Search results for "electronics"
showing 10 items of 4340 documents
Reduced efficiency roll-off in light-emitting diodes enabled by quantum dot–conducting polymer nanohybrids
2014
We demonstrate QLEDs implementing wider active layers (50 nm) based on QD–conducting polymer nanohybrids, which exhibit a stable operational device performance across a wide range of current densities and brightness. A comparative study reveals that the significant suppression of efficiency roll-off in the high current density regime is primarily attributed to a sufficient charge carrier distribution over the wider active layer and improved charge carrier balance within QDs enabled by the hybridization of QDs with conducting polymers. Utilization of this finding in future studies should greatly facilitate the development of high performance, stable QLEDs at high current density or luminance…
Tailored conjugated polymer Langmuir-Schafer thin films in sensing transistors
2004
Organic Thin Film Transistors (OTFTs) have been fabricated, in a standard bottom gate configuration, with Langmuir-Schäfer (LS) or cast thin films of regioregular poly[1,4-(2,5-dioctyloxyphenylene)-2,5-thiophene], synthesized via an organometallic protocol, as active layers. The transistors electrical characterization has evidenced that LS based devices exhibit better performance level than cast film ones. Appealing perspectives for newly substituted conjugated polymers in OTFT sensing devices are discussed.
Thermal sensor based on a polymer nanofilm
2016
In this work, we have developed a thermal sensor based on poly(3,4 ethylenedioxythiophene) (PEDOT) nanofilms as thermoelectric material. The PEDOT nanofilms have been synthesized by the electrochemical polymerization method. The thicknesses of the films were around 120 nm. The doping level of PEDOT was controlled by chemical reduction using hydrazine. The achieved Seebeck coeficient is 40 uV/K. A PEDOT nanofilm was integrated into an electronic circuit that amplifies the voltage originated from the Seebeck effect. The temperature increment produced by a fingerprint touching the film is enough to switch on a light emitting diode. Peer Reviewed
External knowledge sourcing in different national settings: a comparison of electronics establishments in Britain and France
2004
04001; International audience; In a detailed comparison of matched samples of electronics establishments in Britain and France, this paper finds that the two samples of establishments were operating in distinctively different national labour markets for engineers and scientists, reflecting structural differences in national higher education systems and a far higher level of individual mobility between enterprises in Britain than is found in France. These differences were found to have very little effect on quantitative measures of establishments' external research interactions which tended to reflect other national-institutional differences such as continued government support for public la…
Transitions in consumption behaviors in a peer-driven stochastic consumer network
2019
Abstract We study transition phenomena between attractors occurring in a stochastic network of two consumers. The consumption of each individual is strongly influenced by the past consumption of the other individual, while own consumption experience only plays a marginal role. From a formal point of view we are dealing with a special case of a nonlinear stochastic consumption model taking the form of a 2-dimensional non-invertible map augmented by additive and/or parametric noise. In our investigation of the stochastic transitions we rely on a mixture of analytical and numerical techniques with a central role given to the concept of the stochastic sensitivity function and the related techni…
On Fixed Point (Trial) Methods for Free Boundary Problems
1992
In this note we consider the trial methods for solving steady state free boundary problems. For two test examples (electrochemical machining and continuous casting) we discuss the convergence of a fixed point method. Moreover, using the techniques of shape optimization we introduce a modification of the method, which gives us superlinear convergence rate. This is also confirmed numerically.
Automatic Processing Scheme for Low Laser Invasiveness Electro Optical Frequency Mapping mode
2016
International audience; Electro optical techniques are efficient backside contactless techniques usually used for design debug and defect location in modern VLSI. Unfortunately, the signal to noise ratio is quite low and depends on laser power with potential device stress due to long acquisition time or high laser power, especially in up to date technologies. Under these conditions, to maintain a good signal or image quality, specific signal or image processing techniques can be implemented. In this paper, we proposed a new spatial filtering by stationary wavelets and contrast enhancement which allows the use of low laser power and short acquisition time in image mode.
A General Investigation on the Differential Leakage Factor for Symmetrical and Asymmetrical Multiphase Winding Design
2020
This work provides an investigation based on a fast estimation of the degree of unbalance (D.U.%) and the differential leakage factor (&sigma
Experimental System Identification and Black Box Modeling of Hydraulic Directional Control Valve
2015
Directional control valves play a large role in most hydraulic systems. When modeling the hydraulic systems, it is important that both the steady state and dynamic characteristics of the valves are modeled correctly to reproduce the dynamic characteristics of the entire system. In this paper, a proportional valve (Brevini HPV 41) is investigated to identify its dynamic and steady state characteristics. The steady state characteristics are identified by experimental flow curves. The dynamics are determined through frequency response analysis and identified using several transfer functions. The paper also presents a simulation model of the valve describing both steady state and dynamic charac…
Graphene p-Type Doping and Stability by Thermal Treatments in Molecular Oxygen Controlled Atmosphere
2015
Doping and stability of monolayer low defect content graphene transferred on a silicon dioxide substrate on silicon are investigated by micro-Raman spectroscopy and atomic force microscopy (AFM) during thermal treatments in oxygen and vacuum controlled atmosphere. The exposure to molecular oxygen induces graphene changes as evidenced by a blue-shift of the G and 2D Raman bands, together with the decrease of I2D/IG intensity ratio, which are consistent with a high p-type doping (∼1013 cm-2) of graphene. The successive thermal treatment in vacuum does not affect the induced doping showing this latter stability. By investigating the temperature range 140-350 °C and the process time evolution, …