Search results for "permeability"
showing 10 items of 596 documents
Connected pathway relative permeability from pore-scale imaging of imbibition
2016
Abstract Pore-scale images obtained from a synchrotron-based X-ray computed micro-tomography (µCT) imbibition experiment in sandstone rock were used to conduct Navier–Stokes flow simulations on the connected pathways of water and oil phases. The resulting relative permeability was compared with steady-state Darcy-scale imbibition experiments on 5 cm large twin samples from the same outcrop sandstone material. While the relative permeability curves display a large degree of similarity, the endpoint saturations for the µCT data are 10% in saturation units higher than the experimental data. However, the two datasets match well when normalizing to the mobile saturation range. The agreement is p…
Influence of the Height of Municipal Solid Waste Landfill on the Formation of Perched Leachate Zones
2015
Waste settlement as well as consolidation phenomena, which occur inside a landfill for municipal solid waste (MSW), can cause a decrease in waste permeability. This can lead to a reduction in conveyance of the leachate drainage system. It is therefore possible that a so-called perched leachate zone will form. Such a zone is constituted by an area in the body of the landfill where the leachate is temporarily trapped and is unable to infiltrate downward. This phenomenon is influenced by many factors, which include rain infiltration rate, waste moisture and composition, landfill height, and so on. The main aim of the paper is to elucidate the role played by landfill height in the formation of …
Comparative assessment of a foam-based oxidative treatment of hydrocarbon-contaminated unsaturated and anisotropic soils.
2019
Abstract In situ delivery of liquid reagents in vadose zone is limited by soil anisotropy and gravity. The enhanced delivery of persulfate (PS) as oxidant, using a new foam-based method (F-PS) was compared at bench-scale to traditional water-based (W-PS) and surfactant solution-based (S-PS) deliveries. The goal was to distribute PS uniformly in coal tar-contaminated unsaturated and anisotropic soils, both in terms of permeability and contamination. Water was the less efficiently delivered fluid because of the hydrophobicity of the contaminated soils. Surfactant enhanced PS-distribution into contaminated zones by reducing interfacial tension and inverting soil wettability. Regardless of coal…
Barrier properties of anti-gas military garments, considering exposure to gas organic compounds
2020
The problems of determining the protective properties of barrier materials used for the production of body surface protection products of an isolative type are very actual. These garments are expected to have long-term resistance against permeation of toxic substances. The paper deals with the study of the effect of organic solvent vapours on the changes in protective properties of selected anti-gas protective garments commonly used by the North Atlantic Treaty Organization armed forces. Permeation measurements of selected gases with integral permeameter were performed to verify their barrier properties, surface changes after exposure to selected solvents by using a 3D optical profilometer,…
Enhanced remedial reagents delivery in unsaturated anisotropic soils using surfactant foam
2018
Abstract Homogeneous delivery of solution of oxidant in unsaturated soils is limited by soil anisotropy and gravity. An innovative injection strategy using foam was developed to improve in situ delivery. Primary foam injection before oxidant solution enhanced both the lateral and uniform delivery of reactant in isotropic and anisotropic (permeability, contamination) soils. The oxidant spread isotropically through the foam water network. This sequential injection heavily improved the delivery radius of influence (ROI), while limiting contact between surfactant and solution of oxidant in order to preserve the selective oxidation of petroleum hydrocarbons contaminant (TPH). Prior foam injectio…
Shear-thinning fluids for gravity and anisotropy mitigation during soil remediation in the vadose zone
2018
Abstract Surfactant foam has been proposed as an effective treatment fluid for in situ environmental remediation of soils. In the vadose zone, it could improve treatment homogeneity, but its use remains challenging. To better understand and predict foam formation and propagation in vadose zone, we studied them in 24 soils with wide range of properties (including permeability: 2 10−12 to 3.3 10−9 m2). Foam rheology showed to be complex and mostly influenced by soil permeability and grading. Below 2 10−11 m2, foam propagation velocity was not influenced by permeability. Conversely, slight shear thinning to Newtonian behavior was observed for higher permeabilities. Benefits for remediation in …
Sequential biological and photocatalysis based treatments for shipboard slop purification: A pilot plant investigation
2019
This study investigated the treatment of a shipboard slop containing commercial gasoline in a pilot plant scale consisting of a membrane biological reactor (MBR) and photocatalytic reactor (PCR) acting in series. The MBR contributed for approximately 70% to the overall slop purification. More precisely, the biological process was able to remove approximately 40%, on average, of the organic pollution in the slop. Nevertheless, the membrane was capable to retain a large amount of organic molecules within the system, amounting for a further 30% of the influent total organic content removal. However, this affected the membrane fouling, thus resulting in the increase of the pore blocking mechani…
Uptake rates of semipermeable membrane devices (SPMDs) for PCDDs, PCDFs and PCBs in water and sediment.
2000
Uptake rates of several PCDDs, PCDFs and PCBs were measured for semipermeable membrane devices (SPMDs) under controlled conditions in bulk water and sediment. The study was performed at 19 degrees C and 11 degrees C, and water and sediment concentrations were measured during the exposure. Linear uptake rates for specific PCDD/Fs and PCBs in 19 degrees C water varied from 34 to 111 l/m2 day and in 11 degrees C water from 8.8 to 96 l/m2 day for the whole SPMD. Uptake rates at 19 degrees C sediment ranged from 9.0 to 80 mgOC/m2 day and in 11 degrees C sediment, from 3.0 to 31, mgOC/m2 day. Partitioning of the compounds between membrane and lipid was also measured during the linear uptake phase…
Relationship between the structure of amphiphilic copolymers and their ability to disturb lipid bilayers.
2005
Nonionic amphiphiles and particularly block copolymers of ethylene oxide and propylene oxide (Pluronics) cause pronounced chemosensitization of tumor cells that exhibit multiple resistance to antineoplastic drugs. This effect is due to inhibition of P-glycoprotein (P-gp) responsible for drug efflux. It was suggested that the inhibition of P-gp might be due to changes in its lipid surrounding. Indeed, high dependence of P-gp activity on the membrane microviscosity was demonstrated [Regev et al. (1999) Eur. J. Biochem. 259, 18-24], suggesting that the ability of Pluronics to affect the P-gp activity is mediated by their effect on the membrane structure. We have found recently that adsorption …
Pore fabric geometry inferred from magnetic and acoustic anisotropies in rocks with various mineralogy, permeability and porosity.
2014
14 pages; International audience; he ferrofluid impregnation technique combined with anisotropy of magnetic susceptibility measurements (AMSff) is one of the ways to analyze the 3-D geometry of the pore space in a rock and indirectly to infer the anisotropy of permeability. We applied this method on different types of rocks (sandstones and carbonates) with a range of different porosity values (10-30%) and permeability (1 mD to 1 D). To get additional information on both the pore aspect ratio and the directional anisotropy we used another technique, measuring the anisotropy of P-waves velocity (APV) in dry and water saturated conditions. Comparing between both methods shows that despite the …