Search results for "electronics"

Frictional behaviour of oxygen diffusion hardened titanium in dry sliding against Co–28Cr–5W–4Fe–3Ni–1Si cobalt alloy

2004

Abstract The results of conformal pin-on-disc tribological tests of a hard layer of the solid solution of oxygen in α-titanium sliding against a Co–28Cr–5W–4Fe–3Ni–1Si cobalt alloy counterspecimen are presented. The α-Ti(O) layer was diffusely produced over 2–8 h of oxidising in the superficial zone of a technical quality titanium specimen. The friction and wear responses of the system were recorded and the wear mechanisms were studied. Investigations of the material structure and chemical constitution in micro-areas of the titanium specimen, cobalt alloy counterspecimen and wear debris formed in dry sliding were performed with a Philips XL20 microscope equipped with an EDAX analyser. Crush…

Structural and spectral properties of ZnO nanorods by wet chemical method for hybrid solar cells applications

2015

Abstract The synthesis of ZnO nanorods on transparent conducting oxides, Al doped ZnO seed layer on glass substrate (AZO) and indium tin oxide substrate (ITO) by using zinc nitrate hexahydrate (Zn (NO3)2·6H2O) and hexamethylenetetramine (HMT, (CH2)6N4 as raw materials is presented. The ZnO seed layer was fabricated by depositing an Al-doped ZnO thin film on glass substrate by sputtering. The effect of seeding on (AZO) and (ITO) substrate by using the wet chemical route growth of ZnO nanorods was investigated. The synthesized nanostructures of ZnO were characterized by X-ray diffraction (XRD), UV–vis absorption spectroscopy, scanning electron microscopy (SEM) and high-resolution transmission…

Study of tritium and helium generation and release from lead-lithium eutectics Li15.7Pb under neutron irradiation

2019

Abstract This paper describes the experiments on study of tritium and helium generation and release processes from lead-lithium eutectics Li15.7Pb. The irradiation was performed at the IVG.1M research reactor at 6 MW of thermal power. The irradiation temperature increased step by step from 225 to 550 °C. A qualitative assessment of the experimental results showed that as the temperature rises above 390 °C, the tritium flux from the sample consisting of T2 and HT molecules decreases. It was concluded that the observed effect is similar to the previously observed one for lead-lithium eutectics with Li17Pb83 composition.

Structural and Magnetic Properties of Epitaxial Ni<sub>2</sub>MnGa Thin Films

2009

We report on the preparation and investigation of epitaxial thin films of the magnetic shape memory alloy Ni2MnGa. For samples close to the stoichiometric composition we find that the phase transformation temperature is affected by the crystallographic orientation. Changes in the crystal structure due to the transformation are observed using temperature-dependent X-ray diffraction. Films with higher manganese content are in the martensitic state at room temperature. Those samples on Al2O3(11-20) reveal the 7-layered orthorhombic structure that allows strains up to 10 %. To avoid blocking of magnetostrictive effects by the substrate, free-standing films are prepared using water-soluble NaCl(…

Unconventional optically active solids in san jose

1990

Reactive sputtering of nanostructured multilayer coatings and their tribological properties

1999

Abstract The present study describes and reports on reactive sputtering of nanostructured multilayer coatings. A 3 μm coating for instance may contain up to a few thousand bilayers of two different film materials, and in order to achieve this, a substrate holder rotates through two different sputtering zones in an Alcatel SC 650 sputtering equipment with metal and carbon cathodes operating concurrently in the so-called side-by-side configuration. In reactive sputtering of nitrides, reactive nitrogen was controlled very accurately in order to establish controllable points on a total sputtering pressure versus nitrogen flow curve. Nanostructured multilayer coatings of the type MeN/C–N were de…

Electrostatic Control over Optically Pumped Hot Electrons in Optical Gap Antennas

2020

International audience; We investigate the influence of a static electric field on the incoherent nonlinear response of an unloaded electrically contacted nanoscale optical gap antenna. Upon excitation by a tightly focused near-infrared femtosecond laser beam, a transient elevated temperature of the electronic distribution results in a broadband emission of nonlinear photoluminescence (N-PL). We demonstrate a modulation of the yield at which driving photons are frequency up-converted by means of an external control of the electronic surface charge density. We show that the electron temperature and consequently the N-PL intensity can be enhanced or reduced depending on the command polarity a…

Electrogeneration of Diiodoaurate in Dimethylsulfoxide on Gold Substrate and Localized Patterning

2016

International audience; A localized etching of gold surface by scanning electrochemical microscope technique is presented where a dimethylsulfoxide-based electrolyte charged with iodine is used. The electrogenerated triiodide ion at the platinum ultramicroelectrode tip (feedback mode) acts as an oxidant for gold surface. The effects of electrode diameter and the bias time have been investigated. The approach curve method was used to hold the electrode tip close to the gold surface. A scanning electron microscope is used to observe the etched gold surfaces where disk-shaped dots are generated. The diameter of these holes depends directly on the Pt electrode diameter and the bias time.

Microwave characterization and modeling of packaged HEMTs by a direct extraction procedure at cryogenic temperatures

2004

In the present work we employ a direct extraction procedure to determine small signal equivalent circuit of microwave GaAs FETs by means of scattering (S-) parameter measurements down to cryogenic temperatures. The direct extraction procedure was tested on packaged AlGaAs/InGaAs HEMTs and good agreement between the simulated and measured S-parameters was obtained at different bias and temperature conditions. We employed a properly designed cryogenic set-up operating in our laboratory that allows to perform DC and RF characterization down to 30 K.

Colloidal plasmonic back reflectors for light trapping in solar cells.

2014

A novel type of plasmonic light trapping structure is presented in this paper, composed of metal nanoparticles synthesized in colloidal solution and self-assembled in uniform long-range arrays using a wet-coating method. The high monodispersion in size and spherical shape of the gold colloids used in this work allows a precise match between their measured optical properties and electromagnetic simulations performed with Mie theory, and enables the full exploitation of their collective resonant plasmonic behavior for light-scattering applications. The colloidal arrays are integrated in plasmonic back reflector (PBR) structures aimed for light trapping in thin film solar cells. The PBRs exhib…