Search results for "paper industry"
showing 10 items of 413 documents
Anaerobic treatment of urban wastewater in membrane bioreactors: evaluation of seasonal temperature variations
2014
The objective of this study was to evaluate the effect of seasonal temperature variations on the anaerobic treatment of urban wastewater in membrane bioreactors (MBRs). To this aim, sludge production, energy recovery potential, chemical oxygen demand (COD) removal and membrane permeability were evaluated in a submerged anaerobic MBR fitted with industrial-scale membrane units. The plant was operated for 172 days, between summer and winter seasons. Sludge production increased and energy recovery potential decreased when temperature decreased. COD removal and membrane permeability remained nearby stable throughout the whole experimental period.
Gasification of pelletized renewable fuel for clean energy production
2011
Abstract The main aim of the study was to develop and investigate a small-scale experimental gasification technique for the effective thermal decomposition of pelletized renewable fuels (wood sawdust, wheat straw). The technical solution of the biomass gasifier for gasification of renewable fuels presents a downdraft gasifier with controllable additional heat energy supply to the biomass using the radial propane flame injection into the bottom part of the biomass layer. From the kinetic study of the mass conversion rate of pelletized biomass and variations of the composition of produced gas it is concluded that the process of biomass gasification is strongly influenced by the amount of addi…
Hand-made paper obtained by green procedure of cladode waste of Opuntia ficus indica (L.) Mill. from Sicily
2019
Cellulosic fibres have been obtained by green procedures from the cladodes of Opuntia ficus indica (L.) Mill., constituting a large agro industrial waste in our territory. The materials have been analysed for its relative composition, applying, IR and TG methodologies and it was characterised by the absence of lignin. The fibrous material allowed the manufacture of a handmade paper obtaining an ecological material suitable for packaging purposes. The authors evidenced that the simple protocol based on hot water treatment was able to decrease the amount of hemicellulose in the final material.
A comparative economic analysis of torrefied pellet production based on state-of-the-art pellets
2017
Abstract Torrefied pellets have fuel properties superior to those of conventional wood pellets and potentially allow greater rates of co-firing and thus larger reductions in net CO 2 emissions. Despite the growing amount of scientific output on torrefaction, the economic feasibility of torrefied pellet production is still a topic of considerable uncertainty. This is an obstacle for decision makers looking to implement sustainable energy policies. This paper compares the economics of torrefied pellets to conventional wood pellets. Working backwards from demonstrated pellet properties, this work attempts to answer the following question: Based on state-of-the-art torrefied pellets, what would…
The Production of Industrial Cow’s Milk Curds
2016
By the historical viewpoint, cheeses are the final product of a complex work starting from milk. This liquid substance has to be coagulated: as a result, a heterogeneous matter—curd—is precipitated from the original milk. The rough composition of this intermediate influences the chemical composition of the final cheese. For these reasons, the production of industrial curds should be studied with attention. Different systems are available at present, but the mail process concerns always the coagulation of the original milk and the production of readily available curds for immediate or subsequent use (near the same cheesemaker or in different locations).This chapter discusses the normal produ…
Comparison of simultaneous saccharification and fermentation and separate hydrolysis and fermentation processes for butanol production from rice straw
2020
Abstract Rice straw (RS) is one of the lignocellulosic wastes with the highest global production. The main objective of this study was to maximise the butanol production by Clostridium beijerinckii DSM 6422 from RS pretreated by microwave-assisted hydrothermolysis. Two different fermentation strategies were compared: separate hydrolysis and fermentation (SHF, two-step process) and simultaneous saccharification and fermentation (SSF, one-step process). In parallel, the variables that significantly affected the butanol production were screened by using fractional factorial designs. Butanol concentration and productivity at 48 h were, respectively, 8% and 173% higher in SSF than in SHF. A one-…
Catalytic treatment of rapeseed straw for enhanced production of furfural and glucose for bioethanol production
2021
Abstract Ethanol produced from renewable biomass, such as lignocellulosic feedstock, is one of the most promising future biofuels. In this paper, rapeseed straw was tested as an abundant and cost-effective renewable resource material for the production of cellulosic glucose. Pre-treatment of this material is an important step to improve the efficiency of subsequent cellulose hydrolysis. In this study, we used two pre-treatment methods – hydrothermochemical and ultrasound. Studies have shown that, in the initial hydrothermal pre-treatment of rapeseed straw, Al2(SO4)3 may be used as an efficient catalyst, at least in procedures for obtaining glucose. An increase in the amount of this catalyst…
Anaerobic removal of 1-methoxy-2-propanol under ambient temperature in an EGSB reactor
2015
Two laboratory-scale expanded granular sludge bed (EGSB) reactors were operated at 18 and 25 °C, respectively, for the treatment of synthetic wastewater composed of ethanol and 1-methoxy-2-propanol (M2P) in a mass ratio of 4:1. Reactors were operated first with continuous wastewater supply and after with discontinuous substrate supply (5 days a week, 16 h a day) to simulate shift working conditions. Under continuous wastewater supply chemical oxygen demand (COD), removal efficiency higher than 95 % was achieved at the end of the trial applying organic loading rates (OLR) of 29 and 43 kg COD m(-3) day(-1) at 18 and 25 °C; thus, corresponding to M2P OLR of 6.4 and 9.3 kg COD m(-3) day(-1), re…
Transportation of complexing agents released by pulp and paper industry: A Finnish lake case
1996
Complexing agents (EDTA, DTPA) are used to bind metal ions in pulp and paper industry. Their role will increase significantly when the total chlorine free (TCF) processes will be applied to a larger extent. EDTA and DTPA were analysed in the waters from the southern part of the Lake Saimaa (SE Finland) influenced by the effluents of three pulp and paper mills. The samples were collected at different distances from the points of emission. The results of analyses suggest that EDTA can persist in lake water and is able to propagate for considerable distances, while DTPA can be detected only in the near surroundings of the site of release. Some EDTA was found even in the sampling points that we…
Kinetics of nitrogen removal in a MBR nutrient removal activated sludge system
2006
The application of membrane bioreactor (MBR) technology to biological nutrient removal (BNR) activated sludge (AS) systems is limited and uncertainty exists as to the impact of the conditions induced by the membranes on the biologically mediated processes of nutrient removal. Two main conditions associated with MBRs are (1) high total suspended solids (TSS) concentrations (8–20 g/L) and (2) different selection pressures due to biomass retention not being based on settleability, compared with conventional systems with secondary settling tanks (SSTs). Recently, Ramphao et al. [1] concluded that incorporating membranes in BNR AS makes a profound difference to the design of the system. Previous…