Search results for "light intensity"
showing 10 items of 146 documents
<title>Relaxation processes in amorphous As-S and As-Se films</title>
1997
The relaxation of optical, mechanical and chemical properties of as-evaporated amorphous As-S and As-Se films while storing them at room temperature is investigated. The AsxS1-x films with arsenic content 0.3 less than x less than 0.4 are found to undergo maximal changes. It is shown that the phenomenon of dark self-enhancement of holograms (an increase of diffraction efficiency over time without any special treatment) can be used as an efficient method for investigation of relaxation processes in the amorphous chalcogenide films. The changes of diffraction efficiency in amorphous As2S3 films have been measured as a function of aging time and recording light intensity. The relaxation proces…
A photoplethysmography device for multipurpose blood circulatory system assessment
2011
A novel method for photoplethysmography (PPG) signal detection has been proposed and implemented in a three channel prototype device. The current design is simple, low cost and does not require sophisticated analogue circuits. The prototype was evaluated by physiological measurements and recorded PPG signals from conduit arteries of human subject.
EFFICIENT DEGRADATION OF CLOFIBRIC ACID BY HETEROGENEOUS PHOTOCATALYTIC OXIDATION PROCESS
2019
International audience; Emerging pollutants such as pharmaceutical active compounds were detected worldwide in different environmental compartments. Nowadays, multiple studies are focused on the investigation of their environmental fate, as well as to find new, efficient and sustainable removal technologies. Several studies demonstrated that heterogeneous photocatalysis is one of the most promising techniques used for water purification. Thus, the aim of our work was to evaluate the photodegradation efficiency of a refractory emergent compound, named clofibric acid, under UV light in aqueous solution. We report that photodegradation and mineralization efficiency are strongly dependent of th…
Modeling light and temperature influence on ammonium removal by Scenedesmus sp. under outdoor conditions.
2016
[EN] The ammonium removal rate of the microalga Scenedesmus sp. was studied under outdoor conditions. Microalgae were grown in a 500 L flat-plate photobioreactor and fed with the effluent of a submerged anaerobic membrane bioreactor. Temperature ranged between 9.5 WC and 32.5 WC and maximum light intensity was 1,860 μmol·m2·s1. A maximum specific ammonium removal rate of 3.71 mg NH4 þ-N·g TSS1·h1 was measured (at 22.6 WC and with a light intensity of 1,734 μmol·m2·s1). A mathematical model considering the influence of ammonium concentration, light and temperature was validated. The model successfully reproduced the observed values of ammonium removal rate obtained and it is thus p…
Global sensitivity and uncertainty analysis of a microalgae model for wastewater treatment.
2022
The results of a global sensitivity and uncertainty analysis of a microalgae model applied to a Membrane Photobioreactor (MPBR) pilot plant were assessed. The main goals of this study were: (I) to identify the sensitivity factors of the model through the Morris screening method, i.e. the most influential factors; (II) to calibrate the influential factors online or offline; and (III) to assess the model's uncertainty. Four experimental periods were evaluated, which encompassed a wide range of environmental and operational conditions. Eleven influential factors (e.g. maximum specific growth rate, light intensity and maximum temperature) were identified in the model from a set of 34 kinetic pa…
Limitation of carrier fringe methods in digital photoelasticity
2007
The carrier fringes method has been proposed in digital photoelasticity in combination with techniques such as Fourier transform and phase shifting method, without considering the influence of the isoclinics on the isochromatic patterns analysis. Unlike other optical methods as moire and holographic interferometry, in photoelasticity the light intensity emerging from a circular polariscope is related to both the isochromatic retardation and the isoclinic parameter. As it is shown by the theoretical analysis, owing to the misalignment between the principal stresses in the model and in the carrier, the computed retardation is affected by an error which is the same for all photoelastic methods…
Über den Allantoinstoffwechsel des Laubmooskallus und seine Beeinflussung durch Licht
1972
Summary 1. The amount of allantoin and allantoate was determined in moss callus grown under various light conditions. It can reach 26,5 % of the plant nitrogen content. The accumulation is influenced by light intensity and colour. 2. Red-light (660 nm) causes a greater allantoin level in the cells than blue light and white light illumination. Red-light favours the formation of young setae from the moss callus. We could detect a relation between the intensity of seta-development and the amount of allantoin. The accumulation is increasing with the growth of the setae. 3. Blue-light (440 nm) enhances the chlorophyll synthesis and promotes chloroplast develop ment. This effect is correlated wit…
Modeling of a continuous photocatalytic reactor for isovaleraldehyde oxidation: Effect of different operating parameters and chemical degradation pat…
2013
International audience; An investigation of isovaleraldehyde (ISOV) photocatalytic oxidation was conducted at initial concentrations ranging from 25 to 150 mg/m3 and different relative humidities (5-90% RH) in order to characterize the process performances close to indoor air conditions. Experiments were carried out in two different reactors: cylinder and flat-plate photoreactor (planar reactor) at different air gap (20-60 mm) and gas residence times (0.67-5.0 s). A plug flow reactor system was developed in order to perform kinetic studies of (i) isovaleraldehyde removal, (ii) selectivity of CO2, (iii) byproducts formation and removal. It appears that ISOV removal efficiencies increased wit…
Reliability of automated optical determination of capillary refill time
2021
The present study is devoted to assessment of automated optical capillary refill time determination by custom developed optoelectronic device prototype. Study comprised fifteen healthy volunteers; To induce capillary refill time changes the hand position challenge was utilized. During rest conditions slight inter-subject variation was observed: T90 (0.75±0.27 s), TSTB (2.20±0.58 s) and temperature at the measurement site (32.21±1.87 Co), however during hand position challenge results were more consistent. Rising hand substantially increased, while lowering slightly decreased capillary refill time. We conclude that automated determination of refill time have high clinical potential, however …
Holographic recording in amorphous As2S3 films at 633nm
2006
Abstract Holographic grating recording with focused (light intensity I = 14–124 W/cm 2 ) and unfocused ( I = 0.50–0.78 W/cm 2 ) 633 nm He–Ne laser sub-bandgap light in non-annealed and annealed a-As 2 S 3 films has been experimentally studied. The focused light recording is found to be much more efficient (diffraction efficiency up to 14.9%, specific recording energy down to 216 J/(cm 2 %)) than the unfocused light recording (0.11%, 72 400 J/(cm 2 %)). Some other properties are also different. The hologram lifetime of more than two years and positive refractive index changes take place in the case of focused recording versus two days and negative refractive index changes for unfocused r…