Search results for "electron spectroscopy"
showing 10 items of 525 documents
XPS study of pumice-supported palladium and platinum catalysts
1992
An XPS study has been performed on samples of monometallic of palladium and platinum and on bimetallic Pd-Pt catalysts supported on pumice. A negative shift of about 0.5 eV in the Pd 3d and Pt 4f binding energies of the catalysis relative to the energies of the same levels in the pure metals suggested an increase in the electron density in both metals. A quantitative XPS analysis indicated that the supported metals did not modify the surface atomic composition of pumice
H2-TPR, XPS and TEM Study of the Reduction of Ru and Re promoted Co/γ-Al2O3, Co/TiO2 and Co/SiC Catalysts
2016
<p class="1Body">Effects of Ru and Re promoters on Co-CoO<sub>x </sub>catalysts supported on γ-Al<sub>2</sub>O<sub>3</sub>, TiO<sub>2</sub> and SiC were investigated to improve the understanding of the role of promoters of the active phase of Co-CoO<sub>x</sub>-Ru and Co-CoO<sub>x</sub>-Re. The influence of promoter addition on the composition and activity of the catalysts was characterized by several methods, such as H<sub>2</sub>-TPR, XPS, chemisorption and TEM. Furthermore, the role of support and metal-support interaction was especially studied and different support materials were compared.</p&g…
Support effect on the structure and CO oxidation activity of Cu-Cr mixed oxides over Al2O3 and SiO2
2009
Abstract Cu-Cr based catalysts supported on silica and alumina with 5 wt% total loading of (CuO + Cr2O3), in different molar ratios, were prepared by wet impregnation. The samples were studied by nitrogen adsorption isotherms (BET), temperature-programmed reduction (TPR), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS). Their catalytic activity was tested in the CO oxidation reaction. Different structures were obtained in dependence of the support, the atomic ratio and the calcination temperature. In particular, whereas on Al2O3 there was no experimental evidence for interaction between Cu and Cr, over the silica supported systems formation of new phases CuCr2O4 and CuCrO…
A photoemission study of molybdenum hexacarbonyl adsorption and decomposition on TiO2(110) surface.
2007
International audience; The adsorption and decomposition of molybdenum hexacarbonyl on (110) TiO2 surfaces were studied using both core levels and valence band photoemission spectroscopies. It was found that after an adsorption at 140 K, when going back to room temperature, only a small part of molybdenum compounds, previously present at low temperature, remained on the TiO2 surface. This indicates that the desorption temperature on such a surface is lower than the decomposition one. The use of photon irradiation to decompose the hexacarbonyl molecule was also studied. It was shown that during such a decomposition molecular fragments were chemisorbed on the surface allowing a higher amount …
Functionalization of Silver Nanowires Surface using Ag–C Bonds in a Sequential Reductive Method
2015
Silver nanowires (Ag-NW) assembled in interdigitated webs have shown an applicative potential as transparent and conducting electrodes. However, upon integration in practical device designs, the presence of silver oxide, which instantaneously forms on the Ag-NW surfaces in ambient conditions, is unwanted. Here, we report on the functionalization of Ag-NWs with 4-nitrophenyl moieties through A-C bonds using a versatile two step reduction process, i.e., ascorbate reduction combined electrografting. We show that 40% of the Ag atop sites were terminated and provide high surface stability toward oxidation for more than 2 months while keeping the same intrinsic conductivity as in bulk silver.
Structural and optical properties of Fe and Zn substituted CuInS2 nanoparticles synthesized by a one-pot facile method
2015
We substitute indium present in the CuInS2 ternary compound by iron and zinc using a facile one-pot synthesis method. The quaternary compound of CuIn1−xMxS2 (M = Fe and Zn) was synthesized by dissolving CuCl, InCl3, FeCl3, Zn(ac)2 and SC(NH2)2 as precursors in 1-octadecene, oleylamine and oleic acid as non-coordinating, coordinating and capping agent solvents, respectively. Oleic acid, oleylamine and thiourea were used respectively as a hard Lewis base, borderline Lewis base (in comparison with oleic acid) and soft Lewis base to form appropriate complexes. The complex formation, structure, and optical properties of CuIn1−xMxS2 (M = Fe and Zn) nanoparticles were studied by Fourier transform …
Phosphites as precursors in atomic layer deposition thin film synthesis
2021
We here demonstrate a new route for deposition of phosphorous based materials by atomic layer deposition (ALD) using the phosphites Me3PO3 or Et3PO3 as precursors. These contain phosphorous in the oxidation state (III) and are open for deposition of reduced phases by ALD. We have investigated their applicability for the synthesis of LiPO and AlPO materials and characterized their growth by means of in situ quartz crystal microbalance. Phosphites are good alternatives to the established phosphate-based synthesis routes as they have high vapor pressure and are compatible with water as a coreactant during deposition. The deposited materials have been characterized using XPS, x-ray fluorescence…
Improvement of photocatalytic and photoelectrochemical activity of ZnO/TiO2 core/shell system through additional calcination: Insight into the mechan…
2017
Abstract ZnO/TiO2 composites were prepared by sol-gel deposition of TiO2 on ZnO nanorods hydrothermally grown on electrically conductive indium tin oxide substrate (ITO). It has been shown that the ZnO/TiO2 interface plays a key role in enhancement of photodecomposition of methylene blue (MB) used as a model test pollutant, under monochromatic light irradiation (400 nm). The increase of photocatalytic activity was attributed to the shift of absorption edge of ZnO/TiO2 towards visible light in comparison with bare TiO2. Further enhancement of photocatalytic activity of ZnO/TiO2 was achieved through its additional calcination at 450 °C for 3 h. This treatment brings 40% increase in the rate o…
Laser ablation of a silicon target in chloroform: formation of multilayer graphite nanostructures
2013
With the use of high-resolution transmission electron microscopy, selected area electron diffraction and x-ray photoelectron spectroscopy methods of analysis we show that the laser ablation of a Si target in chloroform (CHCl3) by nanosecond UV pulses (40 ns, 355 nm) results in the formation of about 50–80 nm core–shell nanoparticles with a polycrystalline core composed of small (5–10 nm) Si and SiC mono-crystallites, the core being coated by several layers of carbon with the structure of graphite (the shell). In addition, free carbon multilayer nanostructures (carbon nano-onions) are also found in the suspension. On the basis of a comparison with similar laser ablation experiments implement…
Enhancing the photocatalytic properties of PbS QD solids: the ligand exchange approach.
2019
Surface engineering of nanomaterials is a promising tool towards the design of new materials for conversion of solar energy into chemical energy. In this work, we examine the influence of ligand exchange on the photocatalytic performance of solution-processed PbS films. We test different ligands such as oleylamine (OAm), 1,2-ethanedithiol (EDT), 3-mercaptopropionic acid (MPA) and tetrabutylammonium iodide (TBAI). The study demonstrates that PbS films capped with MPA and EDT exhibit 3.5-fold enhanced photocatalytic performance for the photodecomposition of methyl orange upon sunlight exposure. Both band energy alignment and charge carrier transport have a strong impact on the generation of r…