Search results for "removal"
showing 10 items of 316 documents
[Penile Flexiflate® Surgitek prosthesis explant and simultaneous three-component hydraulic Titan® Alpha 1 prosthesis implantation, with double incisi…
2010
Introduction and Objectives We treated a 45 years old patient, suffering from diabetes mellitus since childhood, with retinal, neurovascular and kidney complications. In 1988, for erectile dysfunction (ED) resistant to medical injective treatment, the patient underwent ligation of the dorsal vein of the penis without any result. In 1989 a Flexiflate® hydraulic prosthesis was implanted with resolution of ED. In 2005 the patient underwent simultaneous kidney and pancreas transplant with a trans-laparotomic approach for end stage renal disease and diabetes mellitus. In 2009, because of the Flexiflate® Surgitek malfunction, the patient underwent explantation of the Flexiflate® prosthesis and si…
Dextran-sulfate-adsorption of atherosclerotic lipoproteins from whole blood or separated plasma for lipid-apheresis--comparison of performance charac…
2007
For many years dextran sulfate adsorption (DSA) treatment of separated plasma has been an established technology for low-density lipoprotein (LDL)-elimination. Recently a system for the treatment of whole blood based on DSA was introduced into clinical practice. To further characterize DSA treatment of whole blood, the performance characteristics of both DSA modalities were compared at two investigational sites with two alternative LDL apheresis systems being already in routine clinical use. In prospective cross-over design, DSA whole blood treatment was compared with a whole blood polyacrylate LDL adsorption system (DALI) in one study group. DSA for plasma treatment was compared with Lipid…
A Brief Review on the Resistance-in-Series Model in Membrane Bioreactors (MBRs)
2019
The cake layer deposited on the membrane modules of membrane bioreactors (MBRs), especially under a submerged configuration, represents a relevant and fundamental mechanism deeply influencing the development of membrane fouling. It negatively affects the total resistance to filtration, while exerting a positive effect as a “pre-filter„ promoting the “dynamic membrane„ that protects the physical membrane from internal fouling. These two opposite phenomena should be properly managed, where the submerged membranes are usually subjected to a periodical cake layer removal through ordinary (permeate backwashing and air scouring) and/or irregular cleaning actions (manual ph…
Rapid One-Step Fabrication of Graphene Oxide-Decorated Polycaprolactone Three-Dimensional Templates for Water Treatment
2020
Coating of flexible substrates is crucial to prepare versatile, multifunctional materials. However, exploration of effective fabrication approaches is still a challenging issue, because the pathways generally proposed require time-consuming, multistep protocols. Here, we developed a one-pot process for decorating either pearl necklace-like or fibrous fluffy-like structures of polycaprolactone (PCL) with graphene oxide (GO) skin. PCL solutions were dry jet-wet electrosprayed or electrospun into a stirred liquid collector constituted by ethanol-containing GO nanoparticles. The stirred liquid collector enables the formation of 3D-structures, whose microarchitecture can be designed by controlli…
Sulfidation Mechanism of Pure and Cu-Doped ZnO Nanoparticles at Moderate Temperature: TEM and In Situ XRD Studies
2012
International audience; Sulfidation mechanism of pure and Cu-doped ZnO nanoparticles (Cu0.03Zn0.97O and Cu0.06Zn0.94O) at 250 and 350 degrees C was studied by transmission electron microscopy (TEM) and in situ synchrotron XRD. For nondoped ZnO, we observed by TEM that partial reaction with H2S is accompanied by the formation of voids at the ZnO/ZnS interface. This phenomenon (known as the Kirkendall effect) confirms that sulfidation of nanosized ZnO by gaseous H2S proceeds via the outward growth of ZnS: Zn2+ and O2- are transferred to the external (ZnS/gas) surface, where zinc is combined with sulfur and oxygen reacts with protons yielding H2O. During sulfidation of Cu-doped ZnO, the caviti…
Efficient boron removal by using mesoporous matrices grafted with saccharides.
2004
Highly efficient boron removal from water was achieved by using mesoporous silica materials functionalised with saccharides. Beltran Porter, Daniel, Daniel.Beltran@uv.es ; Amoros del Toro, Pedro Jose, Pedro.Amoros@uv.es
Neurocysticercosis with a single brain lesion in Germany: a case report
2009
Neurocysticercosis is rare in Western Europe and a high degree of physician awareness is necessary for diagnosis. We describe a case of Neurocysticercosis with a single brain lesion acquired in Germany in which only surgical removal and subsequent histological examination allowed diagnosis whereas diagnostic investigation yielded no pathological findings.
Effect of temperature on ammonium removal in Scenedesmus sp
2015
The effect of temperature on microalgal ammonium uptake was investigated by carrying out four batch experiments in which a mixed culture of microalgae, composed mainly of Scenedesmus sp., was cultivated under different temperatures within the usual temperature working range in Mediterranean climate (15-34 ºC). Ammonium removal rates increased with temperature up to 26 ºC and stabilized thereafter. Ratkowsky and Cardinal Temperatures models successfully reproduced the experimental data. Optimum (31.3 ºC), minimum (8.8 ºC) and maximum (46.1 ºC) temperatures for ammonium removal by Scenedesmus sp. under the studied conditions were obtained as model parameters. These temperature-related paramet…
Simultaneous sludge minimization, biological phosphorous removal and membrane fouling mitigation in a novel plant layout for MBR.
2020
Abstract The integration of one anaerobic reactor in the mainstream (AMSR) of a pre-denitritication-MBR was evaluated with the aim to achieve simultaneous sludge minimization and phosphorous removal. The excess sludge production was reduced by 64% when the AMSR was operated under 8 h of hydraulic retention time (HRT). The highest nutrients removal performances referred to organic carbon (98%), nitrogen (90%) and phosphorous (97%) were obtained under 8 h of HRT. In contrast, prolonged anaerobic-endogenous conditions were found to be detrimental for all nutrients removal performances. Similarly, the lowest membrane fouling tendency (FR = 0.65∙1011 m−1 d−1) was achieved under 8 h of HRT, where…
Biological minimization of excess sludge in a membrane bioreactor: Effect of plant configuration on sludge production, nutrient removal efficiency an…
2018
Abstract Excess sludge minimization was studied in a MBR with pre-denitrification scheme. Sludge minimization, nitrogen removal performance and membrane fouling tendency were investigated in two configurations, characterized by a different position of the sludge retention reactor (SRR). In particular, the SRR was placed: i) in the return activated sludge line (Anaerobic Side-Stream Reactor – ASSR configuration) and ii) in the mainstream between the anoxic and aerobic reactor (Anaerobic Main-Stream Reactor – AMSR configuration). The achieved results demonstrated that the ASSR enabled a higher excess sludge reduction (74% vs 32%), while achieving lower biological nitrogen removal (BNR) (TN = …