Search results for "dioxide"

Une méthode rapide et simple pour l'estimation de la position de la courbe de dissociation de l'oxyhémoglobine

1989

The methods currently available for assessing the oxyhaemoglobin dissociation curve parameters are expensive, lengthy, require a large volume of blood, and the results obtained are modified by anaesthetic gases. The equipment required for the method described includes: a microtonometre, microcuvettes, 3 gas bottles containing different oxygen, carbon dioxide and nitrogen mixtures (4.5%, 5.6%, 89.9%; 3.5%, 5.6%, 90.9%; 2.5%, 5.6%, 91.9% respectively), a microxymetre, and a micropHmetre. The samples in the microcuvettes are incubated at 37 degrees C in a gas flow of 45 ml.min-1 from the bottles. SO2 is then read using the microxymetre. P50, i.e. PO2 at 50% saturation, is calculated, as well a…

Iron deposition on TiO2(110): effect of the surface stoichiometry and roughness

1999

Abstract Characterizations of ultra-thin iron films deposited on TiO 2 (110) surfaces with different stoichiometries, roughnesses and crystallinities have been carried out by X-ray photoelectron spectroscopy (XPS) and Auger electron spectroscopy (AES). For a high initial roughness of the substrate, a 2D growth mode is observed up to three monolayers. But, if the initial roughness is low, clusters grow on the TiO 2 surface. Whatever the initial surface stoichiometry, electronic exchanges occur between titanium and iron leading to a reduction of titanium and an oxidation of iron. This interaction between iron and titanium dioxide surface takes place only at the interface between the metal and…

Earth Degassing in Tectonically Active Regions: New Evidences from Southern Italy and the Balkans

2022

Multi-doped Brookite-Prevalent TiO2 Photocatalyst with Enhanced Activity in the Visible Light

2018

© 2018 Springer Science+Business Media, LLC, part of Springer Nature Abstract: Enabling solar and/or visible light-driven photocatalysis is a crucial step to access innovative applications in environmental science and sustainable energy. Titanium dioxide is the most used photocatalyst because of its low cost and toxicity, however it is also limitedly active under visible light irradiation due to its wide band gap. Among its polymorphs, brookite holds promising optoelectronic properties for visible light photocatalysis, which have to the best of our knowledge been limitedly exploited. Here, a C,S,N-doped brookite-based TiO2has been prepared via a rapid one-pot sol–gel synthesis. Besides subs…

Electron Transfer from Organic Aminophenyl Acid Sensitizers to Titanium Dioxide Nanoparticle Films

2009

Electron transfer from three conjugated amino-phenyl acid dyes to titanium and aluminum oxide nanocrystalline films was studied by using transient absorption spectroscopy with sub 20 fs time-resolution over the visible spectral region. All the dyes attached to TiO2 showed long-lived ground state bleach signals indicative of formation of new species. Global analysis of the transient kinetics of the dyes on TiO2 revealed stimulated emission decays of about 40 fs and less than 300 fs assigned to electron injection. The same dyes on Al2O3 substrates displayed long stimulated emission decays (ns) suggesting that electron transfer is blocked in this high band gap semiconductor. For two of the dye…

Effect of sulfur dioxide on mucociliary activity and ciliary beat frequency in guinea pig trachea

1994

The effects of 30 min exposure to sulfur dioxide on mucociliary activity (MCA) and ciliary beat frequency (CBF) were studied in 31 guinea pig tracheas. MCA was measured by recording the light reflected from ciliated mucous membranes using an infrared bar code reader. CBF of single ciliated cells obtained by brushing was measured with phase-contrast microscopy. Each tracheal sample was exposed to SO2 at concentrations ranging from 2.5 to 12.5 ppm, or to air for control purposes. MCA and CBF were measured before and immediately after gas exposure. A reduction in mean MCA of 63% (P = 0.0007) and statistically insignificant changes in CBF (P > 0.05) were recorded at concentrations of 2.5 PPM SO…

X-Ray crystallographic and computational study on uranyl-salophen complexes bearing nitro groups.

2017

In the solid state, salophen–UO2 complexes bearing one, two, or three NO2 groups lack the pronounced ligand curvature that represents a structural hallmark for this class of compounds. A detailed structural study based on single-crystal X-ray crystallography and computational methods, comprising molecular dynamics, gas-phase Hartree Fock, and DFT calculations, was carried out to investigate the coordination properties of the uranyl cation.

Photocatalytic oxidation mechanism of benzonitrile in aqueous suspensions of titanium dioxide

2007

Abstract The photocatalytic oxidation of benzonitrile was carried out in aqueous suspensions (pH 11) of commercial polycrystalline TiO 2 (Merck and Degussa P25) irradiated by ultraviolet light. The rate of decomposition was dependent on the concentration of benzonitrile and followed a pseudo-first order kinetics. The complete mineralization of a 0.70 mM benzonitrile solution was achieved in ca. 8 h by using TiO 2 Degussa P25, whereas the substrate was only partially mineralized even after 14 h of irradiation in the presence of TiO 2 Merck. The final oxidation products were carbonate and nitrate. The appearance and the evolution of organic and inorganic intermediate species were also investi…

Carbon nanotube supported aluminum porphyrin-imidazolium bromide crosslinked copolymer

2022

The increased awareness of the catastrophic consequences caused by the accumulation of greenhouse gases into the atmosphere has generated a large mobilization aimed at CO2 mitigation. Herein, in the spirit of the transformation of a waste as CO2 into value added products, we propose an efficient preparation of two different hybrid systems based on aluminum chloride tetrastyrylporphyrin (TSP-Al-Cl) and 1,4-butanediyl-3,3′-bis-1-vinylimidazolium dibromide copolymerized in the presence (MWCNT-TSP-AlCl-imi) and in absence (TSP-AlCl-imi) of multi-walled carbon nanotubes (MWCNTs) for the CO2 utilization in the synthesis of cyclic carbonates. The so-prepared materials have been thoroughly characte…

A solid device based on doped hybrid composites for controlling the dosage of the biocide N-(3-aminopropyl)-N-dodecyl-1,3-propanediamine in industria…

2015

A colorimetric composite device is proposed to determine the widely used biocide N-(3-aminopropyl)-N-dodecyl-1,3-propanediamine (ADP).This sensing device is based on a film of 1,2-Naphthoquinone-4-sulfonate (NQS) embedded into polydimethylsiloxane-tetraethylortosilicate-SiO2 nanoparticles composite (PDMS-TEOS-SiO2NPs). Semiquantitative analysis can be performed by visual inspection. Digitalized image or diffuse reflectance (DR) measurements can be carried out for quantitative analysis. Satisfactory detection limit (0.018%, w/v) and relative standard deviations <12% were achieved. The proposed device has been applied for the determination of ADP in detergent industrial formulations with reco…