Search results for "graphite"
showing 10 items of 229 documents
Potential Application of Voltammetry of Microparticles for Dating Porcine Blood-based Binding Media used in Taiwanese Architectural Polychromies
2012
A method for dating Hemoglobine-containing archaeological samples using the voltammetry of microparticles is described. This is based on the record of the voltammetric response of such materials attached to paraffin-impregnated graphite electrodes in contact with aqueous acetate buffer. Signals attributable to the Fe(III)/Fe(II) iron couple and their catalytic enhancement in the presence of H(2)O(2) can be correlated, via first-order reaction kinetics, with the time of aging of the samples. The method has been applied to the study and dating of the polychromed architectural decoration of different parts of the architectural complex of the Longshan Temple in Lukang (18(th) century, Taiwan).
Graphite-supported TiO2 for 4-nitrophenol degradation in a photoelectrocatalytic reactor
2009
WOS: 000274769500044
An on-line mass separator for fission-produced alkali isotopes
1980
Abstract The design of an on-line mass separator installed at the TRIGA reactor in Mainz is described and its performance discussed. A tungsten oven, filled with about 2 g of 235U embedded in graphite, is exposed to a flux of 1.7 × 1011 thermal neutrons (s− cm−2) near the reactor core. After diffusion out of the graphite the fission-produced alkali isotopes are surface-ionized and electromagnetically mass-separated, the resolving power being about 750. Losses during the diffusion out of the target material are discussed. Due to these losses the maximum separator efficiency is about 5%, corresponding to a source strength of about 109 particles s−1 for the most abundant isotopes. The heaviest…
Spatially resolved nanostructural transformation in graphite under femtosecond laser irradiation
2015
Abstract A polycrystalline graphite target was irradiated using infrared (800 nm) femtosecond (120 fs) laser pulses of different energies. Increase of sp 3 bonds percentage and possible diamond crystal formation were investigated ‘in-depth’ and on the irradiated surfaces. Synchrotron X-ray diffraction pattern have shown the presence of a diamond peak in one of the irradiated zones while X-ray photoelectron spectroscopy investigations have shown an increasing tendency of the sp 3 percent in the low power irradiated areas and similarly ‘in the depth’ of the higher power irradiated zones. Multiple wavelength Micro-Raman investigations have confirmed this trend along with an ‘in-depth’ (but not…
Laser ablation of a silicon target in chloroform: formation of multilayer graphite nanostructures
2013
With the use of high-resolution transmission electron microscopy, selected area electron diffraction and x-ray photoelectron spectroscopy methods of analysis we show that the laser ablation of a Si target in chloroform (CHCl3) by nanosecond UV pulses (40 ns, 355 nm) results in the formation of about 50–80 nm core–shell nanoparticles with a polycrystalline core composed of small (5–10 nm) Si and SiC mono-crystallites, the core being coated by several layers of carbon with the structure of graphite (the shell). In addition, free carbon multilayer nanostructures (carbon nano-onions) are also found in the suspension. On the basis of a comparison with similar laser ablation experiments implement…
Mapping of corrosion products of highly altered archeological iron using voltammetry of microparticles
2013
The application of the voltammetry of microparticles to identify corrosion products on different localizations of highly altered archeological iron pieces is described. The use of graphite pencil methodology permits to mapping different corrosion products, namely, akaganeite, goethite, hematite, jarosite, magnetite, maghemite and siderite, in iron artifacts. Identification protocols are based on square wave voltammetric measurements performed at sample-modified paraffin-impregnated graphite electrodes immersed into aqueous HCl. This methodology is applied for mapping corrosion products on an Iberian Roman shield boss from the Torre la Sal archeological site (Oropesa, Spain) dated in the IVt…
Epoxy composites filled with high surface area-carbon fillers
2013
Citation: J. Appl. Phys. 114, 164304 (2013); doi: 10.1063/1.4826529 (Received 24 July 2013; accepted 6 October 2013; published online 22 October 2013) A comprehensive analysis of electrical, electromagnetic (EM), mechanical, and thermal properties of epoxy resin composites filled with 0.25–2.0 wt. % of carbon additives characterized by high surface area, both nano-sized, like carbon nanotubes (CNTs) and carbon black (CBH), and micro-sized exfoliated graphite (EG), was performed. We found that the physical properties of both CNTs- and CBH-based epoxy resin composites increased all together with filler content and even more clearly for CBH than for CNTs. In the case of EG-based composites, go…
Electrochemical behaviour of Nafion®+cupromeronic phthalocyanine films
1999
Abstract The surface of indium tin oxide (ITO) and graphite+polymer composite electrodes can be modified by Nafion ® films containing a little amount of dispersed electroactive substances, such as phthalocyanines. This procedure allows electroanalytical information on the electroactive deposited substance to be obtained. The preparative methods of these type of modified electrodes are discussed from voltammetric results in this work. The proposed equivalent circuit explains the voltammetric differences between these electrodes. The Nafion ® net acts as a permeable membrane to the hydrogen ions. Besides, the presence of methylviologen within the Nafion ® film makes the electron transport thr…
GFAAS determination of selenium in infant formulas using a microwave digestion method.
1994
A method for determining the selenium content of infant formulas is proposed. It includes wet digestion with nitric acid and hydrogen peroxide in medium pressure teflon bombs in a microwave oven and determination by graphite furnace atomic absorption spectrometry (GFAAS). The absence of interferences is checked. Values obtained for the limit of detection (19.4 ng/g), precision (RSD = 2.2%) and accuracy by analysis of a reference material show that the method is reliable.
Effect of graphene nanoplatelets on the dielectric permittivity and segmental motions of electrospun poly(ethylene-co-vinyl alcohol) nanofibers
2021
The influence of the addition of graphene nanoplatelets (GNPs) on the intra/inter – molecular segmental motions of poly(ethylene-co-vinyl alcohol) (EVOH) was assessed by means of dielectric thermal analysis (DETA). The relaxation spectra were studied in terms of the dielectric permittivity (ε′) and the dielectric loss tangent (tan δ) at wide ranges of frequency (from 10−2 to 107 Hz) and temperature (from -150 to 140 °C). Two relaxation zones were disthinguished. Below the glass transition temperature (Tg), two β-relaxations were observed, which are characteristic local modes of mobility of the EVOH side groups, and related to the influence of the different surroundings of ethylene or vinyl …