Search results for "aqueous solution"

Polyelectrolytes in dilute solution: viscometric access to coil dimensions and salt effects

2015

Copolymers of acrylamide (AM) and diallyldimethylammonium chloride (DADMAC), differing in molar masses M (52.3 to 227 kDa) and degrees of charging y (0.2 to 0.6), were studied with respect to their viscometric behavior in dilute aqueous solutions containing variable amounts of NaCl. Complementary measurements were performed on a Brookhaven 90 plus particle size analyzer. M dominates the intrinsic viscosities [η]. For the viscometric interaction parameters B this is only true for large concentrations of extra salt. [η] and B as a function of solvent salinity follow Boltzmann laws. Coil dimensions, determined either via dynamic light scattering or viscometry, agree well. For low salt contents…

Consequences of linking charged and uncharged monomers to binary copolymers studied in dilute solution. Part I: Viscometric behavior of the homopolym…

2017

Abstract Intrinsic viscosities, generalized intrinsic viscosities and viscometric interaction parameters were measured for aqueous solutions of poly(ethylene oxide) [PEO], poly(N,N-dimethyl aminoethyl methacrylate) [PR] (uncharged) and for poly{[2-(methacryloyloxy)ethyl] trimethylammonium iodide} [PR+] (charged) within a wide range of molar masses. In this manner it was possible to establish the information required for the study of non-additivity effects upon the formation of binary copolymers from the monomers specified above. The following additional items were of particular interest: The effects of charging PR to PR+ and the composition dependence of the coil overlap in the case of sali…

Intrinsic Viscosities of Polymer Blends: Sensitive Probes of Specific Interactions between the Counterions of Polyelectrolytes and Uncharged Macromol…

2018

In joint dilute aqueous solutions of pullulan (PUL) and poly(sodium 4-styrenesulfonate) (PSS-Na) the Na+ ions of the polyelectrolyte interact so favorably with the monomeric units of PUL that isolated coils containing both types of macromolecules are formed upon dilution. When water is replaced against a 1 M solution of NaCl, this effect dies out because of the large surplus of Na+ ions. On the other hand, if the water contains increasing amounts of the respective counterpolymer instead of NaCl, the formation of mixed isolated coils is fostered, where a further diminution of the intrinsic viscosities is caused by the lower the solvent quality. The molar mass of PSS-Na plays an important rol…

2017

Abstract In this study, an adsorption-oriented process for the removal of fungicides from polycontaminated aqueous solutions was applied. To remove triazole fungicides from aqueous mixtures of propiconazole (PROPI), tebuconazole (TEBU), epoxiconazole (EPOXI), bromuconazole (BROMU) and difenoconazole (DIFENO), several materials used as adsorbents were compared using batch experiments, namely two conventional activated carbons (ACs) and five nonconventional cross-linked cyclodextrin (CD)-based materials (α-CDP, β-CDP, γ-CDP, αβγ-CDP mixture, and hydroxypropyl-β-CDP). This article presents the abatements obtained. As expected, ACs exhibited the highest levels of triazole fungicide removal: the…

Tailoring Properties of Carbon Nanotube Dispersions and Nanocomposites Using Temperature-Responsive Copolymers of Pyrene-Modified Poly(N-cyclopropyla…

2010

Despite their immense potential, the ability to control the dispersion and microstructure of carbon nanotubes remains a hurdle for their widespread use. Stimuli-responsive polymers show conformational changes with an applied external stimulus (pH, temperature, light, etc.). The dispersion of carbon nanotubes by thermoresponsive polymers is shown to enable the macroscopic properties of aqueous suspensions to be tailored as a function of temperature. This work presents the synthesis, characterization, and use of temperature-responsive poly(N-cyclopropylacrylamide) (PNCPA) polymers containing 1, 3, and 5 mol % pyrene-bearing repeat units to tailor the dispersion state of single-walled carbon n…

Bitterness and astringency of flavan-3-ol monomers, dimers and trimers

1999

Intensity of astringency and bitterness of seven flavonoid compounds was evaluated by a time-intensity (TI) procedure. Eighteen trained judges rated intensity continuously from ingestion, through expectoration at 10 s until extinction of the sensation. The seven stimuli included two flavan-3-ol monomers, (+)-catechin and (−)-epicatechin, three dimers and two trimers synthesised from catechin or epicatechin by condensation with (+)-dihydroquercitin. As the degree of polymerisation increased, maximum bitterness intensity (Imax) and total duration (Ttot) decreased whereas astringency Imax increased. The monomers were significantly higher in bitterness at Imax than the dimers, which were signif…

Determining the selective impregnation of waterlogged archaeological woods with poly(ethylene) glycols mixtures by differential scanning calorimetry

2012

The differential scanning calorimetry (DSC) technique was demonstrated to be a reliable and fast tool for the investigation of the selective impregnation of archaeological woods with poly(ethylene) glycols (PEGs) mixtures. To this aim, waterlogged archaeological woods were impregnated by using aqueous mixtures of PEG 4000 and PEG 400 as well as mixtures of these polymers in the melt state. The efficiency of the treatments was also estimated by determining the total consolidant content entrapped into the cavities of degraded wood by means of DSC and thermogravimetry.

Cylindrical polyelectrolyte-comb-surfactant complexes

2006

Abstract Quaternized polymer combs based on poly(2-vinylpyridine-macromonomers) and the surfactant sodium dodecylsulfate are employed in the synthesis of a novel cylindrical polyelectrolyte-comb-surfactant complex (PECSC). The complex formed has 1:1 stoichiometry with respect to the ratio of dodecylsulfate to pyridinium units. It is soluble in organic solvents such as 2-butanol or chloroform. Characterization of single particle properties of the complex in organic solution is possible and yields a radius of gyration of 〈Rg〉z = 78.4 nm, a hydrodynamic radius of 〈1/Rh〉z−1 = 51.4 nm and a cross-sectional radius of Rg,cross = 3.9 nm in chloroform. The characteristic ratio γ = 〈Rg〉z/〈1/Rh〉z−1 de…

Voltammetric behaviour of monomeric fac-trioxomolybdenum(VI) complexes with aminocarboxylic ligands in aqueous media

1992

Abstract Cyclic voltammetry, polarography and controlled-potential coulometry experiments have been used to characterize the electrochemical reduction of fac-MoO3L2− complexes (L = aspartic acid or iminodiacetic acid) in aqueous media. These complexes are reduced in two irreversible proton-assisted steps to give an oxo-bridged molybdenum(V) species and then to a molybdenum(III) dimer species. At pH 4.5, the former reduction step for the iminodiacetic acid ligand occurs at Ep = −0.75 V, while the second one appears at −1.12 V vs SCE. The overall electrochemical process can be described in terms of a homogeneous chemical reaction, coupled between two electron transfers (ECE mechanism), that i…

High-energy radiation processing, a smart approach to obtain PVP-graft-AA nanogels

2014

Abstract Poly(N-vinylpyrrolidone)-grafted-acrylic acid biocompatible nanogels (NGs) were prepared using an exiting industrial-type electron accelerator and setups, starting from semi-dilute aqueous solutions of a commercial PVP and the acrylic acid monomer. As a result, NGs with tunable size and structure can be obtained quantitatively. Sterility was also imparted at the integrated dose absorbed. The chemical structure of the NGs produced was confirmed through Fourier Transformer Infrared Spectroscopy (FT-IR). The molecular and physico-chemical properties of NGs, such as the hydrodynamic dimensions and surface charge densities, for various polymer and monomer concentrations in the irradiate…