Search results for "ferroelectric"

showing 10 items of 374 documents

Nonresonant hole burning spectroscopy of the relaxor ferroelectric PLZT

2002

Abstract The polydispersive dielectric response of a lanthanum-modified lead zirconate titanate relaxor ferroelectric was studied using nonresonant hole burning (NHB) spectroscopy. The dynamic heterogeneity of this material was evidenced by the fact that it was possible to burn frequency-dependent spectral holes. The maximum position of the spectral holes depended on the square root of the pump frequency Ω . The refilling of the spectral holes was monitored subsequent to excitation using various pump frequencies. The refilling data could be collapsed onto a master curve by re-scaling them, again, using Ω −0.5 as scaling factor. The refilling time was found to be much longer than the time sc…

Materials scienceCondensed matter physicsMineralogyGeneral ChemistryDielectricCondensed Matter PhysicsLead zirconate titanateFerroelectricityTitanateCondensed Matter::Materials Sciencechemistry.chemical_compoundDomain wall (magnetism)chemistryMaster equationMaterials ChemistrySpectroscopyExcitationSolid State Communications
researchProduct

Spin Logical and Memory Device Based on the Nonvolatile Ferroelectric Control of the Perpendicular Magnetic Anisotropy in PbZr 0.2 Ti 0.8 O 3 /Co/Pt …

2020

Materials scienceCondensed matter physicsPerpendicular magnetic anisotropyLogical conjunctionHeterojunctionFerroelectricityElectronic Optical and Magnetic MaterialsSpin-½Advanced Electronic Materials
researchProduct

Soft mode in PMN–PSN ceramics

2008

Various ordered and disordered (1–x)Pb(Mg1/3Nb2/3)O3 –x Pb(Sc1/2Nb1/2)O3 (PMN–PSN) ceramics were studied by THz transmission spectroscopy in the temperature range of 10–300 K. It is found that the dielectric relaxation dominates in the spectra in higher temperatures, T > 170 K. In contrast, below 150 K, the strength of relaxation becomes so weak that the phonon contribution can be separated. The phonon contributribution in the investigated frequency range (200 GHz–2 THz) is presumably caused by the E component of the Last mode. The component exhibits hardening on cooling in all investigated ceramics and its critical temperature in ferroelectric PMN–PSN ceramics (x = 1, 0.95) is lower than t…

Materials scienceCondensed matter physicsPhononMineralogyDielectricSoft modesAtmospheric temperature rangeCondensed Matter PhysicsFerroelectricitySpectral lineElectronic Optical and Magnetic Materialsvisual_artvisual_art.visual_art_mediumHardening (metallurgy)Ceramicphysica status solidi (b)
researchProduct

Ferroelectricity and structure of BaTiO grown on YBa Cu O thin films

2000

We have investigated the crystal structure and the ferroelectric properties of BaTiO3 thin films with YBa2Cu3O \(_{7 - \delta }\) as the bottom and Au as the top electrode. Epitaxial heterostructures of YBa2Cu3O \(_{7 - \delta }\) and BaTiO3 were prepared by dc and rf sputtering, respectively. The crystal structure of the films was characterised by X-ray diffraction. The ferroelectric behaviour of the BaTiO3 films was confirmed by hysteresis loop measurements using a Sawyer Tower circuit. We obtain a coercive field of 30 kV/cm and a remanent polarisation of 1.25 μC/cm2. At sub-switching fields the capacitance of the films obeys a relation analogous to the Rayleigh law. This behaviour indica…

Materials scienceCondensed matter physicsRayleigh lawDielectricCrystal structureCoercivityCondensed Matter PhysicsFerroelectricityElectronic Optical and Magnetic MaterialsCondensed Matter::Materials Sciencesymbols.namesakeDomain wall (magnetism)SputteringCondensed Matter::SuperconductivitysymbolsThin filmThe European Physical Journal B
researchProduct

Broad Distribution of Relaxation Times in 0.6PMN-0.4PZN Relaxor Ceramics

2007

In this paper dielectric spectra of 0.6PMN-0.4PZN ceramic obtained from broadband dielectric spectroscopy is presented. Measurements revealed an unusual relaxor like nature. Two different processes in the dielectric spectra have been observed. High frequency, or short relaxation times, behaviour is typical for ferroelectric crystals. Longest relaxation times do not follow Vogel—Fulcher dependence, which is unusual for relaxors.

Materials scienceCondensed matter physicsRelaxation (NMR)Condensed Matter PhysicsFerroelectricityZirconateElectronic Optical and Magnetic MaterialsDielectric spectroscopyDistribution (mathematics)Nuclear magnetic resonancevisual_artvisual_art.visual_art_mediumCeramicCole–Cole equationBroadband dielectric spectroscopyFerroelectrics
researchProduct

Chemical strain effects and changed lattice dynamic in (Sr1-1.5xBix)TiO3ceramics (x ≤ 0.15)

2016

ABSTRACTIn this work lattice strain (induced by chemical Bi substitution on A-site) effects on the lattice dynamic of SrTiO3 ceramics were investigated by broadband dielectric spectroscopy in the very broad frequency range from 10 mHz up to 30 GHz and temperatures from 30 K to 500 K. Obtained results confirmed predicted induce of the ferroelectricity and suppression of the structural phase transition due to substitution of A-site ions – chemical straining of the lattice, both happening at the local scale but evident in macroscopic dielectric spectroscopy measurements. Calculated relaxation time distribution function broadens towards the longest relaxation times with temperature decrease and…

Materials scienceCondensed matter physicsRelaxation (NMR)Doping02 engineering and technology021001 nanoscience & nanotechnologyCondensed Matter Physics01 natural sciencesFerroelectricityElectronic Optical and Magnetic MaterialsDielectric spectroscopyIonCondensed Matter::Materials ScienceDistribution functionNuclear magnetic resonanceLattice (order)visual_art0103 physical sciencesvisual_art.visual_art_mediumCeramic010306 general physics0210 nano-technologyFerroelectrics
researchProduct

Dielectric relaxation in crystals and ceramics derived from BaTiO3

1992

Abstract A dielectric relaxation is reported in a crystal of BaTiO3 and in ceramics with composition (Ba1-yCay)TiO3 (0≤y≤0.2) in the frequency and temperature ranges 106 to 109 Hz and 350 to 450 K, respectively. A minimum of the relaxation frequency occurs close to the ferroelectric Curie temperature. The relaxation is of dipolar-type.

Materials scienceCondensed matter physicsRelaxation frequencyDielectricCondensed Matter PhysicsFerroelectricityElectronic Optical and Magnetic MaterialsCrystalvisual_artvisual_art.visual_art_mediumRelaxation (physics)Curie temperatureCeramicCole–Cole equationFerroelectrics
researchProduct

Electrical Transport Properties of Lead−Free (Na0.5Bi0.5)1-xBaxZr0.04Ti0.96O3Ceramics (x = 0.06, 0.085, 0.1)

2011

Lead-free ceramics (Na0.5Bi0.5)1-xBaxZr0.04Ti0.96O3 were prepared by solid phase hot pressing sintering process. Density values of obtained samples are higher than 95% of the theoretical ones. Samples with x = 0.06, 0.085 and 0.1 were investigated in the present work. For these samples both ac and dc electric conductivity were studied. A low frequency (100 Hz-100 kHz) ac conductivity obeys the power law, characteristic for disordered materials. The dc conductivity has a thermally activated character. A barrier hopping model is found to explain the mechanism of charge transport in these materials. The (Na0.5Bi0.5)1-xBaxZr0.04Ti0.96O3 system is expected to be a new and promising candidate for…

Materials scienceCondensed matter physicsSinteringLow frequencyCondensed Matter PhysicsHot pressingFerroelectricityPower lawElectronic Optical and Magnetic MaterialsElectrical resistivity and conductivityvisual_artPhase (matter)visual_art.visual_art_mediumCeramicFerroelectrics
researchProduct

Dielectric spectra of electron-irradiated PSN ceramics

1997

The influence of electron-irradiation on the dielectric properties of transparent PSN ferroelectric ceramics is studied by low (LF) and infralow (ILF) frequency spectrum analysis. Redistribution of relaxation frequencies caused by electron-irradiation has been discovered and is related to pinning impacts of the radiation-induced defects.

Materials scienceCondensed matter physicsSolid-state physicsFerroelectric ceramicschemistry.chemical_elementDielectricElectronElectroluminescenceThuliumNuclear magnetic resonancechemistryvisual_artvisual_art.visual_art_mediumIrradiationCeramicSPIE Proceedings
researchProduct

Interface-induced enhancement of piezoelectricity in the (SrTiO 3 ) m /(BaTiO 3 ) M−m superlattice for energy harvesting applications

2019

This research is funded by the Latvian Council of Science, project No. lzp-2018/1-0147. The computer resources were provided by Stuttgart Supercomputing Center (project DEFTD 12939) and Latvian Super Cluster (LASC). Many thanks to R. Dovesi, A. Erba, and M. Rérat for numerous stimulating discussions.

Materials scienceCondensed matter physicsSuperlatticePhase (waves)General Physics and Astronomy02 engineering and technology010402 general chemistry021001 nanoscience & nanotechnology01 natural sciences7. Clean energyPiezoelectricityFerroelectricitySymmetry (physics)0104 chemical sciencesHybrid functionalTetragonal crystal system:NATURAL SCIENCES:Physics [Research Subject Categories]Physical and Theoretical Chemistry0210 nano-technologyBasis set
researchProduct