Search results for "coating"
showing 10 items of 2834 documents
Study of Mechanisms of Light-Induced Dissociation of Ru(dcbpy)(CO)2I2 in Solution down to 20 fs Time Resolution
2006
Mechanisms of the light-induced ligand exchange reaction of (trans-I) Ru(dcbpy)(CO)2I2 (dcbpy = 4,4'-dicarboxylic acid-2,2'-bipyridine) in ethanol have been studied by transient absorption spectroscopy. Ultraviolet 20 fs excitation pulses centered at 325 nm were used to populate a vibrationally hot excited pi bipyridyl state of the reactant that quickly relaxes to a dissociative Ru-I state resulting in the release of one of the carbonyl groups. Quantum yield measurements have indicated that about 40% of the initially exited reactant molecules form the final photoproduct. A 62 fs rise component in the transient absorption (TA) signal was observed at all probe wavelengths in the visible regio…
MoO (x≤2) ultrathin film growth from reactions between metallic molybdenum and TiO2 surfaces
2001
Abstract Exposures to oxygen at room temperature and annealings under vacuum were carried out on deposits obtained from molybdenum interacting with (1 1 0) TiO 2 surfaces in order to obtain molybdenum oxide ultra thin films. Exposures to oxygen at room temperature show that the interfacial molybdenum oxide layers resulting from the TiO 2 /Mo interactions are inactive towards oxygen whereas the metallic molybdenum clusters, which grew on top of the interfacial layers, oxidise into MoO 3 . Besides, during annealings under vacuum, substrate oxygen anions can diffuse into the deposit. Thus, between 400 and 500°C, molybdenum oxide layers are progressively oxidised into MoO 2 . Moreover, from the…
Reactivity between molybdenum and TiO2(110) surfaces: evidence of a sub-monolayer mode and a multilayer mode
2005
Small amounts of molybdenum (from 0.03 to 1.3 eqML) were deposited on non-stoichiometric TiO 2 (1 1 0) surface. The deposits were investigated by means of LEED and X-ray/UV photoemission using synchrotron radiation. For the smallest coverage (<0.2 eqML), deposition leads to oxidation of molybdenum into species close to Mo 4+ .In such a case, states appearing in TiO 2 band gap are mainly due to reduced titanium. For higher coverages, metallic behaviour of molybdenum is observed. This phenomenon was explained, thanks to first principle calculations, as a decrease of the Mo-O interactions for the benefit of the Mo-Mo interactions as the surface molybdenum atom density increases.
Improved stability of black lipid membranes by coating with polysaccharide derivatives bearing hydrophobic anchor groups
1986
Abstract Black lipid membranes were coated with modified polysaccharides bearing hydrophobic palmitoyl and cholesteryl moieties. The changes in membrane structure were investigated using dipicrylamine, a lipophilic ion, as membrane probe. The kinetics of ion transport through the black lipid membranes were studied using the charge pulse relaxation technique. With this technique it was found that it is possible to detect the insertion of the hydrophobic anchor groups of the polysaccharides into the membrane bilayer. As a result of the surface coating, these membranes exhibit a drastically increased long-term stability.
Ab initio modeling of copper adhesion on regular BaTiO3(001) surfaces
2005
Ab initio calculations have been performed for copper adsorption on a regular, defect-free TiO"2- and BaO-terminated (001) surfaces of a cubic BaTiO"3, using a posteriori HF-CC method as implemented into the CRYSTAL-03 computer code. To clarify the nature of the interfacial bonding, we use slab models of the Cu/BaTiO"3(001) interfaces with different one-side substrate coverages, varied from 1/8 monolayer (ML) up to 1/2 ML, over both TiO"2- and BaO-terminated surfaces. TiO"2 termination has been found to be energetically more favorable for the adsorption of copper atoms. In agreement with previous experimental and theoretical data, our calculations indicate essential contribution of atomic p…
Transport equations of electrodiffusion processes in the laboratory reference frame.
2006
The transport equations of electrodiffusion processes use three reference frames for defining the fluxes: Fick's reference in diffusion, solvent-fixed reference in transference numbers, and laboratory fluxes in electric conductivity. The convenience of using only one reference frame is analyzed here from the point of view of the thermodynamics of irreversible processes. A relation between the fluxes of ions and solvent and the electric current density is deduced first from a mass and volume balance. This is then used to show that (i) the laboratory and Fick's diffusion coefficients are identical and (ii) the transference numbers of both the solvent and the ion in the laboratory reference fr…
A vacuum cell for obtaining clean surfaces on liquid low melting point metals
1997
Abstract Clean oxide film-free surface of liquid gallium was obtained in a sealed vacuum cell with a glass lid for observation. The cell was evacuated to high vacuum (10 -4 Pa) before admission of liquid and sealing. The surface contamination was about 2–5% of the free area and did not exhibit noticeable increase during several months of storing and employing the cell. The cell described allows observation of surface flows, capillary phenomena and crystallization processes under different conditions.
On the relaxation mechanisms of 6-azauracil
2011
The nonadiabatic photochemistry of 6-azauracil has been studied by means of the CASPT2//CASSCF protocol and double-ζ plus polarization ANO basis sets. Minimum energy states, transition states, minimum energy paths, and surface intersections have been computed in order to obtain an accurate description of several potential energy hypersurfaces. It is concluded that, after absorption of ultraviolet radiation (248 nm), two main relaxation mechanisms may occur, via which the lowest (3)(ππ*) state can be populated. The first one takes place via a conical intersection involving the bright (1)(ππ*) and the lowest (1)(nπ*) states, ((1)ππ*/(1)nπ*)(CI), from which a low-energy singlet-triplet crossin…
Dopamine interaction with a polyamine cryptand of 1H-pyrazole in the absence and in the presence of Cu(ii) ions. Crystal structure of [Cu2(H−1L](ClO4…
2000
The crystal structure of the binuclear Cu2+ complex [Cu2(H−1L)](ClO4)3 ·2H2O of the cryptand L = 1,4,7,8,11,14,17,20,21,24,29,32,33,36-tetradecaazapentacyclo[12.12.12.1 6,9.119,22,1,31,34]hentetraconta-6,9(41), 19(40), 21,31,34(39)-hexaene is presented; evidence for the formation in solution of binary L–dopamine and ternary Cu2+–L–dopamine complexes is presented.
A Density Functional Theory study on gold cyanide interactions: The fundamentals of ore cleaning
2010
We have employed Density Functional Theory calculations to study the adsorption of CN, CN− and KCN on Au(111) and Au(211) surfaces and compare the obtained results to CO. The adsorption of CN, CN−, and KCN are exothermic with respect to the gas-phase moieties, and the adsorption energy increases at steps. Our results show that the binding mechanism of CN− is different from that of CO. The projected LDOS indicates that the bond between the flat surface and CN shows very small overlap between metal and CN states. This overlap increases provided that extra charge is present or low-coordinated Au atoms are available. Charge transfer is analyzed via the Bader method and the Electron Localization…