Search results for "electrical conductivity."
showing 10 items of 42 documents
Monitoring pH and ORP in a SHARON reactor
2011
This paper analyses the valuable information provided by the on-line measurements of pH and oxidation reduction potential (ORP) in a continuous single high ammonia removal over nitrite (SHARON) reactor. A laboratory-scale SHARON reactor equipped with pH, ORP, electric conductivity and dissolved oxygen (DO) probes has been operated for more than one year. Nitrogen removal over nitrite has been achieved by adding methanol at the beginning of anoxic stages. Time evolution of pH and ORP along each cycle allows identifying the decrease in nitritation rate when ammonia is consumed during the aerobic phase and the end of the denitrification process during the anoxic phase. Therefore, monitoring pH…
Tuning the Direct and Indirect Excitonic Transitions of h-BN by Hydrostatic Pressure
2021
The pressure dependence of the direct and indirect bandgap transitions of hexagonal boron nitride is investigated using optical reflectance under hydrostatic pressure in an anvil cell with sapphire windows up to 2.5 GPa. Features in the reflectance spectra associated with the absorption at the direct and indirect bandgap transitions are found to downshift with increasing pressure, with pressure coefficients of −26 ± 2 and −36 ± 2 meV GPa–1, respectively. The GW calculations yield a faster decrease of the direct bandgap with pressure compared to the indirect bandgap. Including the strong excitonic effects through the Bethe–Salpeter equation, the direct excitonic transition is found to have a…
Origin of the Chemiresistive Response of Ultrathin Films of Conductive Metal–Organic Frameworks
2018
Conductive metal-organic frameworks are opening new perspectives for the use of these porous materials for applications traditionally limited to more classical inorganic materials, such as their integration into electronic devices. This has enabled the development of chemiresistive sensors capable of transducing the presence of specific guests into an electrical response with good selectivity and sensitivity. By combining experimental data with computational modelling, a possible origin for the underlying mechanism of this phenomenon in ultrathin films (ca. 30 nm) of Cu-CAT-1 is described. ispartof: ANGEWANDTE CHEMIE-INTERNATIONAL EDITION vol:57 issue:46 pages:15086-15090 ispartof: location…
Band Gap Engineering and Trap Depths of Intrinsic Point Defects in RAlO3 (R = Y, La, Gd, Yb, Lu) Perovskites
2021
The work was supported by the Polish National Science Centre (Project No. 2018/31/B/ST8/00774), by the NATO SPS Project G5647, and by the Ministry of Education and Science of Ukraine (Project DB/Kinetyka no. 0119U002249). L.V. acknowledges support of the National Research Foundation of Ukraine under Grant No. 2020.02/0373 “Crystalline phosphors’ engineering for biomedical applications, energy saving lighting and contactless thermometry”. Researchers from Tartu were supported by the ERDF fundings in Estonia granted to the Centre of Excellence TK141 “Advanced materials and high-technology devices for sustainable energetics, sensorics and nanoelectronics (HiTechDevices)” (Grant No. 2014-2020.4…
PEDOT thin films with n-type thermopower
2019
peer-reviewed Synthesis of n-type organic semiconductors is challenging as reduced states are difficult to obtain due to their instability in air. Here, we report tailoring of semiconducting behavior through control of surfactant concentration during synthesis of poly(3,4-ethylenedioxythiophene) (PEDOT) nanoparticles. Nanoparticles were synthesized by mini-emulsion polymerization, where stable suspensions were used to produce polymer films by a simple casting technique on polyethylene terephthalate (PET) substrates. Electrical conductivity and Seebeck coefficients were measured as a function of surfactant concentration. It was found that conductivity decreases three orders of magnitude as s…
Tetrathiotetracene thin film morphology and electrical properties
2015
The electrical properties of organic thin films are determined by their chemical constituents and the morphology of the films deposited. In this paper the morphology of vacuum sublimed (7?10-6 mbar) tetrathiotetracene (TTT) thin films is shown to be strongly affected by the thermal deposition temperature (222-350 K) and rate of deposition. Mostly needle-like morphologies are identified by scanning electron microscopy. Optimal TTT purity (a pre-requisite for device preparation via subsequent oxidation) is evidenced by their initially low electrical conductivity. Altering the TTT morphology, by variation of the evaporation parameters, strongly affects this base electrical conductivity. Four p…
Multifunctional properties of nanocomposites made by 1D and 2D graphene based fillers
2015
High aspect ratio graphene based fillers with different dimensionalities showed the ability to greatly modify rheological, mechanical, thermal and electrical properties of polymers at very low content. In this work, the effect of filler dimensionality on the multifunctional properties of an epoxy matrix reinforced by both carbon nanotubes (1D) and graphite nanoplatelets (2D) have been investigated across the percolation region. Keywords-- Carbon nanotube, Graphite nanoplatelet, nanocomposites, mechanical properties, ...
Space charge limited current mechanism in Bi2S3 nanowires
2016
We report on the charge transport properties of individual Bi2S3 nanowires grown within the pores of anodized aluminum oxide templates. The mean pore diameter was 80 nm. Space charge limited current is the dominating conduction mechanism at temperatures below 160 K. Characteristic parameters of nanowires, such as trap concentration and trap characteristic energy, were estimated from current-voltage characteristics at several temperatures.
Salt extraction from lime-based mortars: An experimental study using different poultice formulations
2020
Abstract The extractive capability of soluble salts in poultices treatments currently used in mortar conservation (ArbocelTM plus sepiolite; ArbocelTM, sepiolite and sand; Westox-Cocoon®) were tested to evaluate their efficiency and compatibility with specific mortar substrate. The pore size distribution of the experimental mortar substrate and of the blank dried poultices were preliminarily accomplished by mercury intrusion porosimetry (MIP). Desalination tests were carried out on specifically-formulated mortars after capillary absorption of Na2SO4 0.3 M solution. The efficiency of salt extraction was measured by means of electrical conductivity meter and ion chromatography. Among the test…
Poly(3,4-Ethylenedioxythiophene) nanoparticles as building blocks for hybrid thermoelectric flexible films
2019
Hybrid thermoelectric flexible films based on poly(3,4-ethylenedioxythiophene) (PEDOT) nanoparticles and carbon nanotubes were prepared by using layer-by-layer (LbL) assembly. The employed PEDOT nanoparticles were synthesized by oxidative miniemulsion polymerization by using iron(III) p-toluenesulfonate hexahydrate (FeTos) as an oxidant and poly(diallyldimethylammonium chloride) (PDADMAC) as stabilizer. Sodium deoxycholate (DOC) was used as a stabilizer to prepare the aqueous dispersions of the carbon nanotubes. Hybrid thermoelectric films were finally prepared with different monomer/oxidant molar ratios and different types of carbon nanotubes, aiming to maximize the power factor (PF). The …