Search results for "electronics"
showing 10 items of 4340 documents
Broadband Tuning of Four-Wave Mixing Bands Using Photonic Crystal Fibers
2016
We present an experimental study of the shift with temperature of widely-spaced FWM parametric bands generated in an ethanol-inflltrated photonic crystal fiber. We report broadband tuning of 175 nm and over 500 nm for the signal and idler bands, respectively, achieved through the thermo-optic effect. Numerical calculations were carried out and show good agreement with experimental data.
High-harmonic km-long self-pulsed Raman fiber laser
2011
Raman all-fiber lasers have attracted considerable interest during the past two decades due to their convenient use and extended wavelength coverage when compared to rare-earth-doped fiber lasers. Still, little is known about their potential as pulsed laser sources. Mode locked Raman fiber lasers have been demonstrated quite recently [1,2], as well as harmonic mode-locking with a record of 500,000 intra-cavity pulses in a dissipative four-wave mixing configuration using a fiber Bragg grating [3].
Wide wavelength-tunable passive mode-locked Erbium-doped fiber laser with a SESAM
2021
Abstract In this work we present a simple polarization-maintaining wavelength-tunable passive mode-locked Erbium-doped fiber laser with a semiconductor saturable absorber mirror (SESAM) as a mode locker. The cavity includes a Sagnac interferometer-based fiber optical loop mirror (FOLM) as a wide wavelength-tunable filter. Tunable mode-locking was experimentally achieved in the range of 1543.2 nm to 1569.5 nm by thermally adjustment of FOLM wavelength reflection. The output pulses have a repetition rate of 11.16 MHz with pulse duration about 0.9 ps. The experimental results were confirmed by numerical simulations.
Transparent conductive oxide photonic crystals on textured substrates
2011
Three-dimensional ZnO:Al photonic crystals were fabricated by atomic layer deposition on highly textured substrates. It turns out that these inverted opals consist of a thin intermediate disordered layer close to the textured substrate followed by a highly-ordered photonic crystal layer. The photonic crystals themselves exhibit comparable optical properties to those on planar substrates.
Tapering photonic crystal fibres for supercontinuum generation with nanosecond pulses at 532nm
2008
Experimental results on supercontinuum generation in photonic crystal fibre tapers using pump pulses of 7 ns duration at 532 nm are presented. Photonic crystal fibre tapers with the first wavelength of zero dispersion around 532 nm were fabricated. The generation of supercontinuum was investigated in normal and anomalous dispersion regimes. Supercontinuum spectra spanning more than 400 nm in the visible region are reported.
Actively mode-locked fiber laser with an acousto-optic in-fiber superlattice modulator
2009
All-fiber lasers permit the development of efficient, robust and compact coherent light sources. However, all-fiber active mode-locking is a challenging objective and very few all-fiber techniques have been published [1–3]. The development of a low-insertion-loss acoustically-induced superlattice modulator that works in the MHz range has demonstrated its suitability to perform active mode-locking of an all-fiber laser. While travelling extensional acoustic waves launched along a fiber Bragg grating (FBG) produce stationary side bands and a frequency shift [4,5], we found that the excitation of a standing extensional acoustic wave should produce no frequency shift, but the amplitude modulati…
Surface Periodic Poling in Lithium Niobate and Lithium Tantalate
2005
Periodic Poling of Lithium Niobate crystals (PPLN) by means of electric field has revealed the best technique for finely tailoring PPLN structures and parameters, which play a central role in many current researches in the field of nonlinear integrated optics. Besides the most studied technique of bulk poling, recently a novel technique where domain inversion occurs just in a surface layer using photoresist or silica masks has been devised and studied. This surface periodic poling (SPP) approach is best suited when light is confined in a thin surface guiding layer or stripe, as in the case of optical waveguide devices. Also, we found that SPP respect to bulk poling offers two orders of magn…
Silica masks for improved surface poling of lithium niobate
2005
Surface periodic poling of congruent lithium niobate was performed with the aid of photolithographically defined silica masks. The latter helped improving the control of duty cycle in the periodic domain poling, with 50:50 mark-to-space ratios. The role of silica was ascertained by numerically solving the Poisson equation.
Feedback Biasing Based Adjustable Gain Ultrasound Preamplifier for CMUTs in 45nm CMOS
2018
As CMOS technology is scaled down, supply voltages are decreasing and intrinsic gain of the nanoscale CMOS transistors is dropping while the threshold voltages of transistors are remaining relatively constant. In such scaled down nanoscale CMOS technologies, conventional vertical stacking architectures (for example. cascode architectures) for high-gain becomes no more attractive. In this paper we present the analysis and design of a feedback biasing based adjustable gain ultrasound preamplifier which is capable of amplifying signals from 15 MHz to 45 MHz from Capacitive Micromachined Ultrasound Transducers (CMUTs) in 45nm CMOS technology for medical ultrasound imaging applications. From the…