Search results for "ck"
showing 10 items of 18632 documents
Measurement of the activation energies of oxygen ion diffusion in yttria stabilized zirconia by flicker noise spectroscopy
2019
The low-frequency noise in a nanometer-sized virtual memristor consisting of a contact of a conductive atomic force microscope (CAFM) probe to an yttria stabilized zirconia (YSZ) thin film deposited on a conductive substrate is investigated. YSZ is a promising material for the memristor application since it is featured by high oxygen ion mobility, and the oxygen vacancy concentration in YSZ can be controlled by varying the molar fraction of the stabilizing yttrium oxide. Due to the low diameter of the CAFM probe contact to the YSZ film (similar to 10nm), we are able to measure the electric current flowing through an individual filament both in the low resistive state (LRS) and in the high r…
A Novel Fault-Tolerant Routing Algorithm for Mesh-of-Tree Based Network-on-Chips
2019
Use of bus architecture based communication with increasing processing elements in System-on-Chip (SoC) leads to severe degradation of performance and speed of the system. This bottleneck is overcome with the introduction of Network-on-Chips (NoCs). NoCs assist in communication between cores on a single chip using router based packet switching technique. Due to miniaturization, NoCs like every Integrated circuit is prone to different kinds of faults which can be transient, intermittent or permanent. A fault in any one component of such a crucial network can degrade performance leaving other components non-usable. This paper presents a novel Fault-Tolerant routing Algorithm for Mesh-of-Tree …
Determination of impurity distributions in ingots of solar grade silicon by neutron activation analysis
2017
AbstractIn a series of crystallization experiments, the directional solidification of silicon was investigated as a low cost path for the production of silicon wafers for solar cells. Instrumental neutron activation analysis was employed to measure the influence of different crystallization parameters on the distribution of 3d-metal impurities of the produced ingots. A theoretical model describing the involved diffusion and segregation processes during the solidification and cooling of the ingots could be verified by the experimental results. By successive etching of the samples after the irradiation, it could be shown that a layer of at least 60 μm of the samples has to be removed to get r…
Long term stability testing of oxide unicouple thermoelectric modules
2019
Thermoelectric devices based on oxides are good candidates for energy harvesting technologies for use in aggressive conditions where the materials should withstand high temperatures and corrosive environments over prolonged time. This leads to a natural concern for the stability of the electrical contacts, especially on the hot side of the module. In this work, we have assembled several prototype unicouple thermoelectric modules made by pyrolyzed and spark plasma sintered n-type CaMnO3 and p-type Ca3Co4O9 and then tested under different conditions mimicking end-user applications. For baseline experiments we have chosen to use nickel as the contact material in order to show the effect of its…
Simulation of IQE tuning of individual cells for DC-balancing multijunction tandem cells
2016
In the present work, the performance of stacks of cells connected in series is examined at different levels of internal quantum efficiency (IQE). Incident photons, generated by employing the ASTM G173-03 data set, are accounted for individually as they interact with the stack of cells. The efficiencies of the devices studied are dependent upon the DC balance throughout the stack of cells. It is demonstrated that reducing the internal quantum efficiency of upper cells can lead to a better DC balance and thereby higher efficiency.
Multiphysical Modeling of Transport Phenomena During Laser Welding of Dissimilar Steels
2016
Abstract The success of new high-strength steels allows attaining equivalent performances with lower thicknesses and significant weight reduction. The welding of new couples of steel grades requires development and control of joining processes. Thanks to high precision and good flexibility, laser welding became one of the most used processes for joining of dissimilar welded blanks. The prediction of the local chemical composition in the weld formed between dissimilar steels in function of the welding parameters is essential because the dilution rate and the distribution of alloying elements in the melted zone determines the final tensile strength of the weld. The goal of the present study i…
Ab initio multi-reference perturbation theory calculations of the ground and low-lying electronic states of the KRb molecule
2016
The potential energy curves of the low-lying electronic states correlating up to the limit K(4p) + Rb(5s) of KRb molecule have been calculated using the multi-reference perturbation theory method at the CASSCF/ XMCQDPT2 level of theory without and with spin–orbit coupling. The calculated parameters of the ground X 1 R + state are in the best agreement among all previously performed ab initio calculations for the KRb molecule. The calculated vibrational intervals of the ground electronic term of the 39 K 85 Rb molecule describe the experiment with the accuracy within ±1 cm ?1 . The calculated intensities of the 2 1 R + (v 0 = 3, J 0 = 26) ? X 1 R + (v 00 = 0...24, J 00 = 25, 27) transitions …
Full-dimensional control of the radiationless decay in pyrazine using the dynamic Stark effect
2014
We present a full quantum-mechanical study of the laser control of the radiationless decay between the B3u(nπ(*)) and B2u(ππ(*)) states of pyrazine using the dynamic Stark effect. In contrast to our previous study [Sala et al., J. Chem. Phys. 140, 194309 (2014)], where a four-dimensional model was used, all the 24 degrees of freedom are now included in order to test the robustness of the strategy of control. Using a vibronic coupling Hamiltonian model in a diabatic representation, the multi-layer version of the multi-configuration time-dependent Hartree method is exploited to propagate the corresponding wave packets. We still observe a trapping of the wavepacket on the B2u(ππ(*)) potential …
Approximate treatment of higher excitations in coupled-cluster theory. II. Extension to general single-determinant reference functions and improved a…
2008
The theory and implementation of approximate coupled-cluster (CC), in particular approximate CC singles, doubles, triples, and quadruples methods, are discussed for general single-determinant reference functions. While the extension of iterative approximate models to the non-Hartree-Fock case is straightforward, the generalization of perturbative approaches is not trivial. In contrast to the corresponding perturbative triples methods, there are additional terms required for non-Hartree-Fock reference functions, and there are several possibilities to derive approximations to these terms. As it turns out impossible to develop an approach that is consistent with the canonical Hartree-Fock-base…
Contextuality-by-Default: A Brief Overview of Ideas, Concepts, and Terminology
2016
This paper is a brief overview of the concepts involved in measuring the degree of contextuality and detecting contextuality in systems of binary measurements of a finite number of objects. We discuss and clarify the main concepts and terminology of the theory called “contextuality-by-default,” and then discuss generalizations of the theory to arbitrary systems of arbitrary random variables.