Search results for "nanocrystalline"
showing 10 items of 145 documents
XPS and EELS investigations of chemical homogeneity in nanometer scaled Ti-ferrites obtained by soft chemistry
1999
Abstract Nanocrystalline Ti-ferrites with composition Fe 3− x Ti x O 4 with 0≤ x ≤1 are synthesized using the soft chemistry route. Heterogeneities in precipitate and annealed powders are investigated by a combination of XPS and EELS techniques. As-prepared powder consists in particles with spinel structure and grain size of about 15 nm. Due to high reactivity towards oxygen of nanoparticules, a significant amount of Fe 2+ cations oxidize during precipitation, so that precipitated powders present large deviation from oxygen-metal stoichiometry. Moreover precipitated particles are evidenced to exhibit a strong surface titanium enrichment and an iron richer core. Observation of such cation se…
Co3O4 particles grown over nanocrystalline CeO2: influence of precipitation agents and calcination temperature on the catalytic activity for methane …
2015
Crystalline cobalt oxides were prepared by a precipitation method using three different precipitation agents, (NH4)(2)CO3, Na2CO3 and CO(NH2)(2). Cobalt oxide nanoparticles corresponding to a Co3O4 loading of 30 wt% were also deposited over high-surface area nanocrystalline ceria by the same precipitation agents. The effect of calcination temperature, 350 or 650 degrees C, on the morphological and structural properties was evaluated. Characterization by BET, XRD, SEM, TEM, Raman spectroscopy, H-2-TPR, XPS and NH3-TPD was performed and the catalytic properties were explored in the methane oxidation reaction. The nature of the precipitation agent strongly influenced the textural properties of…
Deposition and characterization of cold sprayed nanocrystalline NiTi
2011
International audience; Binary 50Ni–50Ti mixture was prepared by mechanical alloying from elemental powders. After 48 h of milling, the nanocrystalline B2-NiTi powder was produced. Then, this as-milled powder was deposited by cold spraying in order to produce a target which can be used to create thin films by magnetron sputtering technique. The objective is to improve the electrical characterizations of the NiTi/SiO2/Si M.O.S structures. Themorphology evolution of the powder particles, the phase identification and the alloying evolution process as function of milling time were studied using scanning electron microscopy, X-ray diffraction and transmission electron microscopy. In addition, th…
Nanostructured Alumina from Freeze-Dried Precursors
2010
Nanocrystalline alumina has been obtained on the 100 g scale by thermal decomposition of precursors resulting from the freeze-drying of aqueous solutions of different aluminum-containing products, namely aluminum acetate and aluminum L-lactate. Samples prepared at different temperatures (from 873 to 1573 K in steps of 100 K) were characterized by X-ray powder diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM), and surface area measurements. In the acetate case, the transformation sequence involves the formation of θ-Al 2 O 3 as an intermediate phase between γ-Al 2 O 3 and α-Al 2 O 3 , whereas this θ phase is not observed in the lactate case. TEM…
Growth, Structure, and Stability of KxWO3 Nanorods on Mica Substrate
2012
International audience; KxWO3 nanorods, interesting as gas sensors, were elaborated on mica muscovite substrate and characterized by atomic force microscopy, scanning electron microscopy, X-ray photoelectron spectroscopy, and mainly transmission electron microscopy. A combination of structural analyses allowed determining the morphology of these rods, and selected area electron diffraction experiments pointed out the simultaneous presence of the exotic hexagonal and stable monoclinic phases. Moreover, the presence of potassium inside the nanorods, coming from the mica substrate, was revealed. By combining all the observations, a growth model is proposed, consisting of the stacking of two di…
Mechanical cleaning of graphene using in situ electron microscopy
2020
Avoiding and removing surface contamination is a crucial task when handling specimens in any scientific experiment. This is especially true for two-dimensional materials such as graphene, which are extraordinarily affected by contamination due to their large surface area. While many efforts have been made to reduce and remove contamination from such surfaces, the issue is far from resolved. Here we report on an in situ mechanical cleaning method that enables the site-specific removal of contamination from both sides of two dimensional membranes down to atomic-scale cleanliness. Further, mechanisms of re-contamination are discussed, finding surface-diffusion to be the major factor for contam…
Atomic layer deposition of Ru films from bis(2,5-dimethylpyrrolyl)ruthenium and oxygen
2012
Abstract Ru thin films were grown on hydrogen terminated Si, SiO 2 , Al 2 O 3 , HfO 2 , and TiO 2 surfaces by atomic layer deposition from bis(2,5-dimethylpyrrolyl)ruthenium precursor and oxygen. The 4–20 nm thick films on these surfaces consisted of nanocrystalline hexagonal metallic ruthenium, regardless of the deposition temperature. At the lowest temperatures examined, 250–255 °C, the growth of the Ru films was favored on silicon, compared to the growth on Al 2 O 3 , TiO 2 and HfO 2 . At higher temperatures the nucleation and growth of Ru became enhanced in particular on HfO 2 , compared to the process on silicon. At 320–325 °C, no growth occurred on Si–H and SiO 2 -covered silicon. Res…
Residual crystalline silicon phase in silicon-rich-oxide films subjected to high temperature annealing
2002
Structural properties of silicon rich oxide films (SRO) have been investigated by means of micro-Raman spectroscopy and transmission electron microscopy (TEM). The layers were deposited by plasma enhanced chemical vapor deposition using different SiH4/O2 gas mixtures. The Raman spectra of the as-deposited SRO films are dominated by a broad band in the region 400-500 cm-1 typical of a highly disordered silicon network. After annealing at temperatures above 1000°C in N2, the formation of silicon nanocrystals is observed both in the Raman spectra and in the TEM images. However, most of the precipitated silicon does not crystallize and assumes an amorphous microstructure. © 2002 The Electrochem…
One-step formation of nanostructures on silicon surfaces using pure hydrogen-radical-initiated reactions
2013
One-step formation of silicon nanowires, sheets, and texture surface on a silicon substrate has been achieved using hydrogen-radical etching reactions. Metallic tungsten and for comparison purposes a tungsten hot wire, were used as catalysts for the hydrogen-molecular cracking. It was shown that a variety of surface structures on silicon such as inverted pyramid texture, V-groove texture, dense silicon nanowire growth over texture, and nanosheet structure can be obtained by controlling the process conditions. The obtained results suggested that the formation of nanotungsten silicide particle is an essential prerequisite to obtain these structures. The particles work as an etching mask again…
Confocal spectromicroscopy of amorphous and nanocrystalline tungsten oxide films
2007
A Raman confocal spectromicroscopic system was used to study in situ phase composition and surface morphology in amorphous and nanocrystalline tungsten oxide and tungstate thin films, prepared on silicon and glass substrates by dc magnetron co-sputtering technique. The possible use of these films for the phase-change optical recording was demonstrated using 442 nm He–Cd laser with a variable power of up to 50 mW. The formation of nanocrystalline tungsten trioxide or tungstate phases was observed under the laser irradiation. These nanocrystalline phases show relatively strong Raman activity, which can be used for information reading purposes. A multilayer structure composed of several tungst…