive index due to the exciton screening by the photogenerated carriers. A calculation of the absorption coefficient and refractive index at different carrier concentrations has led to a reconstruction of transmittance transients which fully agree with the experimental data at different incident intensities and temperatures. Chantal.Ferrer@uv.es ; Jaqueline.Bouvier@uv.es ; Miguel.Andres@…

Pressure dependence of the optical properties of wurtzite and rock-salt Zn1–xCoxO thin films

2007

In this paper we investigate the electronic structure of Zn 1-x Co x O by means of optical absorption measurements under pressure. Thin films of Zn 1-x Co x O with different Co content (from 1 to 30%) were prepared by pulsed laser deposition on mica substrates. Absorption spectra exhibit three main features that are clearly correlated to the Co content in the films: (i) absorption peaks in the infrared associated to crystal-field-split internal transitions in the Co 3d shell, with very small pressure coefficients due to their atomic character; (ii) a broad absorption band below the fundamental edge associated to charge transfer transitions, that exhibit relatively large pressure coefficient…

Huge shift of fundamental electronic absorption edge in Sr1−xBaxNb2O6 crystals at elevated temperatures

1995

Structural Properties and Temperature Behaviour of Optical Absorption Edge in Polycrystalline ZnO:X (Cu,Ag) Films

2013

Silver- and copper-doped ZnO lms were prepared by radio-frequency magnetron sputtering on glass substrates. The in uence of dopants content on the structural, morphological properties as well as on evolution of the optical absorption edge was considered. It has been found that Ag- and Cu-doped ZnO lms are characterized by wurtzite crystalline structure with the preferred direction of crystalline orientation (002). The sizes of grains within the lms were found to be dependent on the type of dopant. The temperature evolution of the optical absorption edge is described by the modi ed Urbach rule that re ects polycrystalline nature of the material. The corresponding parameters concerning electr…

Contribution à l'étude des liaisons optiques atmosphériques : propagation, disponibilité et fiabilité.

2005

In this work we study the fog attenuation in the visible and infrared spectral band related to Free Space Optics (FSO). Based on the Mie scattering theory, fog extinction coefficients for different particle size distributions as a function of wavelength were derived. A simple analytical model allowing the prediction of atmospheric transmission for the 0.69 - 1.55 µm spectral band was developed. This model is valid for advection and convection fog and for visibility range between 50 to 1000 m. This model, implemented into software developed at FT R&D, allows the prediction of the Quality of Service of FSO links. Finally, we performed an experimental study to compare the fog effect on two FSO…

An Introduction to Soil and Water Infiltration

2016

This chapter provides a short presentation of general characteristics of the soil. Basic concepts concerning soil water content and potential and flow of water in the porous medium are then reported since these concepts are diffusely used throughout this book. The infiltration process is finally illustrated considering different modeling approaches. In particular, development of analytical infiltration models is described with reference to one-dimensional gravity-free water absorption, one-dimensional gravity driven infiltration, one-dimensional gravity and capillary driven infiltration and, finally, three-dimensional gravity and capillary driven infiltration.

Synthesis of polymeric derivatives of isoniazid: characterization and in vitro release from a water-soluble adduct with polysuccinimide.

1989

Coupling of isoniazid with polysuccinimide afforded a water-insoluble polymeric pro-drug; by reaction with ethanolamine it was chemically transformed in a water-soluble adduct. The in vitro release of isoniazid from the drug-polymer adduct was studied by using an artificial stomach wall lipid membrane. The transfer rate constant from simulated gastric juice to simulated plasma was defined and compared with that of an equivalent dose of pure drug.

X-ray CT imaging as a scientific tool to study the capillary water absorption in sedimentary rocks used in cultural heritages

2009

This paper proposes the X-Ray CT imaging as appropriate tool for investigating the capillary water absorption in sedimentary rocks. This technique, in fact, provides information useful for deeping the knowledge about of the porosity and the kinetics of the water capillary absorption in porous materials. The possibility to improve in non invasive manner, the understanding of this phenomenon, constitutes a fundamental aspect to take actions in the restoration and conservation of lapideous artifact and monuments from cultural heritages. The investigated sedimentary rocks come from different Sicilian quarries and were used for the building of the Greek temples in the archaeological areas of Agr…

The effects of water absorption and salt fog exposure on agglomerated cork compressive response

2022

The replacement of synthetic foams with agglomerated cork in sandwich composites can meet the increasing environmental concerns. Its peculiar morphology and chemical composition lead to outstanding dimensional recovery that endorsed a broad investigation of its compressive behavior. The knowledge of neat material response is fundamental to obtain a reliable design dataset, but it is necessary to consider all the environmental factors (water, moisture and sunlight) that significantly modify material mechanical properties. In view of this, the present work investigates the effect of distilled and seawater absorption and salt fog exposure on the compressive behavior of two agglomerated corks w…

Investigation of water sorption and aluminum releases from high viscosity and resin modified glass ionomer.

2019

Background High viscosity glass ionomer cement (HVGIC) and resin-modified glass ionomer cement (RMGIC) have recently been clinically preferred thanks to their numerous advantages. However, initial moisture contamination has a negative effect on the mechanical and physical properties of these cements. The aim of this study was in vitro of HVGICs and RMGICs, with and without surface protection, on water sorption, solubility and release of aluminum. Material and Methods In this study, as HVGICs; Equia Forte, IonoStar Plus, Riva Self Cure; as RMCIS, Ionolux and Riva Light Cure; and as control, Z250 universal composite was used. Equia coat, Voco varnish and Riva coat were chosen as surface prote…