Search results for "mineralogy"
showing 10 items of 1516 documents
Batch-to-Melt Conversion Kinetics in Sodium Aluminosilicate Batches Using Different Alumina Raw Materials
2016
The batch-to-melt conversion in batches of sand, soda ash and corundum (C), alumina spinel (A), boehmite (B), or gibbsite (G) as Al2O3 carrier are studied using thermal analysis, X-ray diffraction, and 27Al nuclear magnetic resonance spectroscopy. Laboratory-scaled batches are either heated continuously or quenched from 1600°C in a series of increasing dwell times. The results show that the conversion from the raw materials to the fresh melt proceeds in two kinetic stages. During the first stage (3–5 min), fast conversion of nearly 95% by mass occurs and the conversion coefficient increases in the order G < C ≈ A < B. The second stage is controlled by the slow dissolution of intermediate cr…
Phase segregation in Mg$_{x}$Zn$_{1-x}$O probed by optical absorption and photoluminescence at high pressure
2017
The appearance of segregated wurtzite Mg$_x$Zn$_{1-x}$O with low Mg content in thin films with $x>0.3$ affected by phase separation, cannot be reliably probed with crystallographic techniques owing to its embedded nanocrystalline configuration. Here we show a high-pressure approach which exploits the distinctive behaviors under pressure of wurtzite Mg$_x$Zn$_{1-x}$O thin films with different Mg contents to unveil phase segregation for $x>0.3$. By using ambient conditions photoluminescence (PL), and with optical absorption and PL under high pressure for $x=0.3$ we show that the appearance of a segregated wurtzite phase with a magnesium content of x $\sim$ 0.1 is inherent to the wurtzit…
Preparation, Characterisation and Dielectric Properties of YBa2Cu3O7-δ/ Insulator-Heterostructures
1996
YBa 2 Cu 3 O 7-δ /insulator/Au-heterostructures on SrTiO 3 or LaAlO 3 substrates were prepared to study the properties of the materials SrTiO 3 , BaTiO 3 and Ceo 2 . X-ray diffraction measurements in Bragg-Brentano geometry show c-axis-oriented growth for the superconductor and the insulators SrTiO 3 and CeO 2 . Typical values for the rocking curve width of the different insulating films are between 0.4° and 0.8°. The highest breakdown fields are measured for the insulator SrTiO 3 with +37.5 kV/mm and -8.8 kV/mm. The permittivity for CeO 2 is independent of applied field and only weakly temperature dependent. This is in contrast to the perovskite type insulators, where the permittivity depe…
Anomalies of dielectric properties and conductivity in single domain LiNbO3:Zn crystals
2016
ABSTRACTA study of the temperature dependence of dielectric constant, conductivity, and piezoelectric modulus in the single-domain state of LiNbO3 crystals modified by Zn admixture at threshold concentration is reported. Unipolarity of the LiNbO3:Zn crystals is observed to increase after treatment of brand-new samples by high-temperature electro-diffusion annealing and by subsequent high-temperature annealing of short-circuited samples. The observed effects are explained as a result of meta-stable residual domains collapsing at high temperature the collapse being assisted by disintegration of charged clusters stabilizing domain walls. The rise of unipolarity is accompanied by anomalies on t…
The effects of the additive of Eu ions on elastic and electric properties of BaTiO3ceramics
2016
ABSTRACTThe BaTiO3 and BaTiO3+X%wt.Eu2O3 (X = 1, 2, 3) ceramics were prepared by a solid phase reaction. The structural and morphology studies were carried out by means of an X-ray diffraction technique and scanning electron microscopy, respectively. Elastic moduli were determined with the use of an ultrasonic method. The dielectric permittivity (ϵ′) and tanδ as a function of composition and temperature were investigated. The increasing concentration of Eu ions leads to a slight shift of the Curie temperature and changes the characteristics of ϵ′ and tanδ. The structural, mechanical and dielectric properties of the BTEX ceramics were discussed in terms of microstructure and dopants contents.
Investigation of mechanical and electrical properties of Li doped sodium niobate ceramic system
2016
ABSTRACTThe Na0.96Li0.04NbO3 ceramic solid solution was prepared by means of a two-stage hot-pressing technology. The X-ray diffraction analysis showed the formation of a single perovskite phase with an orthorhombic symmetry in the investigated composition. The microstructure and EDS measurements were performed. They confirmed the high purity and the expected qualitative composition. A good homogeneity of the microstructures and a small degree of porosity were observed. The elastic modulus (the Young's modulus E, shear modulus G, and Poisson's ratio ν) of Na0.96Li0.04NbO3 were determined with the use of an ultrasonic method. The electrical properties of Na0.96Li0.04NbO3 ceramics were invest…
Enhancement of the dielectric response through Al-substitution in La1.6Sr0.4NiO4 nickelates
2016
The structures and dielectric properties of La1.6Sr0.4Ni1−xAlxO4 (x = 0, 0.2 and 0.4) ceramics elaborated using the Pechini method were studied for the first time. The same unique tetragonal phase was found in all compounds. The lattice parameters were found using Rietveld refinement. The surface morphology characterization and elemental analysis of these samples were respectively carried out using scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDS). A giant dielectric response was observed in these ceramics, and one dielectric relaxation was found. The substitution of nickel with aluminum results in a colossal dielectric constant value (>106). The dielectric l…
Domain Walls Motions in Barium Titanate Ceramics
1996
The shear modulus and mechanical loss at low frequencies (0.01, 0.3, 1 Hz) are measured by an inverted pendulum for BaTiO 3 ceramic with large grain sizes. The permittivity and dielectric losses are also investigated for the same material at higher frequencies between 1 and 100 kHz as function of temperature. Those results show several relaxation peaks in the ferroelectric phases. The activation energy of each peak is obtained to be 0.29, 0.45, 0.68, 0.92 eV. The influences of strain amplitude and thermal treatments are studied specially for the mechanical relaxation peak located in the tetragonal phase. All the relaxation peaks could be associated to the interaction of oxygen vacancies in …
Luminescence of polymorphous SiO2
2016
Abstract The luminescence of self-trapped exciton (STE) was found and systematically studied in tetrahedron structured silica crystals (α-quartz, coesite, cristobalite) and glass. In octahedron structured stishovite only host material defect luminescence was observed. It strongly resembles luminescence of oxygen deficient silica glass and γ or neutron irradiated α-quartz. The energetic yield of STE luminescence for α-quartz and coesite is about 20% of absorbed energy and about 5(7)% for cristobalite. Two types of STE were found in α-quartz. Two overlapping bands of STEs are located at 2.5–2.7 eV. The model of STE is proposed as Si–O bond rupture, relaxation of created non-bridging oxygen (N…
Positron trapping defects in free-volume investigation of Ge–Ga–S–CsCl glasses
2016
Abstract Evolution of free-volume positron trapping defects caused by crystallization process in (80GeS 2 –20Ga 2 S 3 ) 100−х (СsCl) x , 0 ≤ x ≤ 15 chalcogenide-chalcohalide glasses was studied by positron annihilation lifetime technique. It is established that CsCl additives in Ge–Ga–S glassy matrix transform defect-related component spectra, indicating that the agglomeration of free-volume voids occurs in initial and crystallized (80GeS 2 –20Ga 2 S 3 ) 100−х (СsCl) x , 0 ≤ x ≤ 10 glasses. Void fragmentation in (80GeS 2 –20Ga 2 S 3 ) 85 (СsCl) 15 glass can be associated with loosing of their inner structure. Full crystallization in each of these glasses corresponds to the formation of defe…