Search results for "dynamics"

Friction between Polymer Brushes in Good Solvent Conditions:  Steady-State Sliding versus Transient Behavior

2003

Previous molecular dynamics simulations of friction between polymer brushes in relative sliding motion [Kreer, T.; Muser, M. H.; Binder, K.; Klein, J. Langmuir 2001, 17, 7804] are extended beyond steady-state conditions. We study two different protocols:  (i) stop and return and (ii) stop and go. In protocol (i), the relative, lateral motion between the two surfaces is stopped abruptly and reimposed opposite to the initial direction after the system could relax for some time. Protocol (ii) is similar except that the sliding direction is maintained. In the constant-velocity steady state, the average lateral extension lc of the polymers is found to be a power law of the sliding velocity v, na…

Correlations of the nonexponentiality and state dependence of mechanical relaxations with bond connectivity in Ge-As-Se supercooled liquids

1992

We have studied the mechanical responses of supercooled Ge-As-Se liquids to flexural strains and temperature steps. The departures from exponential relaxation correlate well with the variations in connectivity. The structural state dependence of the mechanical relaxation, detected in pure and weakly cross-linked Se, is suppressed completely at the rigidity percolation threshold {l angle}{ital r}{sub {ital c}}{r angle}, where the liquid fragility is a minimum. The shapes of the decay functions of samples with the same {l angle}{ital r}{sub {ital c}}{r angle} but different compositions are not universal at {ital T}{sub {ital g}} probably because of chemical effects near the binary edges of th…

Coil-Globule Collapse of Polystyrene Chains in Tetrahydrofuran-Water Mixtures.

2018

We study the coil and globule states of a single polymer chain in solution by performing molecular dynamics simulations with a united atom model. Specifically, we characterize the structural properties of atactic polystyrene chains with N = 20–150 monomers in tetrahydrofuran–water mixtures at varying mixing ratios. We find that the hydrophobic polymers form rather open coils when the mole fraction of water, XW, is roughly below 0.25, whereas the chains collapse into globules when XW ≳ 0.75. We confirm the theoretically expected scaling laws for the radius of gyration, Rg, in these regimes, i.e., Rg ∝ N3/5 and Rg ∝ N1/3 for good and poor solvent conditions, respectively. For poor solvent con…

Solidification behavior of the theta system 2-propanol/poly(n-butyl methacrylate)

1995

Thermoreversible gelation of the system 2-propanol/poly (n-butyl methacrylate) — as detected by D'SC or dielectric experiments — does not manifest itself in a straightforward manner in the dynamic-mechanical properties. Its occurrence can, however, be seen in many ways: i) For constant composition of the system and a reference temperature lower than Tgel, the storage modulus G′ is larger than the loss modulus G″ in the glass transition zone of the master curve and both vary in an almost parallel manner with the angular frequency ω over almost two decades (whereas this feature is normally found for other gelling systems within the rubber plateau or the flow region). ii) The entanglement mole…

Microfluidic Pumping by Micromolar Salt Concentrations

2017

An ion-exchange-resin-based microfluidic pump is introduced that utilizes trace amounts of ions to generate fluid flows. We show experimentally that our pump operates in almost deionized water for periods exceeding 24h and induces fluid flows of um/s over hundreds of um. This flow displays a far-field, power-law decay which is characteristic of two-dimensional (2D) flow when the system is strongly confined and of three-dimensional (3D) flow when it is not. Using theory and numerical calculations we demonstrate that our observations are consistent with electroosmotic pumping driven by umol/L ion concentrations in the sample cell that serve as 'fuel' to the pump. Our study thus reveals that t…

Unusual crystallization kinetics in a hard sphere colloid-polymer mixture.

2008

We investigated the crystallization kinetics of a hard sphere colloid-polymer mixture at conditions where about 95% of solid coexists with about 5% of fluid. From time resolved Bragg and small angle light scattering, we find that the crystallite size increases with a power law of exponent alpha approximately 1/3 during both the conversion and the coarsening stage. This observation points to a single conserved order parameter for both stages and cannot be explained if the mixture is regarded as an effective one-component system. We alternatively suggest that--based on local geometric demixing--the polymer density takes the role of the conserved order parameter.

Escape transition of a compressed polymer mushroom under good solvent conditions

1999

The escape transition of a flexible polymer chain of chain length N, endgrafted at a hard wall and compressed by a piston of radius R, is studied by Monte Carlo simulation and by phenomenological arguments. In contrast to previous theories which have considered the transition as a function of a (fixed) height H of the piston above the wall, we consider the transition as a function of the conjugate variable, the force f acting on the piston. We find that the transition (which is sharp only for N → ∞) is characterized by a flat region of f in the f vs. H isotherm, i.e. a jump in the height occurs at the transition from Hesc,t to Himp,t, with (Himp,t − Hesc,t)/Hesc,t ≈ 0.26.

Quasielastic neutron scattering study of dynamics at the crossover from dilute to semidilute behavior in polymer solutions

1982

Mechanical And Thermophysical Properties Of Polymers And Chemical Structure: From Computer Simulations To Experimental Data

1988

Chemical structure is related to properties on the basis of results of computer modelling of mechanical behavior. An equation for the shift factor aT,c dependent on temperature T and concentration c is provided, connection to the chain relaxation capability noted, and potential application range of the approach discussed. Constituents of free volume are defined, and effects of individual constituents on mechanical properties.

Controlling the wetting properties of the Asakura-Oosawa model and applications to spherical confinement.

2012

We demonstrate for the Asakura-Oosawa model and an extension of this model that uses continuous rather than hard potentials, how wetting properties at walls can be easily controlled. By increasing the interaction range of the repulsive wall potential acting on the colloids (while keeping the polymer-wall interactions constant) polymers begin to substitute colloids at walls and the system can be driven from complete wetting of colloids via partial wetting to complete wetting of polymers. As an application, we discuss the morphology and wetting behavior of colloid-polymer mixtures in spherical confinement. We apply the recently developed 'ensemble switch method' where the Hamiltonian is exten…