Search results for "magnitude"
showing 10 items of 501 documents
MeV-energy Xe ion-induced damage in LiF: The contribution of electronic and nuclear stopping mechanisms
2016
The contribution of electronic and nuclear damage mechanisms in the modification of structure and micromechanical properties of LiF crystals irradiated with 52, 224, and 450 MeV Xe ions at fluences 1010–1014 ions cm−2 has been studied. The ion-induced formation of dislocations and hardening in LiF at fluences above 1010 ions cm−2 has been observed. The depth profiles of nanoindentation show a joint contribution of electronic excitation and nuclear (impact) mechanisms to the ion-induced hardening. The electronic excitation mechanism dominates in the major part of the ion range while the impact mechanism prevails in a narrow zone at the end of the ion range. The efficiency of hardening produc…
Photoelectron Emission from Metal Surfaces Induced by VUV-emission of Filament Driven Hydrogen Arc Discharge Plasma
2015
Photoelectron emission measurements have been performed using a filament-driven multi-cusp arc discharge volume production H^- ion source (LIISA). It has been found that photoelectron currents obtained with Al, Cu, Mo, Ta and stainless steel (SAE 304) are on the same order of magnitude. The photoelectron currents depend linearly on the discharge power. It is shown experimentally that photoelectron emission is significant only in the short wavelength range of hydrogen spectrum due to the energy dependence of the quantum efficiency. It is estimated from the measured data that the maximum photoelectron flux from plasma chamber walls is on the order of 1 A per kW of discharge power.
Stabilization of primary mobile radiation defects in MgF2 crystals
2016
Abstract Non-radiative decay of the electronic excitations (excitons) into point defects ( F – H pairs of Frenkel defects) is main radiation damage mechanism in many ionic (halide) solids. Typical time scale of the relaxation of the electronic excitation into a primary, short-lived defect pair is about 1–50 ps with the quantum yield up to 0.2–0.8. However, only a small fraction of these primary defects are spatially separated and survive after transformation into stable, long-lived defects. The survival probability (or stable defect accumulation efficiency) can differ by orders of magnitude, dependent on the material type; e.g. ∼10% in alkali halides with f.c.c. or b.c.c. structure, 0.1% in…
Impact of internal variability on projections of Sahel precipitation change.
2017
12 pages; International audience; The impact of the increase of greenhouse gases on Sahelian precipitation is very uncertain in both its spatial pattern and magnitude. In particular, the relative importance of internal variability versus external forcings depends on the time horizon considered in the climate projection. In this study we address the respective roles of the internal climate variability versus external forcings on Sahelian precipitation by using the data from the CESM Large Ensemble Project, which consists of a 40 member ensemble performed with the CESM1-CAM5 coupled model for the period 1920–2100. We show that CESM1-CAM5 is able to simulate the mean and interannual variabilit…
Detection of X-ray flares from AX J1714.1-3912, the unidentified source near RX J1713.7-3946
2018
Molecular clouds are predicted to emit nonthermal X-rays when they are close to particle-accelerating supernova remnants (SNRs), and the hard X-ray source AX J1714.1-3912, near the SNR RX J1713.7-3946, has long been considered a candidate for diffuse nonthermal emission associated with cosmic rays diffusing from the remnant to a closeby molecular cloud. We aim at ascertaining the nature of this source by analyzing two dedicated X-ray observations performed with Suzaku and Chandra. We extracted images from the data in various energy bands, spectra, and light curves and studied the long-term evolution of the X-ray emission on the basis of the ~4.5 yr time separation between the two observatio…
Spatio-temporal patterns of thermal anomalies and drought over tropical forests driven by recent extreme climatic anomalies
2018
The recent 2015–2016 El Niño (EN) event was considered as strong as the EN in 1997–1998. Given such magnitude, it was expected to result in extreme warming and moisture anomalies in tropical areas. Here we characterize the spatial patterns of temperature anomalies and drought over tropical forests, including tropical South America (Amazonia), Africa and Asia/Indonesia during the 2015–2016 EN event. These spatial patterns of warming and drought are compared with those observed in previous strong EN events (1982–1983 and 1997–1998) and other moderate to strong EN events (e.g. 2004–2005 and 2009–2010). The link between the spatial patterns of drought and sea surface temperature anomalies in th…
Ground deformation reveals the scale-invariant conduit dynamics driving explosive basaltic eruptions
2021
The mild activity of basaltic volcanoes is punctuated by violent explosive eruptions that occur without obvious precursors. Modelling the source processes of these sudden blasts is challenging. Here, we use two decades of ground deformation (tilt) records from Stromboli volcano to shed light, with unprecedented detail, on the short-term (minute-scale) conduit processes that drive such violent volcanic eruptions. We find that explosive eruptions, with source parameters spanning seven orders of magnitude, all share a common pre-blast ground inflation trend. We explain this exponential inflation using a model in which pressure build-up is caused by the rapid expansion of volatile-rich magma ri…
Gas mass derived by infrasound and UV cameras: Implications for mass flow rate
2016
Abstract Mass Flow Rate is one of the most crucial eruption source parameter used to define magnitude of eruption and to quantify the ash dispersal in the atmosphere. However, this parameter is in general difficult to be derived and no valid technique has been developed yet to measure it in real time with sufficient accuracy. Linear acoustics has been applied to infrasonic pressure waves generated by explosive eruptions to indirectly estimate the gas mass erupted and then the mass flow rate. Here, we test on Stromboli volcano (Italy) the performance of such methodology by comparing the acoustic derived results with independent gas mass estimates obtained with UV cameras, and constraining th…
Dynamic Triggering of Mud Volcano Eruptions During the 2016-2017 Central Italy Seismic Sequence
2017
On 24 August 2016 a seismic event (Mw 6.0) was the first of the long Central Italy sequence (ongoing at the end of 2017) of medium-to-high magnitude earthquakes, with nine Mw ≥5 up to October 2017, and with about 74.000 seismic events registered after one year. The largest was the Mw 6.5 30 October 2016 event near Norcia. After the major seismic events, seventeen mud volcanoes erupted around Monteleone di Fermo village (Marche region). Mud volcano eruptions generally occurred a few hours to a few days after the main earthquakes, suggesting a seismic triggering. We analyzed the peak ground velocities (PGV) and dynamic stresses during the three largest earthquakes. We also evaluated the stati…
Seismic sources and stress transfer interaction among axial normal faults and external thrust fronts in the Northern Apennines (Italy): A working hyp…
2016
In this study we analyse the main potential seismic sources in some axial and frontal sectors of the Northern Apennines, in Italy. This region was hit by a peculiar series of earthquakes that started in 1916 on the external thrust fronts near Rimini. Later, in 1917-1921, seismicity (up to Mw approximate to 6.5) shifted into the axial zone and clearly migrated north-westward, along the belt of active normal faults. The collection of fault-slip data focused on the active normal faults potentially involved in this earthquake series. The acquired data allowed us to better characterize the geometry and kinematics of the faults. In a few instances, the installation of local seismic networks durin…