Search results for "feature"
showing 10 items of 4091 documents
A simulation tool for analysis and design of reverse electrodialysis using concentrated brines
2015
Abstract Reverse electrodialysis (SGP-RE or RED) represents a viable technology for the conversion of the salinity gradient power into electric power. A comprehensive model is proposed for the RED process using sea or brackish water and concentrated brine as feed solutions. The goals were (i) reliably describing the physical phenomena involved in the process and (ii) providing information for optimal equipment design. For such purposes, the model has been developed at two different scales of description: a lower scale for the repeating unit of the system (cell pair), and a higher scale for the entire equipment (stack). The model was implemented in a process simulator, validated against orig…
A two-stage fault detection and classification for electric pitch drives in offshore wind farms using support vector machine
2017
This article presents a two-stage fault detection and classification scheme, for induction motor drives in wind turbine pitch systems. The presented approach is suitable for application in offshore wind farms. The adopted strategy utilizes three phase motor current sensing at the pitch drives for fault detection and only when a fault is detected at this stage, features extracted from the current signals are transmitted to a central support vector machine classifier. The proposed method is validated in a laboratory setup of the pitch drive.
Patterned wafer segmentation
2003
This paper is an extension of our previous work on the image segmentation of electronic structures on patterned wafers to improve the defect detection process on optical inspection tools. Die-to-die wafer inspection is based upon the comparison of the same area on two neighborhood dies. The dissimilarities between the images are a result of defects in this area of one of the die. The noise level can vary from one structure to the other, within the same image. Therefore, segmentation is needed to create a mask and apply an optimal threshold in each region. Contrast variation on the texture can affect the response of the parameters used for the segmentation. This paper shows a method to antic…
Range image binarization: applications to wooden stamps analysis
2003
This paper deals with the analysis of ancient wooden stamps. The aim is to extract a binary image from the stamp. This image must be the closer to the image produced by inking and using a printing press with the stamps. A range image based method is proposed to extract a stamped image from the stamps. The range image acquisition from a 3D laser scanner is presented. Pre-filtering for range image enhancement is detailed. The range image binarization method is based on an adaptive thresholding. Few simple processes applied on the range image enable a final binarized image computing. The proposed method provides here a very efficient way to perform "virtual" stampings with ancient wooden stamp…
Identification of the inertial model for innovative semi-immergible USV (SI-USV) drone for marine and lakes operations
2015
The proposed project shows the results obtained in the implementation and testing in lacustrine and marine environment of a nautical remote controlled vehicle with surface navigation and innovative features Semi-Immergible (SI-USV). This vehicle is based on a pending patent belonging to Palermo University (Patent Pending RM2012A000209 and Patent RM2014Z000060) concerning innovative semi-immersible vehicles (SI-Drone), that can be remotely controlled from the ground, air, satellite and sea also during the semi-immersible operation. Given its low draft, the electric powered vehicle, coupled with jet propulsion, makes it possible to navigate in shallow waters, coastal shipping or sandbars.
Urban public transport optimization by bus ways: a neural network-based methodology
2007
This paper describes an approach for planning the introduction of bus lanes into the urban road network, that has been applied to the urban area of Palermo. The proposed modelling tool adopts a multi-agent objective function expressing the trade-off between the interests of diverse stakeholders: the generalized transport cost for car drivers and the travel time for public transport users. The reaction of car traffic to a certain planning scenario has been simulated by the DUE assignment technique and the positive impact of the modal shift on the objective function has been tackled by attaching a suitable weight to the time saving for bus passengers. The rise in the bus travel speed, owing t…
Cross-Flow Turbine Design For Energy Production And Discharge Regulation
2015
Cross-flow turbines are very efficient and cheap turbines that allow a very good cost/benefit ratio for energy production located at the end of conduits carrying water from a water source to a tank. In this paper a new design procedure for a cross-flow turbine working with a variable flow rate is proposed. The regulation of the head immediately upstream the turbine is faced by adopting a shaped semicircular segment moving around the impeller. The maximum efficiency of the turbine is attained by setting the velocity of the particles entering the impeller at about twice the velocity of the rotating system at the impeller inlet. If energy losses along the pipe are negligible, the semicircular …
How to formulate an accident prediction model for urban intersections.
2009
Several safety prediction models and methods have been developed to eliminate the relationship between the expected accident frequency and various urban intersection geometry and operational attributes. It is generally accepted that accident rates tend to be higher at intersections than on through sections of a road. This is particularly frequent in urban area where roads are characterized by intersections in close succession; moreover, the safe and effective operations of the urban road system can be significantly affected by safety conditions at intersections. In this paper models and methods designed to understand and to predict the accident process at urban intersections are reviewed. I…
The Area Of The Strait Reading Theories And Strategies For A Metropolitan Dimension
2016
Abstract Extending across a peninsular strip going from Gioia Tauro to Melito Porto Salvo on the Calabrian side, and from Milazzo to Giardini Naxos on the Sicilian side, the Strait of Sicily sees theAspromonte massif and the Peloritani mountain range as two facing stage sets of land sketching in the gulf a water piazza of a landscaping room. Described in the proposal by Giuseppe and Alberto Samona, Ludovico Quaroni, Antonio Quistelli, Sergio Musmeci, Paolo D’Orsi Villani and Leonardo Urbani, it outlines, in the county seats of Reggio Calabria and Messina, the prevalence of a Euclidean space, identifiable in the exact metrics given by the recurrence of the measuring step of the blocks drawn …
Multicriteria evaluation of heating choices for a new sustainable residential area
2015
Abstract The city of Loviisa in Finland is planning a new sustainable residential area with a total of 240,000 m2 of residential houses and apartment buildings with services. The city wants to promote sustainable energy solutions in the area, considering various renewable energy forms for heating. The aim of this research is to evaluate which heating system would be best for a new single-family house when different technical, economic, environmental and usability criteria are considered. A group of experts evaluated the alternative heating systems with respect to the criteria. The citizens were involved with a questionnaire to provide preference information for different criteria. Altogethe…