Search results for "catalyst"

Catalytic activity of biscobalt porphyrin-corrole dyads toward the reduction of dioxygen

2009

A series of biscobalt cofacial porphyrin-corrole dyads bearing mesityl substituents at the meso positions of the corrole ring were investigated as to their electrochemistry, spectroelectrochemistry, and CO binding properties in nonaqueous media and then applied to the surface of a graphite electrode and tested as electrocatalysts for the reduction of dioxygen to water or hydrogen peroxide in air-saturated aqueous solutions containing 1 M HClO(4). The catalytic reduction of O(2) with the same dyads was also investigated in the homogeneous phase using 1,1'-dimethylferrocene as a reductant in PhCN containing HClO(4). The examined compounds are represented as (PMes(2)CY)Co(2), where P = a porph…

Sewage sludge as cheap alternative to microalgae as feedstock of catalytic hydrothermal liquefaction processes

2019

Abstract Production of biocrude through hydrothermal liquefaction (HTL) of sewage sludge (SS) and Chlorella vulgaris was investigated. NiMo/Al2O3 (KF 851), CoMo/Al2O3 (KF 1022) and activated carbon felt, tested as catalysts at 598 K for 30 min, did not change the biocrude yield but significantly improved its quality. Quantitative sulfur removal and lower oxygen content were found in biocrude when KF 851 and KF 1022 were used with C. vulgaris. The same catalysts decreased O/C and S/C ratio of the biocrude from SS. The highest HHV (38.19 MJ/kg) and H/C ratio (1.65) and the lowest O/C (0.11) of the biocrude from SS were obtained with the cheaper activated carbon felt. A new product phase, prob…

Microscopic Revelation of Charge-Trapping Sites in Polymeric Carbon Nitrides for Enhanced Photocatalytic Activity by Correlating with Chemical and El…

2019

The influences of chemical and electronic structures on the photophysical properties of polymeric carbon nitrides (PCNs) photocatalysts, which govern the microscopic mechanisms of the superior photocatalytic activity under visible-light irradiation, have been resolved in this work. Time-resolved photoluminescence and in situ electron paramagnetic resonance measurements indicate that the photoexcited electrons in the fractured PCNs swiftly transfer to the C2p-localized states where the trapped photoelectrons exhibit longer lifetime compared to those in the ordinary PCNs. Moreover, the structure deviation at the carbon (Cb) atoms around the bridging sites of heptazine ring units, where trappe…

Few layer 2D pnictogens catalyze the alkylation of soft nucleophiles with esters

2019

Group 15 elements in zero oxidation state (P, As, Sb and Bi), also called pnictogens, are rarely used in catalysis due to the difficulties associated in preparing well–structured and stable materials. Here, we report on the synthesis of highly exfoliated, few layer 2D phosphorene and antimonene in zero oxidation state, suspended in an ionic liquid, with the native atoms ready to interact with external reagents while avoiding aerobic or aqueous decomposition pathways, and on their use as efficient catalysts for the alkylation of nucleophiles with esters. The few layer pnictogen material circumvents the extremely harsh reaction conditions associated to previous superacid–catalyzed alkylations…

2020

Worldwide, tons of lignin is produced annually in pulping plants and it is mainly considered as a waste material. Usually lignin is burned to produce energy for the pulping reactors. The production of value-added materials from renewable materials like lignin, has proved to be challenging. In this study, the effects of addition of three different types of lignin in the production of tannin/furanic foams is investigated. The foams were matured, first at 373 K and finally carbonized at 1073 K and the properties of them including mechanical strength, specific surface area and pore development are investigated before and after thermal treatment. According to the results, higher mechanical stren…

The swinholide biosynthesis gene cluster from a terrestrial cyanobacterium, Nostoc sp. strain UHCC 0450

2017

ABSTRACT Swinholides are 42-carbon ring polyketides with a 2-fold axis of symmetry. They are potent cytotoxins that disrupt the actin cytoskeleton. Swinholides were discovered from the marine sponge Theonella sp. and were long suspected to be produced by symbiotic bacteria. Misakinolide, a structural variant of swinholide, was recently demonstrated to be the product of a symbiotic heterotrophic proteobacterium. Here, we report the production of swinholide A by an axenic strain of the terrestrial cyanobacterium Nostoc sp. strain UHCC 0450. We located the 85-kb trans -AT polyketide synthase (PKS) swinholide biosynthesis gene cluster from a draft genome of Nostoc sp. UHCC 0450. The swinholide …

Sustainable Construction of Heterocyclic 1,2,3-Triazoles by Strict Click [3+2] Cycloaddition Reactions Between Azides and Alkynes on Copper/Carbon in…

2019

1,4-Disubstituted-1,2,3-triazoles, considered as an important and useful class of heterocycles with potential applications in material science and biology, have been prepared in an efficient and selective manner by copper on carbon-catalyzed [3+2] cycloaddition reactions of azides and alkynes (CuAAC) in water under strict click chemistry conditions. Copper(I) catalysts heterogenized onto commercially activated carbon materials (Cu-CC) and on another carbon material produced from vegetable biomass using Argan nut shells (Cu-CANS) were found to be versatile catalytic sources for sustainable CuAAC. These copper on carbon supports were prepared and fully characterized by using two types of acti…

ChemInform Abstract: Recyclable Catalyst Reservoir: Oxidation of Alcohols Mediated by Noncovalently Supported Bis(imidazolium)-Tagged 2,2,6,6-Tetrame…

2014

Comparison of activity in the 2-propanol dehydration of supported heteropolyacid (photo)catalysts at the gas-solid interface

2015

Catalytic and photocatalytic tests for 2-propanol dehydration to propene were successfully carried out by using binary materials obtained by supporting a Keggin heteropolyacid H3PW12O40 (PW12) via impregnation method and/or solvothermal treatment. The supports used were commercial SiO2 (Mallinckrodt), TiO2 (Evonik P25) and multiwall carbon nanotubes (Sunnano) or home solvothermically prepared SiO2 and TiO2. (Photo)catalytic 2-propanol dehydration was studied in gas-solid regime by using a continuous (photo)reactor working at atmospheric pressure and 80 °C. the reaction was also studied by performing FTIR spectra of the gas-phase over the HPA-support composites, where the 2-propanol had been…

3D Printed Palladium Catalyst for Suzuki-Miyaura Cross-coupling Reactions

2020

Selective laser sintering (SLS) 3d printing was utilized to manufacture a solid catalyst for Suzuki-Miyaura cross-coupling reactions from polypropylene as a base material and palladium nanoparticles on silica (SilicaCat Pd(0)R815-100 by SiliCycle) as the catalytically active additive. The 3d printed catalyst showed similar activity to that of the pristine powdery commercial catalyst, but with improved practical recoverability and reduced leaching of palladium into solution. Recycling of the printed catalyst led to increase of the induction period of the reactions, attributed to the pseudo-homogeneous catalysis. The reaction is initiated by oxidative addition of aryl iodide to palladium nano…