Search results for "ionic"

Conductive and Capacitive Properties of the Bipolar Membrane Junction Studied by AC Impedance Spectroscopy

2001

The complete ac impedance spectrum of four bipolar membranes is analyzed both theoretically and experimentally taking into account both ionic transport and water dissociation together with the structural aspects of the bipolar junction. A theoretical model based on the Nernst-Planck and Poisson equations for the conductive and capacitive properties of the junction provides a qualitative description of the bipolar membranes for a broad range of electric currents and temperatures. Special attention is paid to the characteristics of the bipolar junction structure and the contact region between the two ion-exchange layers. It is observed that the effective area of this region increases with the…

Improving the multiple errors detection coverage in distributed embedded systems

2004

Currently, a lot of critical applications in automobile and aircraft avionics are built on fault-tolerant real-time distributed embedded systems. Fault injection techniques have been used extensively in the experimental validation of these systems and it is a challenge to adapt them to the demands of new technologies. This paper deals with the effect of physical faults at pin level on the Communication Network Interface in a prototype based on time-triggered architecture. Due to the essential necessity of observing system behavior during injection experiments, a suitable monitor for distributed embedded systems is proposed. The monitor is used to detect failures in the value domain that cou…

Ligand-Length Modification in CsPbBr3 Perovskite Nanocrystals and Bilayers with PbS Quantum Dots for Improved Photodetection Performance

2020

Nanocrystals surface chemistry engineering offers a direct approach to tune charge carrier dynamics in nanocrystals-based photodetectors. For this purpose, we have investigated the effects of altering the surface chemistry of thin films of CsPbBr3 perovskite nanocrystals produced by the doctor blading technique, via solid state ligand-exchange using 3-mercaptopropionic acid (MPA). The electrical and electro-optical properties of photovoltaic and photoconductor devices were improved after the MPA ligand exchange, mainly because of a mobility increase up to 5 &times

Nitrogen-Doped Carbon Nanodots-Ionogels: Preparation, Characterization, and Radical Scavenging Activity

2018

Hybrid diimidazolium-based ionogels were obtained by dispersing nitrogen-doped carbon nanodots (NCNDs) in ionic liquid (IL) solutions and by using dicationic organic salts as gelators. The properties of the NCND-ionogels were studied in terms of thermal stability, mechanical strength, morphology, rheological, and microscopic analyses. Insights into the formation of the hybrid soft material were attained from kinetics of sol-gel phase transition and from estimating the size of the aggregates, obtained from opacity and resonance light-scattering measurements. We demonstrate that, on one hand, NCNDs were able to favor the gel formation both in the presence of gelating and nongelating ILs. On t…

Water-Tolerant Trifloaluminate Ionic Liquids: New and Unique Lewis Acidic Catalysts for the Synthesis of Chromane

2018

The first example of triflometallate ionic liquids, named in analogy to chlorometallate ionic liquids, is reported. Trifloaluminate ionic liquids, synthesised from 1-alkyl-3-methylimidazolium triflates and aluminium triflate, were characterised by multinuclear NMR spectroscopy and FT-IR spectroscopy, revealing the existence of oligonuclear, multiply-charged trifloaluminate anions, with multiple bridging triflate modes. Acceptor numbers were determined to quantify their Lewis acidity, rendering trifloaluminate ionic liquids as medium-strength Lewis acids (AN = ca. 65). Used as acidic catalysts in the cycloaddition of 2,4-dimethylphenol and isoprene (molar ratio 2:1) to prepare chromane, trif…

Influence of Anion and Cation Structure of Ionic Liquids on Carboxylic Acids Extraction

2019

A recently proposed new mechanism and a model of reactive extraction of carboxylic acids by hydrophobic ionic liquids (ILs) was tested on five systems from published as well as from new equilibrium data on liquid-liquid extraction of butyric and lactic acids (BA and LA) from aqueous solutions. Two phosphonium and one ammonium ILs were used. The model describes experimental data for all systems with a good fit. The mechanism of acid extraction by ILs is very similar for all tested systems. This indicates a more general validity of the developed model. The model allows deeper understanding of regularities in carboxylic acid extraction by hydrophobic ILs. Stability constants of the first acid-…

Multi-layered, covalently supported ionic liquid phase (mlc-SILP) as highly cross-linked support for recyclable palladium catalysts for the suzuki re…

2011

The reaction between an excess of 1,4-bis(3-vinylimidazolium-1-yl) bromide and a mercaptopropyl-modified amorphous silica gel or ordered mesoporous silica SBA-15 in the presence of azobisisobutyronitrile (AIBN) afforded new materials, which have a high loading of imidazolium moieties. These materials, which contain a highly cross-linked polymeric network, have been denoted as multi-layered, covalently supported ionic liquid phase (mlc-SILP) and have been used as support for palladium catalysts containing a high loading of the metal (10 wt%). Such materials were characterized by several techniques (13C magic angle spinning nuclear magnetic resonance, the Brunauer–Emmett–Teller technique, sma…

Surfactant Self-Assembling in the Gas Phase:bis(2-ethylhexyl)sulfosuccinate-Metal Ion Aggregates

2009

Reversible self-assembly of metal chalcogenide/metal oxide nanostructures based on Pearson hardness.

2010

Nanotechnology has reached a stage of development where not individual nanoparticles but rather systems of greater complexity are the focus of concern. These complex structures incorporate two or more types of materials, an example of which is the formation of metal–semiconductor hybrids, which effectively combine the properties of both materials. The assembly of multicomponent nanoparticles from constituents with different optical, electrical, magnetic, and chemical properties can lead to novel functionalities that are independent of the individual components and may be tailored to fit a specific application. These applications include such far-reaching challenges as solar energy conversio…

Lactobionic acid: a possible substituent of glucono-delta-lactone in dairy products

2014

National audience