Search results for "alkaline"
showing 10 items of 283 documents
High-Pressure Phase Diagram and Superionicity of Alkaline Earth Metal Difluorides
2018
We study the high-pressure–high-temperature phase diagram and superionicity of alkaline earth metal (AEM) difluorides (AF2, A = Ca, Sr, Ba) with first-principles simulation methods. We find that the superionic behavior of SrF2 and BaF2 at high pressures differ appreciably from that previously reported for CaF2 [Phys. Rev. Lett. 2014, 113, 235902]. Specifically, the critical superionic temperature of SrF2 and BaF2 in the low-pressure cubic fluorite phase is not reduced by effect of compression, and the corresponding high-pressure orthorhombic contunnite phases become superionic at elevated temperatures. We get valuable microscopic insights into the superionic features of AEM difluorides in b…
Observation of chemical reactions between alkaline-earth oxides and tungsten at high pressure and high temperature
2009
Abstract The potential chemical reactions of alkaline-earth oxides (AeO with Ae: Mg, Ca, Sr, and Ba) and tungsten are studied at high pressure and high temperature. At pressures ranging from 5 to 10 GPa and temperatures of 2000 K, a noticeable reaction between AeO and powder tungsten (W) was detected. As a product of the reaction, scheelite-structured orthotungstates (AeWO 4 ) were formed. The reactivity of alkaline-earth oxides with tungsten increases in the order Ca 2 →AeWO 4 .
An improved cathode for alkaline fuel cells
2010
Abstract The use of nickel foam as an electrode substrate in alkaline fuel cells (AFCs) has been investigated for bipolar cells incorporating an electrically conducting gas diffusion layer (GDL). Improved performance, compared to a previous design, was obtained by adding an extra active layer (AL) composed of manganese (IV) oxide (MnO2) deposited onto carbon black. This new cathode design performed significantly better (130 mA cm−2 at 0.8 V and 25 °C) than the previous design (35 mA cm−2 under the same condition), especially at higher potential. It has been shown that the GDL is a key component of the gas diffusion electrode for both performance and durability, especially with liquid electr…
Alkaline fuel cell technology - A review
2021
Abstract The realm of alkaline-based fuel cells has with the arrival of anionic exchange membrane fuel cells (AEMFCs) taken a great step to replace traditional liquid electrolyte alkaline fuel cells (AFCs). The following review summarises progress, bottleneck issues and highlights the most recent research trends within the field. The activity of alkaline catalyst materials has greatly advanced, however achieving long-term stability remains a challenge. Great AEMFC performances are reported, though these are generally obtained through the employment of platinum group metals (PGMs), thus emphasising the importance of R&D related to non-PGM materials. Thorough design strategies must be utilise…
Clean analytical method for the determination of propoxur
1995
Abstract A method has been developed for the determination of propoxur, a carbamate pesticide, by means of its reaction with p-aminophenol (PAP). The method involves the reaction, in the presence of KIO4, between the quinoneimine form of PAP and the deprotonated form of 2-isopropoxyphenol, obtained by the alkaline hydrolysis of propoxur, to provide an indophenol dye which absorbs at 600 nm. The analysis is carried out in a flow system and, after the measurement step, the waste, the reaction product and the unreacted derivatising agent is detoxified in a UV-irradiated coil placed after the measurement flow-cell and after mixing the waste with a TiO2(anatase) catalyst slurry, which can be reu…
Trace element partitioning in lamproitic magmas—the Gaussberg olivine leucitite
2004
Abstract Partition coefficients for compatible and incompatible trace elements for use in modelling the origin and evolution of lamproitic and other potassic rocks are reported. These are based on values obtained by in situ determination using laser ablation microprobe-inductively coupled plasma-mass spectrometry (LAM-ICP-MS) on mineral/glass pairs in examples of the Gaussberg olivine leucitite, a classic leucite lamproite. Leucite/melt partition coefficients for 32 elements show values above 1 only for Cs and Rb, whereas values for Ni, Ga and Co are 0.4–0.1. DLc/Lq for most other elements are in the range 0.07–0.0005, and delineate a gently sloping pattern to lower values for elements gene…
Particles of vaterite, a metastable CaCO3polymorph, exhibit high biocompatibility for human osteoblasts and endothelial cells and may serve as a biom…
2018
We have previously described a promising alternative to conventional synthetic bone biomaterials using vaterite, a metastable CaCO3 polymorph that increases the local Ca2+ concentration in vitro and leads to an oversaturation of phosphate, the primary bone mineral. This stimulates a natural bone-like mineralisation in a short period of time. In this study, sterile and endotoxin-free vaterite particles were synthesised in a nearly quantitative yield. The 500-1,000 nm vaterite particles did not exhibit any cytotoxic effects as measured by MTS, lactate dehydrogenase, or crystal violet assays on the human osteoblast cell line (MG-63) exposed to concentrations up to 500 μg/ml vaterite up to 72 h…
3D bioprinting of tissue units with mesenchymal stem cells, retaining their proliferative and differentiating potential, in polyphosphate-containing …
2021
Abstract The three-dimensional (3D)-printing processes reach increasing recognition as important fabrication techniques to meet the growing demands in tissue engineering. However, it is imperative to fabricate 3D tissue units, which contain cells that have the property to be regeneratively active. In most bio-inks, a metabolic energy-providing component is missing. Here a formulation of a bio-ink is described, which is enriched with polyphosphate (polyP), a metabolic energy providing physiological polymer. The bio-ink composed of a scaffold (N,O-carboxymethyl chitosan), a hydrogel (alginate) and a cell adhesion matrix (gelatin) as well as polyP substantially increases the viability and the …
Redox-active crown ethers derived from biphenyl. Electrochemical and spectroscopic study of binding processes with alkali, alkali-earth and mercury s…
1998
Abstract Three new electroactive ligands, 3a, 3b and 3c, that contain the biphenyl frameworks in their structure were prepared. These new ligands presented three interesting characteristics: 1) they exhibited a reversible oxidation, 2) the oxidation induced a conformational change in the crown moiety and 3) they had two different coordination centers, the crown ether and the dimethylamino groups. Electrochemical and spectroscopic studies using alkali, alkali-earth and mercury salts were carried out.
The effects of alpha-cypermethrin exposure on biochemical and redox parameters in pregnant rats and their newborns
2016
IF 2.388; International audience; Pyrethroid insecticides are extensively used in agriculture and in household activities. During pregnancy, they might affect maternal metabolic status and there after fetal development. In this work, we studied metabolic and redox effects of low dose alpha-cypermethrin exposure in pregnant rats and their offspring. The diet containing alpha cypermethrin at 0.02 mg/kg/day was consumed during the entire gestation. Plasma biochemical parameters as well as liver lipid and oxidative stress markers were determined. Our results showed that alpha-cypermethrin induced an increase in body weight and in plasma glucose and lipid levels, as well as in plasma aspartate a…