Search results for "medium"
showing 10 items of 3746 documents
High proton conduction in a chiral ferromagnetic metal-organic quartz-like framework.
2011
A complex-as-ligand strategy to get a multifunctional molecular material led to a metal-organic framework with the formula (NH(4))(4)[MnCr(2)(ox)(6)]·4H(2)O. Single-crystal X-ray diffraction revealed that the anionic bimetallic coordination network adopts a chiral three-dimensional quartz-like architecture. It hosts ammonium cations and water molecules in functionalized channels. In addition to ferromagnetic ordering below T(C) = 3.0 K related to the host network, the material exhibits a very high proton conductivity of 1.1 × 10(-3) S cm(-1) at room temperature due to the guest molecules.
The Effects of 3d Admixtures on Properties of Relaxor PLZT8/65/35 Ceramics
2012
A study of the effects of the 3d dopants Mn, Fe, Co, Ni, and Cu on relaxor behavior and other properties of the ferroelectric PLZT8/65/35(La8) ceramic compound by X-ray diffraction, electron microscopy and other techniques is reported. The complex dielectric permittivity ϵ* = ϵ′-iϵ′′ is measured in the 20–400°C range of temperature at frequencies within the range of 102 – 106 Hz. Essential changes caused by the admixtures in the behavior of dielectric permittivity with frequency and temperature are observed along with changes in the XRD SEM patterns are observed. The mechanisms of the phenomena are discussed.
Vapor growth of Hg1−xCdxI2 on glass using CdTe buffer
2001
Abstract Vapor phase epitaxy (VPE) of Hg1−xCdxI2 layers on glass substrates covered by a CdTe buffer layer has been studied. The buffer layers of 2–4 μm thickness were formed by VPE using polycrystalline CdTe and Cd metal sources. The Hg1−xCdxI2 layers were grown using a (Hg1−yCdy)1−z(I2)z polycrystalline source, with a composition in the range of y=0.1–0.5 and z=0.5–0.8. Scanning electron microscopy and X-ray diffraction studies have shown that the composition and structure of Hg1−xCdxI2 layers depend strongly on the VPE conditions. Varying the growth time and source composition, it has been possible to obtain Hg1−xCdxI2 layers with the composition x in the range from approximately 0 (HgI2…
Structural and elastic properties of defect chalcopyrite HgGa2S4 under high pressure
2014
In this work, we focus on the study of the structural and elastic properties of mercury digallium sulfide (HgGa2S4) at high pressures. This compound belongs to the family of AB(2)X(4) ordered-vacancy compounds and exhibits a tetragonal defect chalcopyrite structure. X-ray diffraction measurements at room temperature have been performed under compression up to 15.1 GPa in a diamond anvil cell. Our measurements have been complemented and compared with ab initio total energy calculations. The axial compressibility and the equation of state of the low-pressure phase of HgGa2S4 have been experimentally and theoretically determined and compared to other related ordered-vacancy compounds. The pres…
Modified YBCO superconductor-ferroelectric composites: Bulk materials and thick films
1996
Bulk samples and 50–125 μm thick films of (1-x)YBa2Cu3O7−δ-xBaTiO3 (0⩽x⩽0.12 by weight) composites have been synthesized, the films being obtained by Stokes sedimentation on SrTiO3 ceramic plates and firing in oxygen by Melt Textured Growth techniques. The phase composition and texture have been studied by X-ray diffraction and microstructure. Resistance and magnetic susceptibility of prepared samples have been measured.
Pressure-restored superconductivity in Cu-substituted FeSe
2011
Copper doping of FeSe destroys its superconductivity at ambient pressure, even at low doping levels. Here we report the pressure-dependent transport and structural properties of Fe${}_{1.01\ensuremath{-}x}$Cu${}_{x}$Se with 3$%$ and 4$%$ Cu doping and find that the superconductivity is restored. Metallic resistivity behavior, absent in Cu-doped FeSe, is also restored. At the low pressure of 1.5 GPa, superconductivity is seen at 6 K for 4$%$ Cu doping, somewhat lower than the 8 K ${T}_{c}$ of undoped FeSe. ${T}_{c}$ reaches its maximum of 31.3 K at 7.8 GPa, lower than the maximum superconducting temperature in the undoped material under pressure (${T}_{c}$ max of 37 K) but still very high. X…
Investigation of AC Electrical Properties of MXene-PCL Nanocomposites for Application in Small and Medium Power Generation
2021
The paper examined Ti3C2Tx MXene (T—OH, Cl or F), which is prepared by etching a layered ternary carbide Ti3AlC2 (312 MAX-phase) precursor and deposited on a polycaprolactone (PCL) electrospun membrane (MXene-PCL nanocomposite). X-ray Diffraction analysis (XRD) and Scanning Electron Microscopy (SEM) indicates that the obtained material is pure Ti3C2 MXene. SEM of the PCL-MXene composite demonstrate random Ti3C2 distribution over the nanoporous membrane. Results of capacitance, inductance, and phase shift angle studies of the MXene-PCL nanocomposite are presented. It was found that the frequency dependence of the capacitance exhibited a clear sharp minima in the frequency range of 50 Hz to o…
Mixed valence mono- and hetero-metallic grid catenanes
2015
Multicomponent self-assembly was employed to obtain, in the solid state, a series of mixed valence mono- and hetero-metallic grid catenanes, which were characterized by single crystal X-ray diffraction.
Applications of automated diffraction tomography (ADT) on nanocrystalline porous materials
2013
Abstract Many porous materials, both inorganic and hybrid organic–inorganic, can only be synthesized as nanocrystals. X-ray powder diffraction delivers one-dimensional data from the overall sample and is therefore often limited by peak overlap at low or medium resolution and by peak broadening. Thus, structure solution of materials with large unit cells and low symmetry, disorder or pseudosymmetry, or available only in polyphasic systems, turns out to be problematic or even impossible. Electron diffraction allows collecting three-dimensional structure information from nanocrystalline materials, but is traditionally biased by low completeness of the diffraction data, dynamical scattering and…
Elastic Properties of Barium Zirconate Titanate Ceramics
2011
In the paper the influence of zirconium admixture on the structure and material constants of polycrystalline ferroelectric materials BaZrxTi1-xO3 (BZT) was examined. The barium zirconate titanate samples were prepared by a conventional solid state reaction method. A single phase with perovskite structure of the samples, was identified by an X-Ray diffraction technique at room temperature. The performed EDS study revealed that the samples were perfectly sintered and the material was chemically homogeneous. The dependence of shear modulus G on sample composition is similar to the respective dependence of Young's modulus E, whereas the Poisson's ratio ν decreases with the increase in zirconium…