Search results for "hydrogenation"
showing 10 items of 155 documents
Triazolopyridines. Part 30. Hydrogen transfer reactions; pyridylcarbene formation
2013
The transfer hydrogenation reaction of (1,2,3)triaz olo(1,5-a)pyridines with Pd/C/Zn or Pd(OH) 2/C/Zn in water, ethanol or water/ethanol mixture ha s been explored. 4,5,6,7-Tetrahydro- triazolopyridines were obtained in good to medium yields. In addition, under the same conditions 2-substituted pyridines were also formed as a resul t of intermediate pyridylcarbene formation, by triazole ring opening and loss of nitrogen.
The nickel-support interaction as determining factor of the selectivity to ethylene in the oxidative dehydrogenation of ethane over nickel oxide/alum…
2021
[EN] Nickel oxides supported on gamma-alumina (Ni-loading from 5 to 30 wt% NiO) have been synthesized and tested in the oxidative dehydrogenation (ODH) of ethane in order to determine the importance of the NiO-support interaction. The best performance was achieved by the catalyst with 15 wt% NiO; higher NiO-loadings lead to the formation of unselective bulk-like NiO and lower Ni-loadings present high proportion of free alumina surface sites. The presence of oxalic acid and/or niobium in the synthesis gel resulted in the formation of NiO particles with similar size, but higher crystallinity and reducibility than the standard 15 wt% NiO catalyst. The obtained results have revealed that, in ad…
Relationship between bulk phase, near surface and outermost atomic layer of VPO catalysts and their catalytic performance in the oxidative dehydrogen…
2017
Abstract A set of vanadium phosphorous oxide (VPO) catalysts, mainly consisting of (VO) 2 P 2 O 7 , VO(PO 3 ) 2 or VOPO 4 ·2H 2 O bulk crystalline phases, has been investigated for the oxidative dehydrogenation (ODH) of ethane to ethylene, a key potential reaction for a sustainable industrial and socioeconomic development. The catalytic performance on these VPO catalysts has been explained on the basis of the main crystalline phases and the corresponding surface features found by XPS and LEISS at 400 °C, i.e. within the temperature range used for ODH reaction. The catalysts based on (VO) 2 P 2 O 7 phase presented the highest catalytic activity and productivity to ethylene. Nevertheless, the…
Oxidative dehydrogenation of ethane on diluted or promoted nickel oxide catalysts: Influence of the promoter/diluter
2020
Ti- and Nb- containing NiO catalysts have been synthesized by two different preparation methods: i) by precipitation (Me-Ni-O oxides, Me = Nb or Ti), in order to prepare promoted NiO catalysts; and ii) by wet impregnation on TiO or NbO supports, in order to prepare diluted/supported NiO catalysts. The catalysts have been also characterized and tested in the oxidative dehydrogenation of ethane. The catalytic performance of Ti- and Nb-promoted catalysts strongly depends on the composition, although in both cases the optimal one is found at similar Ti or Nb loadings (ca. 90 wt% NiO), showing similar ethylene selectivity in the ODH of ethane (ca. 90% at 10–20% ethane conversion). However, in th…
Selective oxidative dehydrogenation of ethane over MoVSbO mixed oxide catalysts
2006
Abstract Mo–V–Sb–O mixed metal oxides were prepared, characterized and tested for the oxidative dehydrogenation of ethane (ODH). These catalysts are active and selective in the oxidative dehydrogenation of ethane to ethylene, although their catalytic performance depends strongly on the calcination temperature. The best catalytic results were obtained on samples heat-treated at 600 °C in N 2 (with selectivities to ethylene higher than 80% at ethane conversions about 65%). Moreover, a loss in the catalyst activity is initially observed on these catalysts as a consequence of modifications in the nature of the crystalline phases. Changes on the oxidation state of antimony ions on the surface of…
Niobium phosphates as new highly selective catalysts for the oxidative dehydrogenation of ethane
2011
Several niobium phosphate phases have been prepared, fully characterized and tested as catalysts for the selective oxidation of ethane to ethylene. Three distinct niobium phosphate catalysts were prepared, and each was comprised predominantly of a different bulk phase, namely Nb(2)P(4)O(15), NbOPO(4) and Nb(1.91)P(2.82)O(12). All of the niobium phosphate catalysts showed high selectivity towards ethylene, but the best catalyst was Nb(1.91)P(2.82)O(12), which was produced from the reduction of niobium oxide phosphate (NbOPO(4)) by hydrogen. It was particularly selective for ethylene, giving ca. 95% selectivity at 5% conversion, decreasing to ca. 90% at 15% conversion, and only produced low l…
Structural characterization of Niobium Phosphate Catalysts used for the Oxidative Dehydrogenation of Ethane to Ethylene
2011
Extended abstract of a paper presented at Microscopy and Microanalysis 2011 in Nashville, Tennessee, USA, August 7–August 11, 2011.
Molybdenum–vanadium supported on mesoporous alumina catalysts for the oxidative dehydrogenation of ethane
2006
Abstract Vanadium and/or molybdenum oxides supported on mesoporous alumina have been prepared by a “wet” impregnation method, characterized (by using several physico-chemical techniques TPR, DR-UV–vis, Raman spectroscopies) and tested in the oxidative dehydrogenation (ODH) of ethane. For comparison Mo–V-mixed oxides supported on γ-Al2O3 have also been studied. The characterization results indicate that the main vanadium species in both Mo-free and Mo-containing V-based samples present low aggregation and coordination, whereas molybdenum is present as monomeric or polymeric tetrahedral molybdenum species. Interestingly, no apparent interaction between molybdenum and vanadia takes place. The …
Nickel oxide supported on porous clay heterostructures as selective catalysts for the oxidative dehydrogenation of ethane
2016
[EN] Porous clay heterostructures (PCH) have shown to be highly efficient supports for nickel oxide in the oxidative dehydrogenation of ethane. Thus NiO supported on silica with a PCH structure shows productivity towards ethylene three times higher than if NiO is supported on a conventional silica. This enhanced productivity is due to the increase in the catalytic activity and especially to the drastic increase in the selectivity to ethylene. Additionally, PCH silica partially modified with titanium in the columns (PCH-Ti) have also been synthesized and used as supports for NiO. An enhanced activity and selectivity to ethylene was found over NiO supported over PCH-Ti compared to the corresp…
DFT study on complete ethylene decomposition on flat and stepped Pd
2010
Abstract We applied density functional theory (DFT) calculations to study ethylidyne (CCH 3 ) adsorption and decomposition to C and H over flat and stepped Pd surfaces. Our calculations show that ethylidyne is the most stable molecule among all the possible dehydrogenation or decomposition residues of ethylene. We discuss various possible reaction pathways for ethylidyne decomposition and point out that the most probable one is via ethynyl (CCH) species suggested also by experimental observations. Our calculations indicate that the presence of steps modify the potential energy surface by increasing the binding of most of the species, and also lowering the activation barrier for several reac…