Search results for "electron spectroscopy"
showing 10 items of 525 documents
Angular-resolved electron spectroscopy from (110) surfaces of ternary Ce-based intermetallics: CePd2Si2 and CeNi2Ge2
1997
Investigations of electronic properties were carried out for the ternary Ce-based intermetallic systems CeT2X2 (T = Ni, Pd; X = Ge, Si). To produce well-ordered and atomically clean surfaces, preparation is carried out in UHV. The polycrystalline substance was evaporated on a W(110) substrate with subsequent annealing. The single-crystalline layers obtained are characterised by MEED (thickness), AES (surface stoichiometry), LEED and SEM (surface structure). For electron-spectroscopic investigations, ARUPS (angle-resolved photoemission spectroscopy) was used. In the photoemission spectra, dispersion effects could be detected by variation of the detection angle.
Preparation by radio-frequency magnetron co-sputtering and characterization of thin films of lanthanum–strontium ferromanganites
2005
Abstract (La 0.8 Sr 0.2 )(Mn 1 − y Fe y )O 3 ± δ films with y = 0, 0.2, 0.5, 0.8 and 1, a few hundred nanometers thick, were deposited onto polycrystalline yttria-stabilized zirconia YSZ by a magnetron co-sputtering technique using individual targets of La 0.8 Sr 0.2 MnO 3 and La 0.8 Sr 0.2 FeO 3 . The deposition parameters, substrate temperature and gas pressure, were studied by scanning electron microscopy, energy dispersive X-ray spectrometry, X-ray diffraction and interferential microscopy for their effects on the morphological, chemical, topographic and crystallographic properties of films and YSZ-film interfaces. (La 0.8 Sr 0.2 )(Mn 1 − y Fe y )O 3 ± δ thin films were found to be …
The growth of oxide platelets on nickel in pure oxygen. II. Surface analyses and growth mechanism
1993
The structural properties of NiO platelets emerging from a primary oxide layer by oxidation of pretreated nickels in pure oxygen between 650 and 800° C have been investigated in relation with the initial metallic layers and the primary oxide. Surface composition and segregation of impurities were also studied by X-ray photoelectron spectroscopy and Auger electron spectroscopy. Textural properties and structural orientation of both the primary oxide layer and the platelets were analyzed by X-ray diffraction and transmission electron microscopy. Platelets grew along {111} planes, leading to elliptical or semicircular bicrystals. The driving force for the present type of growth originates from…
Technical Note:Study of the Cl−-Induced Breakdown of the Passive Layer on Steel
1991
Abstract The Cl−-induced breakdown of the passive layer on a standard steel has an induction time that increases in a nearly linear fashion with the previous holding time (at the passivation potent...
Effect of the surface stoichiometry on the interaction of Mo with TiO2 (110)
2000
Abstract Molydenum has been deposited at room temperature on (110) TiO2 surfaces with different stoichiometries, roughnesses and crystallinities. Whatever the substrate preparation is, in-situ Auger electron spectroscopy (AES) and X-ray photoelectron spectroscopy (XPS) studies as well as ex-situ atomic force microscopy (AFM) and reflexion high-energy electron diffraction (RHEED) studies reveal a Stranski–Krastanov growth mode: the completion of three monolayers followed by islands growth is observed in every case. The three monolayers are always composed of amorphous molybdenum oxide with an oxidation state of molybdenum less than IV. The oxidation of the molybdenum layers generates Ti3+ an…
Initial chemical transport of reducing elements and chemical reactions in oxide cathode base metal
2002
Abstract In the present work, the formation of compounds associated to the diffusion of reducing elements (Mg and Al) to the nickel surface of a one-piece oxide cathode has been studied. Those compounds have been evidenced after the annealing steps at high temperature performed on cathode base metal prior to the emitting coating deposition. Therefore, they form the “initial” interface between the nickel and the coating, in other words, the interface existing at the beginning of cathode life. Extensive analysis to characterize the nickel base prior to coating deposition has been performed by means of scanning electron microscopy (SEM) coupled with energy dispersive X-ray spectroscopy (EDX), …
Diamond nucleation on iridium: local variations of structure and density within the BEN layer
2009
Abstract The diamond nuclei generated by the bias enhanced nucleation (BEN) on iridium are gathered in well defined areas (“domains”). In atomic force microscopy (AFM) measurements they become manifest in a 1 nm downward step. The fine structure of the carbon layer inside and outside these domains has been studied by small spot Auger electron spectroscopy (AES), high resolution transmission electron microscopy (HRTEM), AFM and lateral force microscopy (LFM). The Auger spectra of the carbon KLL peak taken in an ultra high vacuum setup revealed diamond features inside and more graphitic features outside the domains. The comparison with the intensity of the Auger signal originating from the un…
Influence of the passive film properties and residual stresses on the micro-electrochemical behavior of duplex stainless steels
2010
In the present paper, the chemical composition of passive films formed on both phases of two types of duplex stainless steels (UNS S31803 and UNS S32304) is determined at the micro-scale using Auger electron spectroscopy (AES). Samples were either mechanically polished (down to diamond pastes) or electrochemically etched in acidic solutions. The micro-electrochemical behavior of samples was then determined in sodium chloride media by means of the electrochemical micro-cell technique (capillary diameters of 30 μm). The results obtained were analyzed considering the passive film chemical composition. Quantitative relationships between electrochemical parameters and the distribution of chromiu…
Passive properties of lean duplex stainless steels after long-term ageing in air studied using EBSD, AES, XPS and local electrochemical impedance spe…
2013
Abstract Passivity of duplex stainless steel was studied after long-term ageing in air using local electrochemical impedance spectroscopy, AES, XPS and EBSD. After mechanical polishing, the passive film was homogeneous and had a capacitive behaviour described by the CPE. After long-term ageing, a small thickening was detected and O2−/OH− was significantly higher in the austenite than in the ferrite. Austenite behaved as a blocking electrode whereas two capacitive loops were observed in the ferrite (low value of O2−/OH). The loop at high frequencies was related with the oxygen reduction and the loop at low frequencies was connected with the passive film.
Generic Method for Modular Surface Modification of Cellulosic Materials in Aqueous Medium by Sequential Click-Reaction and Adsorption
2012
A generic approach for heterogeneous surface modification of cellulosic materials in aqueous medium, applicable for a wide range of functionalizations, is presented. In the first step, carboxymethyl cellulose (CMC) modified with azide or alkyne functionality, was adsorbed on a cellulosic substrate, thus, providing reactive sites for azide–alkyne cycloaddition click reactions. In the second step, functional units with complementary click units were reacted on the cellulose surface, coated by the click-modified CMC. Selected model functionalizations on diverse cellulosic substrates are shown to demonstrate the generality of the approach. The concept by sequentially combining the robust physic…